sched: Remove the cfs_rq dependency from set_task_cpu()

[safe/jmp/linux-2.6] / drivers / spi / Kconfig

diff --git a/drivers/spi/Kconfig b/drivers/spi/Kconfig
index c00f9e5..2d9d703 100644 (file)
--- a/drivers/spi/Kconfig
+++ b/drivers/spi/Kconfig
@@ -155,9 +155,6 @@ config SPI_MPC8xxx
          This enables using the Freescale MPC8xxx SPI controllers in master
          mode.
 
-         This driver uses a simple set of shift registers for data (opposed
-         to the CPM based descriptor model).
-
 config SPI_OMAP_UWIRE
        tristate "OMAP1 MicroWire"
        depends on ARCH_OMAP1
@@ -172,6 +169,12 @@ config SPI_OMAP24XX
          SPI master controller for OMAP24xx/OMAP34xx Multichannel SPI
          (McSPI) modules.
 
+config SPI_OMAP_100K
+       tristate "OMAP SPI 100K"
+       depends on SPI_MASTER && (ARCH_OMAP850 || ARCH_OMAP730)
+       help
+         OMAP SPI 100K master controller for omap7xx boards.
+
 config SPI_ORION
        tristate "Orion SPI master (EXPERIMENTAL)"
        depends on PLAT_ORION && EXPERIMENTAL
@@ -223,6 +226,13 @@ config SPI_S3C24XX_GPIO
          the inbuilt hardware cannot provide the transfer mode, or
          where the board is using non hardware connected pins.
 
+config SPI_SH_MSIOF
+       tristate "SuperH MSIOF SPI controller"
+       depends on SUPERH && HAVE_CLK
+       select SPI_BITBANG
+       help
+         SPI driver for SuperH MSIOF blocks.
+
 config SPI_SH_SCI
        tristate "SuperH SCI SPI controller"
        depends on SUPERH
@@ -268,6 +278,13 @@ config SPI_XILINX_PLTFM
          This is the platform driver for the SPI controller IP
          from the Xilinx EDK.
 
+config SPI_NUC900
+       tristate "Nuvoton NUC900 series SPI"
+       depends on ARCH_W90X900 && EXPERIMENTAL
+       select SPI_BITBANG
+       help
+         SPI driver for Nuvoton NUC900 series ARM SoCs
+
 #
 # Add new SPI master controllers in alphabetical order above this line
 #