mfd: driver for the TC6387XB TMIO controller.
[safe/jmp/linux-2.6] / include / linux / mmc / host.h
index 2da0c91..9c288c9 100644 (file)
 #ifndef LINUX_MMC_HOST_H
 #define LINUX_MMC_HOST_H
 
-#include <linux/mmc/mmc.h>
+#include <linux/leds.h>
+
+#include <linux/mmc/core.h>
 
 struct mmc_ios {
        unsigned int    clock;                  /* clock rate */
        unsigned short  vdd;
 
-#define        MMC_VDD_150     0
-#define        MMC_VDD_155     1
-#define        MMC_VDD_160     2
-#define        MMC_VDD_165     3
-#define        MMC_VDD_170     4
-#define        MMC_VDD_180     5
-#define        MMC_VDD_190     6
-#define        MMC_VDD_200     7
-#define        MMC_VDD_210     8
-#define        MMC_VDD_220     9
-#define        MMC_VDD_230     10
-#define        MMC_VDD_240     11
-#define        MMC_VDD_250     12
-#define        MMC_VDD_260     13
-#define        MMC_VDD_270     14
-#define        MMC_VDD_280     15
-#define        MMC_VDD_290     16
-#define        MMC_VDD_300     17
-#define        MMC_VDD_310     18
-#define        MMC_VDD_320     19
-#define        MMC_VDD_330     20
-#define        MMC_VDD_340     21
-#define        MMC_VDD_350     22
-#define        MMC_VDD_360     23
+/* vdd stores the bit number of the selected voltage range from below. */
 
        unsigned char   bus_mode;               /* command output mode */
 
@@ -62,12 +41,41 @@ struct mmc_ios {
 
 #define MMC_BUS_WIDTH_1                0
 #define MMC_BUS_WIDTH_4                2
+
+       unsigned char   timing;                 /* timing specification used */
+
+#define MMC_TIMING_LEGACY      0
+#define MMC_TIMING_MMC_HS      1
+#define MMC_TIMING_SD_HS       2
 };
 
 struct mmc_host_ops {
        void    (*request)(struct mmc_host *host, struct mmc_request *req);
+       /*
+        * Avoid calling these three functions too often or in a "fast path",
+        * since underlaying controller might implement them in an expensive
+        * and/or slow way.
+        *
+        * Also note that these functions might sleep, so don't call them
+        * in the atomic contexts!
+        *
+        * Return values for the get_ro callback should be:
+        *   0 for a read/write card
+        *   1 for a read-only card
+        *   -ENOSYS when not supported (equal to NULL callback)
+        *   or a negative errno value when something bad happened
+        *
+        * Return values for the get_ro callback should be:
+        *   0 for a absent card
+        *   1 for a present card
+        *   -ENOSYS when not supported (equal to NULL callback)
+        *   or a negative errno value when something bad happened
+        */
        void    (*set_ios)(struct mmc_host *host, struct mmc_ios *ios);
        int     (*get_ro)(struct mmc_host *host);
+       int     (*get_cd)(struct mmc_host *host);
+
+       void    (*enable_sdio_irq)(struct mmc_host *host, int enable);
 };
 
 struct mmc_card;
@@ -82,38 +90,75 @@ struct mmc_host {
        unsigned int            f_max;
        u32                     ocr_avail;
 
+#define MMC_VDD_165_195                0x00000080      /* VDD voltage 1.65 - 1.95 */
+#define MMC_VDD_20_21          0x00000100      /* VDD voltage 2.0 ~ 2.1 */
+#define MMC_VDD_21_22          0x00000200      /* VDD voltage 2.1 ~ 2.2 */
+#define MMC_VDD_22_23          0x00000400      /* VDD voltage 2.2 ~ 2.3 */
+#define MMC_VDD_23_24          0x00000800      /* VDD voltage 2.3 ~ 2.4 */
+#define MMC_VDD_24_25          0x00001000      /* VDD voltage 2.4 ~ 2.5 */
+#define MMC_VDD_25_26          0x00002000      /* VDD voltage 2.5 ~ 2.6 */
+#define MMC_VDD_26_27          0x00004000      /* VDD voltage 2.6 ~ 2.7 */
+#define MMC_VDD_27_28          0x00008000      /* VDD voltage 2.7 ~ 2.8 */
+#define MMC_VDD_28_29          0x00010000      /* VDD voltage 2.8 ~ 2.9 */
+#define MMC_VDD_29_30          0x00020000      /* VDD voltage 2.9 ~ 3.0 */
+#define MMC_VDD_30_31          0x00040000      /* VDD voltage 3.0 ~ 3.1 */
+#define MMC_VDD_31_32          0x00080000      /* VDD voltage 3.1 ~ 3.2 */
+#define MMC_VDD_32_33          0x00100000      /* VDD voltage 3.2 ~ 3.3 */
+#define MMC_VDD_33_34          0x00200000      /* VDD voltage 3.3 ~ 3.4 */
+#define MMC_VDD_34_35          0x00400000      /* VDD voltage 3.4 ~ 3.5 */
+#define MMC_VDD_35_36          0x00800000      /* VDD voltage 3.5 ~ 3.6 */
+
        unsigned long           caps;           /* Host capabilities */
 
