[ARM] pxa: move ssp into common plat-pxa

[safe/jmp/linux-2.6] / drivers / spi / pxa2xx_spi.c

diff --git a/drivers/spi/pxa2xx_spi.c b/drivers/spi/pxa2xx_spi.c
index c2f707e..50d6b78 100644 (file)
--- a/drivers/spi/pxa2xx_spi.c
+++ b/drivers/spi/pxa2xx_spi.c
@@ -29,14 +29,14 @@
 #include <linux/delay.h>
 #include <linux/clk.h>
 #include <linux/gpio.h>
+#include <linux/slab.h>
 
 #include <asm/io.h>
 #include <asm/irq.h>
 #include <asm/delay.h>
 
 #include <mach/dma.h>
-#include <mach/regs-ssp.h>
-#include <mach/ssp.h>
+#include <plat/ssp.h>
 #include <mach/pxa2xx_spi.h>
 
 MODULE_AUTHOR("Stephen Street");
@@ -1317,14 +1317,14 @@ static int setup(struct spi_device *spi)
        /* NOTE:  PXA25x_SSP _could_ use external clocking ... */
        if (drv_data->ssp_type != PXA25x_SSP)
                dev_dbg(&spi->dev, "%ld Hz actual, %s\n",
-                               clk_get_rate(ssp->clk)
-                                       / (1 + ((chip->cr0 & SSCR0_SCR) >> 8)),
-                               chip->enable_dma ? "DMA" : "PIO");
+                       clk_get_rate(ssp->clk)
+                               / (1 + ((chip->cr0 & SSCR0_SCR(0xfff)) >> 8)),
+                       chip->enable_dma ? "DMA" : "PIO");
        else
                dev_dbg(&spi->dev, "%ld Hz actual, %s\n",
-                               clk_get_rate(ssp->clk) / 2
-                                       / (1 + ((chip->cr0 & SSCR0_SCR) >> 8)),
-                               chip->enable_dma ? "DMA" : "PIO");
+                       clk_get_rate(ssp->clk) / 2
+                               / (1 + ((chip->cr0 & SSCR0_SCR(0x0ff)) >> 8)),
+                       chip->enable_dma ? "DMA" : "PIO");
 
        if (spi->bits_per_word <= 8) {
                chip->n_bytes = 1;
@@ -1557,7 +1557,7 @@ static int __init pxa2xx_spi_probe(struct platform_device *pdev)
        write_SSCR1(SSCR1_RxTresh(RX_THRESH_DFLT) |
                                SSCR1_TxTresh(TX_THRESH_DFLT),
                                drv_data->ioaddr);
-       write_SSCR0(SSCR0_SerClkDiv(2)
+       write_SSCR0(SSCR0_SCR(2)
                        | SSCR0_Motorola
                        | SSCR0_DataSize(8),
                        drv_data->ioaddr);