#define V4L2NAMESIZE 32
+/*
+ *
+ * The internal V4L2 device interface core.
+ *
+ */
+
enum v4l2_int_type {
v4l2_int_type_master = 1,
v4l2_int_type_slave
};
+struct v4l2_int_device;
+
+struct v4l2_int_master {
+ int (*attach)(struct v4l2_int_device *slave);
+ void (*detach)(struct v4l2_int_device *slave);
+};
+
+typedef int (v4l2_int_ioctl_func)(struct v4l2_int_device *);
+typedef int (v4l2_int_ioctl_func_0)(struct v4l2_int_device *);
+typedef int (v4l2_int_ioctl_func_1)(struct v4l2_int_device *, void *);
+
+struct v4l2_int_ioctl_desc {
+ int num;
+ v4l2_int_ioctl_func *func;
+};
+
+struct v4l2_int_slave {
+ /* Don't touch master. */
+ struct v4l2_int_device *master;
+
+ char attach_to[V4L2NAMESIZE];
+
+ int num_ioctls;
+ struct v4l2_int_ioctl_desc *ioctls;
+};
+
+struct v4l2_int_device {
+ /* Don't touch head. */
+ struct list_head head;
+
+ struct module *module;
+
+ char name[V4L2NAMESIZE];
+
+ enum v4l2_int_type type;
+ union {
+ struct v4l2_int_master *master;
+ struct v4l2_int_slave *slave;
+ } u;
+
+ void *priv;
+};
+
+void v4l2_int_device_try_attach_all(void);
+
+int v4l2_int_device_register(struct v4l2_int_device *d);
+void v4l2_int_device_unregister(struct v4l2_int_device *d);
+
+int v4l2_int_ioctl_0(struct v4l2_int_device *d, int cmd);
+int v4l2_int_ioctl_1(struct v4l2_int_device *d, int cmd, void *arg);
+
+/*
+ *
+ * Types and definitions for IOCTL commands.
+ *
+ */
+
+enum v4l2_power {
+ V4L2_POWER_OFF = 0,
+ V4L2_POWER_ON,
+ V4L2_POWER_STANDBY,
+};
+
+/* Slave interface type. */
+enum v4l2_if_type {
+ /*
+ * Parallel 8-, 10- or 12-bit interface, used by for example
+ * on certain image sensors.
+ */
+ V4L2_IF_TYPE_BT656,
+};
+
+enum v4l2_if_type_bt656_mode {
+ /*
+ * Modes without Bt synchronisation codes. Separate
+ * synchronisation signal lines are used.
+ */
+ V4L2_IF_TYPE_BT656_MODE_NOBT_8BIT,
+ V4L2_IF_TYPE_BT656_MODE_NOBT_10BIT,
+ V4L2_IF_TYPE_BT656_MODE_NOBT_12BIT,
+ /*
+ * Use Bt synchronisation codes. The vertical and horizontal
+ * synchronisation is done based on synchronisation codes.
+ */
+ V4L2_IF_TYPE_BT656_MODE_BT_8BIT,
+ V4L2_IF_TYPE_BT656_MODE_BT_10BIT,
+};
+
+struct v4l2_if_type_bt656 {
+ /*
+ * 0: Frame begins when vsync is high.
+ * 1: Frame begins when vsync changes from low to high.
+ */
+ unsigned frame_start_on_rising_vs:1;
+ /* Use Bt synchronisation codes for sync correction. */
+ unsigned bt_sync_correct:1;
+ /* Swap every two adjacent image data elements. */
+ unsigned swap:1;
+ /* Inverted latch clock polarity from slave. */
+ unsigned latch_clk_inv:1;
+ /* Hs polarity. 0 is active high, 1 active low. */
+ unsigned nobt_hs_inv:1;
+ /* Vs polarity. 0 is active high, 1 active low. */
+ unsigned nobt_vs_inv:1;
+ enum v4l2_if_type_bt656_mode mode;
+ /* Minimum accepted bus clock for slave (in Hz). */
+ u32 clock_min;
+ /* Maximum accepted bus clock for slave. */
+ u32 clock_max;
+ /*
+ * Current wish of the slave. May only change in response to
+ * ioctls that affect image capture.
+ */
+ u32 clock_curr;
+};
+
+struct v4l2_ifparm {
+ enum v4l2_if_type if_type;
+ union {
+ struct v4l2_if_type_bt656 bt656;
+ } u;
+};
+
+/* IOCTL command numbers. */
enum v4l2_int_ioctl_num {
/*
*
vidioc_int_queryctrl_num,
vidioc_int_g_ctrl_num,
vidioc_int_s_ctrl_num,
+ vidioc_int_cropcap_num,
+ vidioc_int_g_crop_num,
+ vidioc_int_s_crop_num,
vidioc_int_g_parm_num,
vidioc_int_s_parm_num,
+ vidioc_int_querystd_num,
+ vidioc_int_s_std_num,
+ vidioc_int_s_video_routing_num,
/*
*
vidioc_int_dev_init_num = 1000,
/* Delinitialise the device at slave detach. */
vidioc_int_dev_exit_num,
- /* Set device power state: 0 is off, non-zero is on. */
+ /* Set device power state. */
vidioc_int_s_power_num,
- /* Get parallel interface clock speed for current settings. */
- vidioc_int_g_ext_clk_num,
/*
- * Tell what the parallel interface clock speed actually is.