 #define MMC_CAP_4_BIT_DATA     (1 << 0)        /* Can the host do 4 bit transfers */
-#define MMC_CAP_MULTIWRITE     (1 << 1)        /* Can accurately report bytes sent to card on error */
-#define MMC_CAP_BYTEBLOCK      (1 << 2)        /* Can do non-log2 block sizes */
+#define MMC_CAP_MMC_HIGHSPEED  (1 << 1)        /* Can do MMC high-speed timing */
+#define MMC_CAP_SD_HIGHSPEED   (1 << 2)        /* Can do SD high-speed timing */
+#define MMC_CAP_SDIO_IRQ       (1 << 3)        /* Can signal pending SDIO IRQs */
+#define MMC_CAP_SPI            (1 << 4)        /* Talks only SPI protocols */
+#define MMC_CAP_NEEDS_POLL     (1 << 5)        /* Needs polling for card-detection */
 
        /* host specific block data */
        unsigned int            max_seg_size;   /* see blk_queue_max_segment_size */
        unsigned short          max_hw_segs;    /* see blk_queue_max_hw_segments */
        unsigned short          max_phys_segs;  /* see blk_queue_max_phys_segments */
-       unsigned short          max_sectors;    /* see blk_queue_max_sectors */
        unsigned short          unused;
+       unsigned int            max_req_size;   /* maximum number of bytes in one req */
        unsigned int            max_blk_size;   /* maximum size of one mmc block */
+       unsigned int            max_blk_count;  /* maximum number of blocks in one req */
 
        /* private data */
+       spinlock_t              lock;           /* lock for claim and bus ops */
+
        struct mmc_ios          ios;            /* current io bus settings */
        u32                     ocr;            /* the current OCR setting */
 
-       unsigned int            mode;           /* current card mode of host */
-#define MMC_MODE_MMC           0
-#define MMC_MODE_SD            1
+       /* group bitfields together to minimize padding */
+       unsigned int            use_spi_crc:1;
+       unsigned int            claimed:1;      /* host exclusively claimed */
+       unsigned int            bus_dead:1;     /* bus has been released */
+#ifdef CONFIG_MMC_DEBUG
+       unsigned int            removed:1;      /* host is being removed */
+#endif
 
-       struct list_head        cards;          /* devices attached to this host */
+       struct mmc_card         *card;          /* device attached to this host */
 
        wait_queue_head_t       wq;
-       spinlock_t              lock;           /* claimed lock */
-       unsigned int            claimed:1;      /* host exclusively claimed */
-
-       struct mmc_card         *card_selected; /* the selected MMC card */
 
        struct delayed_work     detect;
 
+       const struct mmc_bus_ops *bus_ops;      /* current bus driver */
+       unsigned int            bus_refs;       /* reference counter */
+
+       unsigned int            sdio_irqs;
+       struct task_struct      *sdio_irq_thread;
+       atomic_t                sdio_irq_thread_abort;
+
+#ifdef CONFIG_LEDS_TRIGGERS
+       struct led_trigger      *led;           /* activity led */
+#endif
+
+       struct dentry           *debugfs_root;
+
        unsigned long           private[0] ____cacheline_aligned;
 };
 
@@ -127,6 +172,8 @@ static inline void *mmc_priv(struct mmc_host *host)
        return (void *)host->private;
 }
 
+#define mmc_host_is_spi(host)  ((host)->caps & MMC_CAP_SPI)
+
 #define mmc_dev(x)     ((x)->parent)
 #define mmc_classdev(x)        (&(x)->class_dev)
 #define mmc_hostname(x)        ((x)->class_dev.bus_id)
@@ -137,5 +184,11 @@ extern int mmc_resume_host(struct mmc_host *);
 extern void mmc_detect_change(struct mmc_host *, unsigned long delay);
 extern void mmc_request_done(struct mmc_host *, struct mmc_request *);
 
+static inline void mmc_signal_sdio_irq(struct mmc_host *host)
+{
+       host->ops->enable_sdio_irq(host, 0);
+       wake_up_process(host->sdio_irq_thread);
+}
+
 #endif