/*
- * $Id: mtd.h,v 1.61 2005/11/07 11:14:54 gleixner Exp $
- *
* Copyright (C) 1999-2003 David Woodhouse <dwmw2@infradead.org> et al.
*
* Released under GPL
#ifndef __MTD_MTD_H__
#define __MTD_MTD_H__
-#ifndef __KERNEL__
-#error This is a kernel header. Perhaps include mtd-user.h instead?
-#endif
-
#include <linux/types.h>
#include <linux/module.h>
#include <linux/uio.h>
#include <linux/mtd/compatmac.h>
#include <mtd/mtd-abi.h>
+#include <asm/div64.h>
+
#define MTD_CHAR_MAJOR 90
#define MTD_BLOCK_MAJOR 31
#define MAX_MTD_DEVICES 32
#define MTD_ERASE_DONE 0x08
#define MTD_ERASE_FAILED 0x10
+#define MTD_FAIL_ADDR_UNKNOWN -1LL
+
/* If the erase fails, fail_addr might indicate exactly which block failed. If
- fail_addr = 0xffffffff, the failure was not at the device level or was not
+ fail_addr = MTD_FAIL_ADDR_UNKNOWN, the failure was not at the device level or was not
specific to any particular block. */
struct erase_info {
struct mtd_info *mtd;
- u_int32_t addr;
- u_int32_t len;
- u_int32_t fail_addr;
+ uint64_t addr;
+ uint64_t len;
+ uint64_t fail_addr;
u_long time;
u_long retries;
- u_int dev;
- u_int cell;
+ unsigned dev;
+ unsigned cell;
void (*callback) (struct erase_info *self);
u_long priv;
u_char state;
};
struct mtd_erase_region_info {
- u_int32_t offset; /* At which this region starts, from the beginning of the MTD */
- u_int32_t erasesize; /* For this region */
- u_int32_t numblocks; /* Number of blocks of erasesize in this region */
+ uint64_t offset; /* At which this region starts, from the beginning of the MTD */
+ uint32_t erasesize; /* For this region */
+ uint32_t numblocks; /* Number of blocks of erasesize in this region */
+ unsigned long *lockmap; /* If keeping bitmap of locks */
};
/*
* mode = MTD_OOB_PLACE)
* @datbuf: data buffer - if NULL only oob data are read/written
* @oobbuf: oob data buffer
+ *
+ * Note, it is allowed to read more than one OOB area at one go, but not write.
+ * The interface assumes that the OOB write requests program only one page's
+ * OOB area.
*/
struct mtd_oob_ops {
mtd_oob_mode_t mode;
struct mtd_info {
u_char type;
- u_int32_t flags;
- u_int32_t size; // Total size of the MTD
+ uint32_t flags;
+ uint64_t size; // Total size of the MTD
/* "Major" erase size for the device. Naïve users may take this
* to be the only erase size available, or may use the more detailed
* information below if they desire
*/
- u_int32_t erasesize;
+ uint32_t erasesize;
/* Minimal writable flash unit size. In case of NOR flash it is 1 (even
* though individual bits can be cleared), in case of NAND flash it is
* one NAND page (or half, or one-fourths of it), in case of ECC-ed NOR
* Any driver registering a struct mtd_info must ensure a writesize of
* 1 or larger.
*/
- u_int32_t writesize;
+ uint32_t writesize;
- u_int32_t oobsize; // Amount of OOB data per block (e.g. 16)
- u_int32_t ecctype;
- u_int32_t eccsize;
+ uint32_t oobsize; // Amount of OOB data per block (e.g. 16)
+ uint32_t oobavail; // Available OOB bytes per block
/*
- * Reuse some of the above unused fields in the case of NOR flash
- * with configurable programming regions to avoid modifying the
- * user visible structure layout/size. Only valid when the
- * MTD_PROGRAM_REGIONS flag is set.
- * (Maybe we should have an union for those?)
+ * If erasesize is a power of 2 then the shift is stored in
+ * erasesize_shift otherwise erasesize_shift is zero. Ditto writesize.
*/
-#define MTD_PROGREGION_CTRLMODE_VALID(mtd) (mtd)->oobsize
-#define MTD_PROGREGION_CTRLMODE_INVALID(mtd) (mtd)->ecctype
+ unsigned int erasesize_shift;
+ unsigned int writesize_shift;
+ /* Masks based on erasesize_shift and writesize_shift */
+ unsigned int erasesize_mask;
+ unsigned int writesize_mask;
// Kernel-only stuff starts here.
- char *name;
+ const char *name;
int index;
/* ecc layout structure pointer - read only ! */
int numeraseregions;
struct mtd_erase_region_info *eraseregions;
- /* This really shouldn't be here. It can go away in 2.5 */
- u_int32_t bank_size;
-
+ /*
+ * Erase is an asynchronous operation. Device drivers are supposed
+ * to call instr->callback() whenever the operation completes, even
+ * if it completes with a failure.
