If you plan to use the LCD display with your SA-1100 system, say
Y here.
+config HAVE_FB_IMX
+ bool
+
config FB_IMX
tristate "Motorola i.MX LCD support"
- depends on FB && (ARCH_MX1 || ARCH_MX2)
+ depends on FB && (HAVE_FB_IMX || ARCH_MX1 || ARCH_MX2)
select FB_CFB_FILLRECT
select FB_CFB_COPYAREA
select FB_CFB_IMAGEBLIT
config FB_XVR1000
bool "Sun XVR-1000 support"
- depends on SPARC64
+ depends on (FB = y) && SPARC64
select FB_CFB_FILLRECT
select FB_CFB_COPYAREA
select FB_CFB_IMAGEBLIT
select FB_CFB_FILLRECT
select FB_CFB_COPYAREA
select FB_CFB_IMAGEBLIT
- select FB_SOFT_CURSOR
select I2C_ALGOBIT
select I2C
+ select GPIOLIB
help
This is the frame buffer device driver for Graphics chips of VIA
UniChrome (Pro) Family (CLE266,PM800/CN400,P4M800CE/P4M800Pro/
To compile this driver as a module, choose M here: the
module will be called viafb.
+
+if FB_VIA
+
+config FB_VIA_DIRECT_PROCFS
+ bool "direct hardware access via procfs (DEPRECATED)(DANGEROUS)"
+ depends on FB_VIA
+ default n
+ help
+ Allow direct hardware access to some output registers via procfs.
+ This is dangerous but may provide the only chance to get the
+ correct output device configuration.
+ Its use is strongly discouraged.
+
+endif
+
config FB_NEOMAGIC
tristate "NeoMagic display support"
depends on FB && PCI
config FB_SH_MOBILE_LCDC
tristate "SuperH Mobile LCDC framebuffer support"
- depends on FB && SUPERH && HAVE_CLK
+ depends on FB && (SUPERH || ARCH_SHMOBILE) && HAVE_CLK
select FB_SYS_FILLRECT
select FB_SYS_COPYAREA
select FB_SYS_IMAGEBLIT
Turn on debugging messages. Note that you can set/unset at run time
through sysfs
+config FB_NUC900
+ bool "NUC900 LCD framebuffer support"
+ depends on FB && ARCH_W90X900
+ select FB_CFB_FILLRECT
+ select FB_CFB_COPYAREA
+ select FB_CFB_IMAGEBLIT
+ ---help---
+ Frame buffer driver for the built-in LCD controller in the Nuvoton
+ NUC900 processor
+
+config GPM1040A0_320X240
+ bool "Giantplus Technology GPM1040A0 320x240 Color TFT LCD"
+ depends on FB_NUC900
+
+config FB_NUC900_DEBUG
+ bool "NUC900 lcd debug messages"
+ depends on FB_NUC900
+ help
+ Turn on debugging messages. Note that you can set/unset at run time
+ through sysfs
+
config FB_SM501
tristate "Silicon Motion SM501 framebuffer support"
depends on FB && MFD_SM501
select FB_CFB_FILLRECT
select FB_CFB_COPYAREA
select FB_CFB_IMAGEBLIT
- default y
config FB_MX3
tristate "MX3 Framebuffer support"