ATA_MAX_DEVICES = 2, /* per bus/port */
ATA_MAX_PRD = 256, /* we could make these 256/256 */
ATA_SECT_SIZE = 512,
+ ATA_MAX_SECTORS_128 = 128,
+ ATA_MAX_SECTORS = 256,
+ ATA_MAX_SECTORS_LBA48 = 65535,/* TODO: 65536? */
ATA_ID_WORDS = 256,
- ATA_ID_SERNO_OFS = 10,
- ATA_ID_FW_REV_OFS = 23,
- ATA_ID_PROD_OFS = 27,
+ ATA_ID_SERNO = 10,
+ ATA_ID_FW_REV = 23,
+ ATA_ID_PROD = 27,
ATA_ID_OLD_PIO_MODES = 51,
ATA_ID_FIELD_VALID = 53,
ATA_ID_MWDMA_MODES = 63,
ATA_ID_MAJOR_VER = 80,
ATA_ID_PIO4 = (1 << 1),
+ ATA_ID_SERNO_LEN = 20,
+ ATA_ID_FW_REV_LEN = 8,
+ ATA_ID_PROD_LEN = 40,
+
ATA_PCI_CTL_OFS = 2,
- ATA_SERNO_LEN = 20,
+
+ ATA_PIO0 = (1 << 0),
+ ATA_PIO1 = ATA_PIO0 | (1 << 1),
+ ATA_PIO2 = ATA_PIO1 | (1 << 2),
+ ATA_PIO3 = ATA_PIO2 | (1 << 3),
+ ATA_PIO4 = ATA_PIO3 | (1 << 4),
+ ATA_PIO5 = ATA_PIO4 | (1 << 5),
+ ATA_PIO6 = ATA_PIO5 | (1 << 6),
+
+ ATA_SWDMA0 = (1 << 0),
+ ATA_SWDMA1 = ATA_SWDMA0 | (1 << 1),
+ ATA_SWDMA2 = ATA_SWDMA1 | (1 << 2),
+
+ ATA_SWDMA2_ONLY = (1 << 2),
+
+ ATA_MWDMA0 = (1 << 0),
+ ATA_MWDMA1 = ATA_MWDMA0 | (1 << 1),
+ ATA_MWDMA2 = ATA_MWDMA1 | (1 << 2),
+
+ ATA_MWDMA12_ONLY = (1 << 1) | (1 << 2),
+ ATA_MWDMA2_ONLY = (1 << 2),
+
ATA_UDMA0 = (1 << 0),
ATA_UDMA1 = ATA_UDMA0 | (1 << 1),
ATA_UDMA2 = ATA_UDMA1 | (1 << 2),
ATA_REG_IRQ = ATA_REG_NSECT,
/* ATA device commands */
+ ATA_CMD_DEV_RESET = 0x08, /* ATAPI device reset */
ATA_CMD_CHK_POWER = 0xE5, /* check power mode */
ATA_CMD_STANDBY = 0xE2, /* place in standby power mode */
ATA_CMD_IDLE = 0xE3, /* place in idle power mode */
ATA_CMD_WRITE_MULTI_EXT = 0x39,
ATA_CMD_WRITE_MULTI_FUA_EXT = 0xCE,
ATA_CMD_SET_FEATURES = 0xEF,
+ ATA_CMD_SET_MULTI = 0xC6,
ATA_CMD_PACKET = 0xA0,
ATA_CMD_VERIFY = 0x40,
ATA_CMD_VERIFY_EXT = 0x42,
ATA_CMD_INIT_DEV_PARAMS = 0x91,
ATA_CMD_READ_NATIVE_MAX = 0xF8,
ATA_CMD_READ_NATIVE_MAX_EXT = 0x27,
+ ATA_CMD_SET_MAX = 0xF9,
+ ATA_CMD_SET_MAX_EXT = 0x37,
ATA_CMD_READ_LOG_EXT = 0x2f,
+ ATA_CMD_PMP_READ = 0xE4,
+ ATA_CMD_PMP_WRITE = 0xE8,
/* READ_LOG_EXT pages */
ATA_LOG_SATA_NCQ = 0x10,
+ /* READ/WRITE LONG (obsolete) */
+ ATA_CMD_READ_LONG = 0x22,
+ ATA_CMD_READ_LONG_ONCE = 0x23,
+ ATA_CMD_WRITE_LONG = 0x32,
+ ATA_CMD_WRITE_LONG_ONCE = 0x33,
