#include "../core/hcd.h"
-#define DRIVER_VERSION "2006 August 04"
#define DRIVER_AUTHOR "Roman Weissgaerber, David Brownell"
#define DRIVER_DESC "USB 1.1 'Open' Host Controller (OHCI) Driver"
static int ohci_restart (struct ohci_hcd *ohci);
#endif
+#ifdef CONFIG_PCI
+static void quirk_amd_pll(int state);
+static void amd_iso_dev_put(void);
+#else
+static inline void quirk_amd_pll(int state)
+{
+ return;
+}
+static inline void amd_iso_dev_put(void)
+{
+ return;
+}
+#endif
+
+
#include "ohci-hub.c"
#include "ohci-dbg.c"
#include "ohci-mem.c"
int ret;
struct usb_hcd *hcd = ohci_to_hcd(ohci);
+ if (distrust_firmware)
+ ohci->flags |= OHCI_QUIRK_HUB_POWER;
+
disable (ohci);
ohci->regs = hcd->regs;
*/
static int ohci_run (struct ohci_hcd *ohci)
{
- u32 mask, temp;
+ u32 mask, val;
int first = ohci->fminterval == 0;
struct usb_hcd *hcd = ohci_to_hcd(ohci);
/* boot firmware should have set this up (5.1.1.3.1) */
if (first) {
- temp = ohci_readl (ohci, &ohci->regs->fminterval);
- ohci->fminterval = temp & 0x3fff;
+ val = ohci_readl (ohci, &ohci->regs->fminterval);
+ ohci->fminterval = val & 0x3fff;
if (ohci->fminterval != FI)
ohci_dbg (ohci, "fminterval delta %d\n",
ohci->fminterval - FI);
/* also: power/overcurrent flags in roothub.a */
}
- /* Reset USB nearly "by the book". RemoteWakeupConnected was
- * saved if boot firmware (BIOS/SMM/...) told us it's connected,
- * or if bus glue did the same (e.g. for PCI add-in cards with
- * PCI PM support).
+ /* Reset USB nearly "by the book". RemoteWakeupConnected has
+ * to be checked in case boot firmware (BIOS/SMM/...) has set up
+ * wakeup in a way the bus isn't aware of (e.g., legacy PCI PM).
+ * If the bus glue detected wakeup capability then it should
+ * already be enabled; if so we'll just enable it again.
*/
- if ((ohci->hc_control & OHCI_CTRL_RWC) != 0
- && !device_may_wakeup(hcd->self.controller))
- device_init_wakeup(hcd->self.controller, 1);
+ if ((ohci->hc_control & OHCI_CTRL_RWC) != 0)
+ device_set_wakeup_capable(hcd->self.controller, 1);
switch (ohci->hc_control & OHCI_CTRL_HCFS) {
case OHCI_USB_OPER:
- temp = 0;
+ val = 0;
break;
case OHCI_USB_SUSPEND:
case OHCI_USB_RESUME:
ohci->hc_control &= OHCI_CTRL_RWC;
ohci->hc_control |= OHCI_USB_RESUME;
- temp = 10 /* msec wait */;
+ val = 10 /* msec wait */;
break;
// case OHCI_USB_RESET:
default:
ohci->hc_control &= OHCI_CTRL_RWC;
ohci->hc_control |= OHCI_USB_RESET;
- temp = 50 /* msec wait */;
+ val = 50 /* msec wait */;
break;
}
ohci_writel (ohci, ohci->hc_control, &ohci->regs->control);
// flush the writes
(void) ohci_readl (ohci, &ohci->regs->control);
- msleep(temp);
+ msleep(val);
memset (ohci->hcca, 0, sizeof (struct ohci_hcca));
retry:
/* HC Reset requires max 10 us delay */
ohci_writel (ohci, OHCI_HCR, &ohci->regs->cmdstatus);
- temp = 30; /* ... allow extra time */
+ val = 30; /* ... allow extra time */
while ((ohci_readl (ohci, &ohci->regs->cmdstatus) & OHCI_HCR) != 0) {
- if (--temp == 0) {
+ if (--val == 0) {
spin_unlock_irq (&ohci->lock);
ohci_err (ohci, "USB HC reset timed out!\n");
return -1;
ohci_writel (ohci, mask, &ohci->regs->intrenable);
/* handle root hub init quirks ... */
- temp = roothub_a (ohci);
- temp &= ~(RH_A_PSM | RH_A_OCPM);
+ val = roothub_a (ohci);
+ val &= ~(RH_A_PSM | RH_A_OCPM);
if (ohci->flags & OHCI_QUIRK_SUPERIO) {
/* NSC 87560 and maybe others */
- temp |= RH_A_NOCP;
- temp &= ~(RH_A_POTPGT | RH_A_NPS);
- ohci_writel (ohci, temp, &ohci->regs->roothub.a);
- } else if ((ohci->flags & OHCI_QUIRK_AMD756) || distrust_firmware) {
+ val |= RH_A_NOCP;
+ val &= ~(RH_A_POTPGT | RH_A_NPS);
+ ohci_writel (ohci, val, &ohci->regs->roothub.a);
+ } else if ((ohci->flags & OHCI_QUIRK_AMD756) ||
+ (ohci->flags & OHCI_QUIRK_HUB_POWER)) {
/* hub power always on; required for AMD-756 and some
* Mac platforms. ganged overcurrent reporting, if any.