- */
- vidioc_int_s_ext_clk_num,
+ * Get slave private data, e.g. platform-specific slave
+ * configuration used by the master.
+ */
+ vidioc_int_g_priv_num,
+ /* Get slave interface parameters. */
+ vidioc_int_g_ifparm_num,
/* Does the slave need to be reset after VIDIOC_DQBUF? */
vidioc_int_g_needs_reset_num,
+ vidioc_int_enum_framesizes_num,
+ vidioc_int_enum_frameintervals_num,
/*
*
vidioc_int_reset_num,
/* VIDIOC_INT_INIT */
vidioc_int_init_num,
- /* VIDIOC_INT_G_CHIP_IDENT */
+ /* VIDIOC_DBG_G_CHIP_IDENT */
vidioc_int_g_chip_ident_num,
/*
vidioc_int_priv_start_num = 2000,
};
-struct v4l2_int_device;
-
-struct v4l2_int_master {
- int (*attach)(struct v4l2_int_device *master,
- struct v4l2_int_device *slave);
- void (*detach)(struct v4l2_int_device *master);
-};
-
-typedef int (v4l2_int_ioctl_func)(struct v4l2_int_device *);
-typedef int (v4l2_int_ioctl_func_0)(struct v4l2_int_device *);
-typedef int (v4l2_int_ioctl_func_1)(struct v4l2_int_device *, void *);
-
-struct v4l2_int_ioctl_desc {
- int num;
- v4l2_int_ioctl_func *func;
-};
-
-struct v4l2_int_slave {
- /* Don't touch master. */
- struct v4l2_int_device *master;
-
- char attach_to[V4L2NAMESIZE];
-
- int num_ioctls;
- struct v4l2_int_ioctl_desc *ioctls;
-};
-
-struct v4l2_int_device {
- /* Don't touch head. */
- struct list_head head;
-
- struct module *module;
-
- char name[V4L2NAMESIZE];
-
- enum v4l2_int_type type;
- union {
- struct v4l2_int_master *master;
- struct v4l2_int_slave *slave;
- } u;
-
- void *priv;
-};
-
-int v4l2_int_device_register(struct v4l2_int_device *d);
-void v4l2_int_device_unregister(struct v4l2_int_device *d);
-
-int v4l2_int_ioctl_0(struct v4l2_int_device *d, int cmd);
-int v4l2_int_ioctl_1(struct v4l2_int_device *d, int cmd, void *arg);
-
/*
*
* IOCTL wrapper functions for better type checking.
arg_type asterisk arg) \
{ \
return v4l2_int_ioctl_1(d, vidioc_int_##name##_num, \
- (void *)arg); \
+ (void *)(unsigned long)arg); \
} \
\
static inline struct v4l2_int_ioctl_desc \
V4L2_INT_WRAPPER_1(queryctrl, struct v4l2_queryctrl, *);
V4L2_INT_WRAPPER_1(g_ctrl, struct v4l2_control, *);
V4L2_INT_WRAPPER_1(s_ctrl, struct v4l2_control, *);
+V4L2_INT_WRAPPER_1(cropcap, struct v4l2_cropcap, *);
+V4L2_INT_WRAPPER_1(g_crop, struct v4l2_crop, *);
+V4L2_INT_WRAPPER_1(s_crop, struct v4l2_crop, *);
V4L2_INT_WRAPPER_1(g_parm, struct v4l2_streamparm, *);
V4L2_INT_WRAPPER_1(s_parm, struct v4l2_streamparm, *);
+V4L2_INT_WRAPPER_1(querystd, v4l2_std_id, *);
+V4L2_INT_WRAPPER_1(s_std, v4l2_std_id, *);
+V4L2_INT_WRAPPER_1(s_video_routing, struct v4l2_routing, *);
V4L2_INT_WRAPPER_0(dev_init);
V4L2_INT_WRAPPER_0(dev_exit);
-V4L2_INT_WRAPPER_1(s_power, int, );
-V4L2_INT_WRAPPER_1(s_ext_clk, u32, );
-V4L2_INT_WRAPPER_1(g_ext_clk, u32, *);
+V4L2_INT_WRAPPER_1(s_power, enum v4l2_power, );
+V4L2_INT_WRAPPER_1(g_priv, void, *);
+V4L2_INT_WRAPPER_1(g_ifparm, struct v4l2_ifparm, *);
V4L2_INT_WRAPPER_1(g_needs_reset, void, *);
+V4L2_INT_WRAPPER_1(enum_framesizes, struct v4l2_frmsizeenum, *);
+V4L2_INT_WRAPPER_1(enum_frameintervals, struct v4l2_frmivalenum, *);
V4L2_INT_WRAPPER_0(reset);
V4L2_INT_WRAPPER_0(init);
git://ftp.safe.ca / safe / jmp / linux-2.6 / blobdiff