+
/* SETFEATURES stuff */
SETFEATURES_XFER = 0x03,
XFER_UDMA_7 = 0x47,
XFER_UDMA_2 = 0x42,
XFER_UDMA_1 = 0x41,
XFER_UDMA_0 = 0x40,
+ XFER_MW_DMA_4 = 0x24, /* CFA only */
+ XFER_MW_DMA_3 = 0x23, /* CFA only */
XFER_MW_DMA_2 = 0x22,
XFER_MW_DMA_1 = 0x21,
XFER_MW_DMA_0 = 0x20,
XFER_SW_DMA_2 = 0x12,
XFER_SW_DMA_1 = 0x11,
XFER_SW_DMA_0 = 0x10,
+ XFER_PIO_6 = 0x0E, /* CFA only */
+ XFER_PIO_5 = 0x0D, /* CFA only */
XFER_PIO_4 = 0x0C,
XFER_PIO_3 = 0x0B,
XFER_PIO_2 = 0x0A,
SETFEATURES_WC_ON = 0x02, /* Enable write cache */
SETFEATURES_WC_OFF = 0x82, /* Disable write cache */
+ SETFEATURES_SPINUP = 0x07, /* Spin-up drive */
+
/* ATAPI stuff */
ATAPI_PKT_DMA = (1 << 0),
ATAPI_DMADIR = (1 << 2), /* ATAPI data dir:
0=to device, 1=to host */
ATAPI_CDB_LEN = 16,
+ /* PMP stuff */
+ SATA_PMP_MAX_PORTS = 15,
+ SATA_PMP_CTRL_PORT = 15,
+
+ SATA_PMP_GSCR_DWORDS = 128,
+ SATA_PMP_GSCR_PROD_ID = 0,
+ SATA_PMP_GSCR_REV = 1,
+ SATA_PMP_GSCR_PORT_INFO = 2,
+ SATA_PMP_GSCR_ERROR = 32,
+ SATA_PMP_GSCR_ERROR_EN = 33,
+ SATA_PMP_GSCR_FEAT = 64,
+ SATA_PMP_GSCR_FEAT_EN = 96,
+
+ SATA_PMP_PSCR_STATUS = 0,
+ SATA_PMP_PSCR_ERROR = 1,
+ SATA_PMP_PSCR_CONTROL = 2,
+
+ SATA_PMP_FEAT_BIST = (1 << 0),
+ SATA_PMP_FEAT_PMREQ = (1 << 1),
+ SATA_PMP_FEAT_DYNSSC = (1 << 2),
+ SATA_PMP_FEAT_NOTIFY = (1 << 3),
+
/* cable types */
ATA_CBL_NONE = 0,
ATA_CBL_PATA40 = 1,
ATA_CBL_PATA80 = 2,
- ATA_CBL_PATA_UNK = 3,
- ATA_CBL_SATA = 4,
+ ATA_CBL_PATA40_SHORT = 3, /* 40 wire cable to high UDMA spec */
+ ATA_CBL_PATA_UNK = 4,
+ ATA_CBL_SATA = 5,
/* SATA Status and Control Registers */
SCR_STATUS = 0,
/* ATA taskfile protocols */
ATA_PROT_UNKNOWN, /* unknown/invalid */
ATA_PROT_NODATA, /* no data */
- ATA_PROT_PIO, /* PIO single sector */
+ ATA_PROT_PIO, /* PIO data xfer */
ATA_PROT_DMA, /* DMA */
ATA_PROT_NCQ, /* NCQ */
ATA_PROT_ATAPI, /* packet command, PIO data xfer*/
};
#define ata_id_is_ata(id) (((id)[0] & (1 << 15)) == 0)
-#define ata_id_is_cfa(id) ((id)[0] == 0x848A)
-#define ata_id_is_sata(id) ((id)[93] == 0)
#define ata_id_rahead_enabled(id) ((id)[85] & (1 << 6))
#define ata_id_wcache_enabled(id) ((id)[85] & (1 << 5))
#define ata_id_hpa_enabled(id) ((id)[85] & (1 << 10))
