#include <linux/platform_device.h>
/*
+ * WM97xx variants
+ */
+#define WM97xx_GENERIC 0x0000
+#define WM97xx_WM1613 0x1613
+
+/*
* WM97xx AC97 Touchscreen registers
*/
#define AC97_WM97XX_DIGITISER1 0x76
#define WM9713_ADCSEL_Y 0x0004 /* Y measurement */
#define WM9713_ADCSEL_PRES 0x0008 /* Pressure measurement */
#define WM9713_COO 0x0001 /* enable coordinate mode */
+#define WM9713_45W 0x1000 /* set for 5 wire panel */
#define WM9713_PDEN 0x0800 /* measure only when pen down */
#define WM9713_ADCSEL_MASK 0x00fe /* ADC selection mask */
#define WM9713_WAIT 0x0200 /* coordinate wait */
unsigned pen_is_down:1; /* Pen is down */
unsigned aux_waiting:1; /* aux measurement waiting */
unsigned pen_probably_down:1; /* used in polling mode */
+ u16 variant; /* WM97xx chip variant */
u16 suspend_mode; /* PRP in suspend mode */
};
+struct wm97xx_batt_pdata {
+ int batt_aux;
+ int temp_aux;
+ int charge_gpio;
+ int min_voltage;
+ int max_voltage;
+ int batt_div;
+ int batt_mult;
+ int temp_div;
+ int temp_mult;
+ int batt_tech;
+ char *batt_name;
+};
+
+struct wm97xx_pdata {
+ struct wm97xx_batt_pdata *batt_pdata; /* battery data */
+};
+
/*
* Codec GPIO access (not supported on WM9705)
* This can be used to set/get codec GPIO and Virtual GPIO status.