*
* Copyright 2002-2005, Devicescape Software, Inc.
* Copyright 2006-2007 Jiri Benc <jbenc@suse.cz>
- * Copyright 2007-2008 Johannes Berg <johannes@sipsolutions.net>
+ * Copyright 2007-2010 Johannes Berg <johannes@sipsolutions.net>
*
* This program is free software; you can redistribute it and/or modify
* it under the terms of the GNU General Public License version 2 as
bool uapsd;
};
-/**
- * struct ieee80211_tx_queue_stats - transmit queue statistics
- *
- * @len: number of packets in queue
- * @limit: queue length limit
- * @count: number of frames sent
- */
-struct ieee80211_tx_queue_stats {
- unsigned int len;
- unsigned int limit;
- unsigned int count;
-};
-
struct ieee80211_low_level_stats {
unsigned int dot11ACKFailureCount;
unsigned int dot11RTSFailureCount;
* @use_short_slot: use short slot time (only relevant for ERP);
* if the hardware cannot handle this it must set the
* IEEE80211_HW_2GHZ_SHORT_SLOT_INCAPABLE hardware flag
- * @dtim_period: num of beacons before the next DTIM, for PSM
+ * @dtim_period: num of beacons before the next DTIM, for beaconing,
+ * not valid in station mode (cf. hw conf ps_dtim_period)
* @timestamp: beacon timestamp
* @beacon_int: beacon interval
* @assoc_capability: capabilities taken from assoc resp
* @IEEE80211_TX_INTFL_RETRANSMISSION: This frame is being retransmitted
* after TX status because the destination was asleep, it must not
* be modified again (no seqno assignment, crypto, etc.)
+ * @IEEE80211_TX_INTFL_HAS_RADIOTAP: This frame was injected and still
+ * has a radiotap header at skb->data.
+ * @IEEE80211_TX_INTFL_NL80211_FRAME_TX: Frame was requested through nl80211
+ * MLME command (internal to mac80211 to figure out whether to send TX
+ * status to user space)
*/
enum mac80211_tx_control_flags {
IEEE80211_TX_CTL_REQ_TX_STATUS = BIT(0),
IEEE80211_TX_CTL_PSPOLL_RESPONSE = BIT(17),
IEEE80211_TX_CTL_MORE_FRAMES = BIT(18),
IEEE80211_TX_INTFL_RETRANSMISSION = BIT(19),
+ IEEE80211_TX_INTFL_HAS_RADIOTAP = BIT(20),
+ IEEE80211_TX_INTFL_NL80211_FRAME_TX = BIT(21),
};
/**
* value will be only achievable between DTIM frames, the hardware
* needs to check for the multicast traffic bit in DTIM beacons.
* This variable is valid only when the CONF_PS flag is set.
+ * @ps_dtim_period: The DTIM period of the AP we're connected to, for use
+ * in power saving. Power saving will not be enabled until a beacon
+ * has been received and the DTIM period is known.
* @dynamic_ps_timeout: The dynamic powersave timeout (in ms), see the
* powersave documentation below. This variable is valid only when
* the CONF_PS flag is set.
int max_sleep_period;
u16 listen_interval;
+ u8 ps_dtim_period;
u8 long_frame_max_tx_count, short_frame_max_tx_count;
* mac80211, any ieee80211_sta pointer you get access to must
* either be protected by rcu_read_lock() explicitly or implicitly,
* or you must take good care to not use such a pointer after a
- * call to your sta_notify callback that removed it.
+ * call to your sta_remove callback that removed it.
*
* @addr: MAC address
* @aid: AID we assigned to the station if we're an AP
* indicates addition and removal of a station to station table,
* or if a associated station made a power state transition.
*
- * @STA_NOTIFY_ADD: a station was added to the station table
- * @STA_NOTIFY_REMOVE: a station being removed from the station table
+ * @STA_NOTIFY_ADD: (DEPRECATED) a station was added to the station table
+ * @STA_NOTIFY_REMOVE: (DEPRECATED) a station being removed from the station table
* @STA_NOTIFY_SLEEP: a station is now sleeping
* @STA_NOTIFY_AWAKE: a sleeping station woke up
*/
* Hardware supports Unscheduled Automatic Power Save Delivery
* (U-APSD) in managed mode. The mode is configured with
* conf_tx() operation.
+ *
+ * @IEEE80211_HW_REPORTS_TX_ACK_STATUS:
+ * Hardware can provide ack status reports of Tx frames to
+ * the stack.