#define ata_id_queue_depth(id) (((id)[75] & 0x1f) + 1)
#define ata_id_removeable(id) ((id)[0] & (1 << 7))
#define ata_id_has_dword_io(id) ((id)[50] & (1 << 0))
+#define ata_id_iordy_disable(id) ((id)[49] & (1 << 10))
+#define ata_id_has_iordy(id) ((id)[49] & (1 << 9))
#define ata_id_u32(id,n) \
(((u32) (id)[(n) + 1] << 16) | ((u32) (id)[(n)]))
#define ata_id_u64(id,n) \
{
unsigned int mver;
+ if (id[ATA_ID_MAJOR_VER] == 0xFFFF)
+ return 0;
+
for (mver = 14; mver >= 1; mver--)
if (id[ATA_ID_MAJOR_VER] & (1 << mver))
break;
return mver;
}
+static inline int ata_id_is_sata(const u16 *id)
+{
+ return ata_id_major_version(id) >= 5 && id[93] == 0;
+}
+
static inline int ata_id_current_chs_valid(const u16 *id)
{
- /* For ATA-1 devices, if the INITIALIZE DEVICE PARAMETERS command
- has not been issued to the device then the values of
+ /* For ATA-1 devices, if the INITIALIZE DEVICE PARAMETERS command
+ has not been issued to the device then the values of
id[54] to id[56] are vendor specific. */
return (id[53] & 0x01) && /* Current translation valid */
id[54] && /* cylinders in current translation */
id[56]; /* sectors in current translation */
}
+static inline int ata_id_is_cfa(const u16 *id)
+{
+ u16 v = id[0];
+ if (v == 0x848A) /* Standard CF */
+ return 1;
+ /* Could be CF hiding as standard ATA */
+ if (ata_id_major_version(id) >= 3 && id[82] != 0xFFFF &&
+ (id[82] & ( 1 << 2)))
+ return 1;
+ return 0;
+}
+
+static inline int ata_drive_40wire(const u16 *dev_id)
+{
+ if (ata_id_is_sata(dev_id))
+ return 0; /* SATA */
+ if ((dev_id[93] & 0xE000) == 0x6000)
+ return 0; /* 80 wire */
+ return 1;
+}
+
static inline int atapi_cdb_len(const u16 *dev_id)
{
u16 tmp = dev_id[0] & 0x3;
return ((block + n_block - 1) < ((u64)1 << 48)) && (n_block <= 65536);
}
+#define sata_pmp_gscr_vendor(gscr) ((gscr)[SATA_PMP_GSCR_PROD_ID] & 0xffff)
+#define sata_pmp_gscr_devid(gscr) ((gscr)[SATA_PMP_GSCR_PROD_ID] >> 16)
+#define sata_pmp_gscr_rev(gscr) (((gscr)[SATA_PMP_GSCR_REV] >> 8) & 0xff)
+#define sata_pmp_gscr_ports(gscr) ((gscr)[SATA_PMP_GSCR_PORT_INFO] & 0xf)
+
#endif /* __LINUX_ATA_H__ */
git://ftp.safe.ca / safe / jmp / linux-2.6 / blobdiff