+ * Callers are supposed to pass a callback function and wait for it
+ * to be called before writing to the block.
+ */
int (*erase) (struct mtd_info *mtd, struct erase_info *instr);
/* This stuff for eXecute-In-Place */
- int (*point) (struct mtd_info *mtd, loff_t from, size_t len, size_t *retlen, u_char **mtdbuf);
+ /* phys is optional and may be set to NULL */
+ int (*point) (struct mtd_info *mtd, loff_t from, size_t len,
+ size_t *retlen, void **virt, resource_size_t *phys);
/* We probably shouldn't allow XIP if the unpoint isn't a NULL */
- void (*unpoint) (struct mtd_info *mtd, u_char * addr, loff_t from, size_t len);
+ void (*unpoint) (struct mtd_info *mtd, loff_t from, size_t len);
int (*read) (struct mtd_info *mtd, loff_t from, size_t len, size_t *retlen, u_char *buf);
int (*write) (struct mtd_info *mtd, loff_t to, size_t len, size_t *retlen, const u_char *buf);
+ /* In blackbox flight recorder like scenarios we want to make successful
+ writes in interrupt context. panic_write() is only intended to be
+ called when its known the kernel is about to panic and we need the
+ write to succeed. Since the kernel is not going to be running for much
+ longer, this function can break locks and delay to ensure the write
+ succeeds (but not sleep). */
+
+ int (*panic_write) (struct mtd_info *mtd, loff_t to, size_t len, size_t *retlen, const u_char *buf);
+
int (*read_oob) (struct mtd_info *mtd, loff_t from,
struct mtd_oob_ops *ops);
int (*write_oob) (struct mtd_info *mtd, loff_t to,
void (*sync) (struct mtd_info *mtd);
/* Chip-supported device locking */
- int (*lock) (struct mtd_info *mtd, loff_t ofs, size_t len);
- int (*unlock) (struct mtd_info *mtd, loff_t ofs, size_t len);
+ int (*lock) (struct mtd_info *mtd, loff_t ofs, uint64_t len);
+ int (*unlock) (struct mtd_info *mtd, loff_t ofs, uint64_t len);
/* Power Management functions */
int (*suspend) (struct mtd_info *mtd);
/* ECC status information */
struct mtd_ecc_stats ecc_stats;
+ /* Subpage shift (NAND) */
+ int subpage_sft;
void *priv;
struct module *owner;
int usecount;
+
+ /* If the driver is something smart, like UBI, it may need to maintain
+ * its own reference counting. The below functions are only for driver.
+ * The driver may register its callbacks. These callbacks are not
+ * supposed to be called by MTD users */
+ int (*get_device) (struct mtd_info *mtd);
+ void (*put_device) (struct mtd_info *mtd);
};
+static inline uint32_t mtd_div_by_eb(uint64_t sz, struct mtd_info *mtd)
+{
+ if (mtd->erasesize_shift)
+ return sz >> mtd->erasesize_shift;
+ do_div(sz, mtd->erasesize);
+ return sz;
+}
+
+static inline uint32_t mtd_mod_by_eb(uint64_t sz, struct mtd_info *mtd)
+{
+ if (mtd->erasesize_shift)
+ return sz & mtd->erasesize_mask;
+ return do_div(sz, mtd->erasesize);
+}
+
+static inline uint32_t mtd_div_by_ws(uint64_t sz, struct mtd_info *mtd)
+{
+ if (mtd->writesize_shift)
+ return sz >> mtd->writesize_shift;
+ do_div(sz, mtd->writesize);
+ return sz;
+}
+
+static inline uint32_t mtd_mod_by_ws(uint64_t sz, struct mtd_info *mtd)
+{
+ if (mtd->writesize_shift)
+ return sz & mtd->writesize_mask;
+ return do_div(sz, mtd->writesize);
+}
/* Kernel-side ioctl definitions */
extern int del_mtd_device (struct mtd_info *mtd);
extern struct mtd_info *get_mtd_device(struct mtd_info *mtd, int num);
+extern struct mtd_info *get_mtd_device_nm(const char *name);
extern void put_mtd_device(struct mtd_info *mtd);
printk(KERN_INFO args); \
} while(0)
#else /* CONFIG_MTD_DEBUG */
-#define DEBUG(n, args...) do { } while(0)
+#define DEBUG(n, args...) \
+ do { \
+ if (0) \
+ printk(KERN_INFO args); \
+ } while(0)
#endif /* CONFIG_MTD_DEBUG */
git://ftp.safe.ca / safe / jmp / linux-2.6 / blobdiff