*/
- temp |= RH_A_NPS;
- ohci_writel (ohci, temp, &ohci->regs->roothub.a);
+ val |= RH_A_NPS;
+ ohci_writel (ohci, val, &ohci->regs->roothub.a);
}
ohci_writel (ohci, RH_HS_LPSC, &ohci->regs->roothub.status);
- ohci_writel (ohci, (temp & RH_A_NPS) ? 0 : RH_B_PPCM,
+ ohci_writel (ohci, (val & RH_A_NPS) ? 0 : RH_B_PPCM,
&ohci->regs->roothub.b);
// flush those writes
(void) ohci_readl (ohci, &ohci->regs->control);
spin_unlock_irq (&ohci->lock);
// POTPGT delay is bits 24-31, in 2 ms units.
- mdelay ((temp >> 23) & 0x1fe);
+ mdelay ((val >> 23) & 0x1fe);
hcd->state = HC_STATE_RUNNING;
if (quirk_zfmicro(ohci)) {
if (quirk_zfmicro(ohci))
del_timer(&ohci->unlink_watchdog);
+ if (quirk_amdiso(ohci))
+ amd_iso_dev_put();
remove_debug_files (ohci);
ohci_mem_cleanup (ohci);
/*-------------------------------------------------------------------------*/
-#define DRIVER_INFO DRIVER_VERSION " " DRIVER_DESC
-
MODULE_AUTHOR (DRIVER_AUTHOR);
-MODULE_DESCRIPTION (DRIVER_INFO);
+MODULE_DESCRIPTION(DRIVER_DESC);
MODULE_LICENSE ("GPL");
#ifdef CONFIG_PCI
#define PCI_DRIVER ohci_pci_driver
#endif
-#ifdef CONFIG_SA1111
+#if defined(CONFIG_ARCH_SA1100) && defined(CONFIG_SA1111)
#include "ohci-sa1111.c"
#define SA1111_DRIVER ohci_hcd_sa1111_driver
#endif
-#ifdef CONFIG_ARCH_S3C2410
+#if defined(CONFIG_ARCH_S3C2410) || defined(CONFIG_ARCH_S3C64XX)
#include "ohci-s3c2410.c"
#define PLATFORM_DRIVER ohci_hcd_s3c2410_driver
#endif
#if defined(CONFIG_CPU_SUBTYPE_SH7720) || \
defined(CONFIG_CPU_SUBTYPE_SH7721) || \
- defined(CONFIG_CPU_SUBTYPE_SH7763)
+ defined(CONFIG_CPU_SUBTYPE_SH7763) || \
+ defined(CONFIG_CPU_SUBTYPE_SH7786)
#include "ohci-sh.c"
#define PLATFORM_DRIVER ohci_hcd_sh_driver
#endif
#define SM501_OHCI_DRIVER ohci_hcd_sm501_driver
#endif
+#ifdef CONFIG_MFD_TC6393XB
+#include "ohci-tmio.c"
+#define TMIO_OHCI_DRIVER ohci_hcd_tmio_driver
+#endif
+
#if !defined(PCI_DRIVER) && \
!defined(PLATFORM_DRIVER) && \
!defined(OF_PLATFORM_DRIVER) && \
!defined(SA1111_DRIVER) && \
!defined(PS3_SYSTEM_BUS_DRIVER) && \
!defined(SM501_OHCI_DRIVER) && \
+ !defined(TMIO_OHCI_DRIVER) && \
!defined(SSB_OHCI_DRIVER)
#error "missing bus glue for ohci-hcd"
#endif
if (usb_disabled())
return -ENODEV;
- printk (KERN_DEBUG "%s: " DRIVER_INFO "\n", hcd_name);
+ printk(KERN_INFO "%s: " DRIVER_DESC "\n", hcd_name);
pr_debug ("%s: block sizes: ed %Zd td %Zd\n", hcd_name,
sizeof (struct ed), sizeof (struct td));
+ set_bit(USB_OHCI_LOADED, &usb_hcds_loaded);
#ifdef DEBUG
- ohci_debug_root = debugfs_create_dir("ohci", NULL);
+ ohci_debug_root = debugfs_create_dir("ohci", usb_debug_root);
if (!ohci_debug_root) {
retval = -ENOENT;
goto error_debug;
goto error_sm501;
#endif
+#ifdef TMIO_OHCI_DRIVER
+ retval = platform_driver_register(&TMIO_OHCI_DRIVER);
+ if (retval < 0)
+ goto error_tmio;
+#endif
+
return retval;
/* Error path */
+#ifdef TMIO_OHCI_DRIVER
+ platform_driver_unregister(&TMIO_OHCI_DRIVER);
+ error_tmio:
+#endif
#ifdef SM501_OHCI_DRIVER
+ platform_driver_unregister(&SM501_OHCI_DRIVER);
error_sm501:
#endif
#ifdef SSB_OHCI_DRIVER
+ ssb_driver_unregister(&SSB_OHCI_DRIVER);
error_ssb:
#endif
#ifdef PCI_DRIVER
error_debug:
#endif
+ clear_bit(USB_OHCI_LOADED, &usb_hcds_loaded);
return retval;
}
module_init(ohci_hcd_mod_init);
static void __exit ohci_hcd_mod_exit(void)
{
+#ifdef TMIO_OHCI_DRIVER
+ platform_driver_unregister(&TMIO_OHCI_DRIVER);
+#endif
#ifdef SM501_OHCI_DRIVER
platform_driver_unregister(&SM501_OHCI_DRIVER);
#endif
#ifdef DEBUG
debugfs_remove(ohci_debug_root);
#endif
+ clear_bit(USB_OHCI_LOADED, &usb_hcds_loaded);
}
module_exit(ohci_hcd_mod_exit);
git://ftp.safe.ca / safe / jmp / linux-2.6 / blobdiff