+ *
*/
enum ieee80211_hw_flags {
IEEE80211_HW_HAS_RATE_CONTROL = 1<<0,
IEEE80211_HW_SUPPORTS_STATIC_SMPS = 1<<15,
IEEE80211_HW_SUPPORTS_DYNAMIC_SMPS = 1<<16,
IEEE80211_HW_SUPPORTS_UAPSD = 1<<17,
+ IEEE80211_HW_REPORTS_TX_ACK_STATUS = 1<<18,
};
/**
* @update_tkip_key: See the section "Hardware crypto acceleration"
* This callback will be called in the context of Rx. Called for drivers
* which set IEEE80211_KEY_FLAG_TKIP_REQ_RX_P1_KEY.
- * The callback can sleep.
+ * The callback must be atomic.
*
* @hw_scan: Ask the hardware to service the scan request, no need to start
* the scan state machine in stack. The scan must honour the channel
* @set_rts_threshold: Configuration of RTS threshold (if device needs it)
* The callback can sleep.
*
- * @sta_notify: Notifies low level driver about addition, removal or power
- * state transition of an associated station, AP, IBSS/WDS/mesh peer etc.
- * Must be atomic.
+ * @sta_add: Notifies low level driver about addition of an associated station,
+ * AP, IBSS/WDS/mesh peer etc. This callback can sleep.
+ *
+ * @sta_remove: Notifies low level driver about removal of an associated
+ * station, AP, IBSS/WDS/mesh peer etc. This callback can sleep.
+ *
+ * @sta_notify: Notifies low level driver about power state transition of an
+ * associated station, AP, IBSS/WDS/mesh peer etc. Must be atomic.
*
* @conf_tx: Configure TX queue parameters (EDCF (aifs, cw_min, cw_max),
* bursting) for a hardware TX queue.
* Returns a negative error code on failure.
* The callback can sleep.
*
- * @get_tx_stats: Get statistics of the current TX queue status. This is used
- * to get number of currently queued packets (queue length), maximum queue
- * size (limit), and total number of packets sent using each TX queue
- * (count). The 'stats' pointer points to an array that has hw->queues
- * items.
- * The callback must be atomic.
- *
* @get_tsf: Get the current TSF timer value from firmware/hardware. Currently,
* this is only used for IBSS mode BSSID merging and debugging. Is not a
* required function.
struct ieee80211_vif *vif, struct ieee80211_sta *sta,
struct ieee80211_key_conf *key);
void (*update_tkip_key)(struct ieee80211_hw *hw,
- struct ieee80211_key_conf *conf, const u8 *address,
- u32 iv32, u16 *phase1key);
+ struct ieee80211_vif *vif,
+ struct ieee80211_key_conf *conf,
+ struct ieee80211_sta *sta,
+ u32 iv32, u16 *phase1key);
int (*hw_scan)(struct ieee80211_hw *hw,
struct cfg80211_scan_request *req);
void (*sw_scan_start)(struct ieee80211_hw *hw);
void (*get_tkip_seq)(struct ieee80211_hw *hw, u8 hw_key_idx,
u32 *iv32, u16 *iv16);
int (*set_rts_threshold)(struct ieee80211_hw *hw, u32 value);
+ int (*sta_add)(struct ieee80211_hw *hw, struct ieee80211_vif *vif,
+ struct ieee80211_sta *sta);
+ int (*sta_remove)(struct ieee80211_hw *hw, struct ieee80211_vif *vif,
+ struct ieee80211_sta *sta);
void (*sta_notify)(struct ieee80211_hw *hw, struct ieee80211_vif *vif,
enum sta_notify_cmd, struct ieee80211_sta *sta);
int (*conf_tx)(struct ieee80211_hw *hw, u16 queue,
const struct ieee80211_tx_queue_params *params);
- int (*get_tx_stats)(struct ieee80211_hw *hw,
- struct ieee80211_tx_queue_stats *stats);
u64 (*get_tsf)(struct ieee80211_hw *hw);
void (*set_tsf)(struct ieee80211_hw *hw, u64 tsf);
void (*reset_tsf)(struct ieee80211_hw *hw);
struct ieee80211_sta *sta, void *priv_sta);
void (*rate_update)(void *priv, struct ieee80211_supported_band *sband,
struct ieee80211_sta *sta,
- void *priv_sta, u32 changed);
+ void *priv_sta, u32 changed,
+ enum nl80211_channel_type oper_chan_type);
void (*free_sta)(void *priv, struct ieee80211_sta *sta,
void *priv_sta);
git://ftp.safe.ca / safe / jmp / linux-2.6 / blobdiff