#include <linux/compiler.h> /* for "__user" et al */
#define IFNAMSIZ 16
+#define IFALIASZ 256
#include <linux/hdlc/ioctl.h>
/* Standard interface flags (netdevice->flags). */
#define IFF_LOOPBACK 0x8 /* is a loopback net */
#define IFF_POINTOPOINT 0x10 /* interface is has p-p link */
#define IFF_NOTRAILERS 0x20 /* avoid use of trailers */
-#define IFF_RUNNING 0x40 /* resources allocated */
+#define IFF_RUNNING 0x40 /* interface RFC2863 OPER_UP */
#define IFF_NOARP 0x80 /* no ARP protocol */
#define IFF_PROMISC 0x100 /* receive all packets */
#define IFF_ALLMULTI 0x200 /* receive all multicast packets*/
#define IFF_MULTICAST 0x1000 /* Supports multicast */
-#define IFF_VOLATILE (IFF_LOOPBACK|IFF_POINTOPOINT|IFF_BROADCAST|IFF_MASTER|IFF_SLAVE|IFF_RUNNING)
-
#define IFF_PORTSEL 0x2000 /* can set media type */
#define IFF_AUTOMEDIA 0x4000 /* auto media select active */
#define IFF_DYNAMIC 0x8000 /* dialup device with changing addresses*/
+#define IFF_LOWER_UP 0x10000 /* driver signals L1 up */
+#define IFF_DORMANT 0x20000 /* driver signals dormant */
+
+#define IFF_ECHO 0x40000 /* echo sent packets */
+
+#define IFF_VOLATILE (IFF_LOOPBACK|IFF_POINTOPOINT|IFF_BROADCAST|IFF_ECHO|\
+ IFF_MASTER|IFF_SLAVE|IFF_RUNNING|IFF_LOWER_UP|IFF_DORMANT)
+
/* Private (from user) interface flags (netdevice->priv_flags). */
#define IFF_802_1Q_VLAN 0x1 /* 802.1Q VLAN device. */
#define IFF_EBRIDGE 0x2 /* Ethernet bridging device. */
+#define IFF_SLAVE_INACTIVE 0x4 /* bonding slave not the curr. active */
+#define IFF_MASTER_8023AD 0x8 /* bonding master, 802.3ad. */
+#define IFF_MASTER_ALB 0x10 /* bonding master, balance-alb. */
+#define IFF_BONDING 0x20 /* bonding master or slave */
+#define IFF_SLAVE_NEEDARP 0x40 /* need ARPs for validation */
+#define IFF_ISATAP 0x80 /* ISATAP interface (RFC4214) */
+#define IFF_MASTER_ARPMON 0x100 /* bonding master, ARP mon in use */
+#define IFF_WAN_HDLC 0x200 /* WAN HDLC device */
+#define IFF_XMIT_DST_RELEASE 0x400 /* dev_hard_start_xmit() is allowed to
+ * release skb->dst
+ */
+#define IFF_DONT_BRIDGE 0x800 /* disallow bridging this ether dev */
#define IF_GET_IFACE 0x0001 /* for querying only */
#define IF_GET_PROTO 0x0002
#define IF_PROTO_FR_ETH_PVC 0x200B
#define IF_PROTO_RAW 0x200C /* RAW Socket */
+/* RFC 2863 operational status */
+enum {
+ IF_OPER_UNKNOWN,
+ IF_OPER_NOTPRESENT,
+ IF_OPER_DOWN,
+ IF_OPER_LOWERLAYERDOWN,
+ IF_OPER_TESTING,
+ IF_OPER_DORMANT,
+ IF_OPER_UP,
+};
+
+/* link modes */
+enum {
+ IF_LINK_MODE_DEFAULT,
+ IF_LINK_MODE_DORMANT, /* limit upward transition to dormant */
+};
/*
* Device mapping structure. I'd just gone off and designed a
* being very small might be worth keeping for clean configuration.
*/
-struct ifmap
-{
+struct ifmap {
unsigned long mem_start;
unsigned long mem_end;
unsigned short base_addr;
/* 3 bytes spare */
};
-struct if_settings
-{
+struct if_settings {
unsigned int type; /* Type of physical device or protocol */
unsigned int size; /* Size of the data allocated by the caller */
union {
* remainder may be interface specific.
*/
-struct ifreq
-{
+struct ifreq {
#define IFHWADDRLEN 6
union
{
* must know all networks accessible).
*/
-struct ifconf
-{
+struct ifconf {
int ifc_len; /* size of buffer */
- union
- {
+ union {
char __user *ifcu_buf;
struct ifreq __user *ifcu_req;
} ifc_ifcu;
#define ifc_buf ifc_ifcu.ifcu_buf /* buffer address */
#define ifc_req ifc_ifcu.ifcu_req /* array of structures */
-
#endif /* _LINUX_IF_H */