#include <linux/libata.h>
#define DRV_NAME "sata_uli"
-#define DRV_VERSION "0.5"
+#define DRV_VERSION "0.6"
enum {
uli_5289 = 0,
uli_5287 = 1,
uli_5281 = 2,
+ uli_max_ports = 4,
+
/* PCI configuration registers */
ULI5287_BASE = 0x90, /* sata0 phy SCR registers */
ULI5287_OFFS = 0x10, /* offset from sata0->sata1 phy regs */
ULI5281_OFFS = 0x60, /* offset from sata0->sata1 phy regs */
};
+struct uli_priv {
+ unsigned int scr_cfg_addr[uli_max_ports];
+};
+
static int uli_init_one (struct pci_dev *pdev, const struct pci_device_id *ent);
static u32 uli_scr_read (struct ata_port *ap, unsigned int sc_reg);
static void uli_scr_write (struct ata_port *ap, unsigned int sc_reg, u32 val);
-static struct pci_device_id uli_pci_tbl[] = {
+static const struct pci_device_id uli_pci_tbl[] = {
{ PCI_VENDOR_ID_AL, 0x5289, PCI_ANY_ID, PCI_ANY_ID, 0, 0, uli_5289 },
{ PCI_VENDOR_ID_AL, 0x5287, PCI_ANY_ID, PCI_ANY_ID, 0, 0, uli_5287 },
{ PCI_VENDOR_ID_AL, 0x5281, PCI_ANY_ID, PCI_ANY_ID, 0, 0, uli_5281 },
.name = DRV_NAME,
.ioctl = ata_scsi_ioctl,
.queuecommand = ata_scsi_queuecmd,
- .eh_strategy_handler = ata_scsi_error,
.can_queue = ATA_DEF_QUEUE,
.this_id = ATA_SHT_THIS_ID,
.sg_tablesize = LIBATA_MAX_PRD,
- .max_sectors = ATA_MAX_SECTORS,
.cmd_per_lun = ATA_SHT_CMD_PER_LUN,
.emulated = ATA_SHT_EMULATED,
.use_clustering = ATA_SHT_USE_CLUSTERING,
.proc_name = DRV_NAME,
.dma_boundary = ATA_DMA_BOUNDARY,
.slave_configure = ata_scsi_slave_config,
+ .slave_destroy = ata_scsi_slave_destroy,
.bios_param = ata_std_bios_param,
- .ordered_flush = 1,
};
static const struct ata_port_operations uli_ops = {
.exec_command = ata_exec_command,
.dev_select = ata_std_dev_select,
- .phy_reset = sata_phy_reset,
-
.bmdma_setup = ata_bmdma_setup,
.bmdma_start = ata_bmdma_start,
.bmdma_stop = ata_bmdma_stop,
.bmdma_status = ata_bmdma_status,
.qc_prep = ata_qc_prep,
.qc_issue = ata_qc_issue_prot,
+ .data_xfer = ata_pio_data_xfer,
- .eng_timeout = ata_eng_timeout,
+ .freeze = ata_bmdma_freeze,
+ .thaw = ata_bmdma_thaw,
+ .error_handler = ata_bmdma_error_handler,
+ .post_internal_cmd = ata_bmdma_post_internal_cmd,
.irq_handler = ata_interrupt,
.irq_clear = ata_bmdma_irq_clear,
static struct ata_port_info uli_port_info = {
.sht = &uli_sht,
- .host_flags = ATA_FLAG_SATA | ATA_FLAG_SATA_RESET |
- ATA_FLAG_NO_LEGACY,
+ .host_flags = ATA_FLAG_SATA | ATA_FLAG_NO_LEGACY,
.pio_mask = 0x1f, /* pio0-4 */
.udma_mask = 0x7f, /* udma0-6 */
.port_ops = &uli_ops,
static unsigned int get_scr_cfg_addr(struct ata_port *ap, unsigned int sc_reg)
{
- return ap->ioaddr.scr_addr + (4 * sc_reg);
+ struct uli_priv *hpriv = ap->host_set->private_data;
+ return hpriv->scr_cfg_addr[ap->port_no] + (4 * sc_reg);
}
static u32 uli_scr_cfg_read (struct ata_port *ap, unsigned int sc_reg)
int rc;
unsigned int board_idx = (unsigned int) ent->driver_data;
int pci_dev_busy = 0;
+ struct uli_priv *hpriv;
if (!printed_version++)
dev_printk(KERN_INFO, &pdev->dev, "version " DRV_VERSION "\n");
goto err_out_regions;
}
+ hpriv = kzalloc(sizeof(*hpriv), GFP_KERNEL);
+ if (!hpriv) {
+ rc = -ENOMEM;
+ goto err_out_probe_ent;
+ }
+
+ probe_ent->private_data = hpriv;
+
switch (board_idx) {
case uli_5287:
- probe_ent->port[0].scr_addr = ULI5287_BASE;
- probe_ent->port[1].scr_addr = ULI5287_BASE + ULI5287_OFFS;
+ hpriv->scr_cfg_addr[0] = ULI5287_BASE;
+ hpriv->scr_cfg_addr[1] = ULI5287_BASE + ULI5287_OFFS;
probe_ent->n_ports = 4;
probe_ent->port[2].cmd_addr = pci_resource_start(pdev, 0) + 8;
probe_ent->port[2].ctl_addr =
(pci_resource_start(pdev, 1) | ATA_PCI_CTL_OFS) + 4;
probe_ent->port[2].bmdma_addr = pci_resource_start(pdev, 4) + 16;
- probe_ent->port[2].scr_addr = ULI5287_BASE + ULI5287_OFFS*4;
+ hpriv->scr_cfg_addr[2] = ULI5287_BASE + ULI5287_OFFS*4;
probe_ent->port[3].cmd_addr = pci_resource_start(pdev, 2) + 8;
probe_ent->port[3].altstatus_addr =
probe_ent->port[3].ctl_addr =
(pci_resource_start(pdev, 3) | ATA_PCI_CTL_OFS) + 4;
probe_ent->port[3].bmdma_addr = pci_resource_start(pdev, 4) + 24;
- probe_ent->port[3].scr_addr = ULI5287_BASE + ULI5287_OFFS*5;
+ hpriv->scr_cfg_addr[3] = ULI5287_BASE + ULI5287_OFFS*5;
ata_std_ports(&probe_ent->port[2]);
ata_std_ports(&probe_ent->port[3]);
break;
case uli_5289:
- probe_ent->port[0].scr_addr = ULI5287_BASE;
- probe_ent->port[1].scr_addr = ULI5287_BASE + ULI5287_OFFS;
+ hpriv->scr_cfg_addr[0] = ULI5287_BASE;
+ hpriv->scr_cfg_addr[1] = ULI5287_BASE + ULI5287_OFFS;
break;
case uli_5281:
- probe_ent->port[0].scr_addr = ULI5281_BASE;
- probe_ent->port[1].scr_addr = ULI5281_BASE + ULI5281_OFFS;
+ hpriv->scr_cfg_addr[0] = ULI5281_BASE;
+ hpriv->scr_cfg_addr[1] = ULI5281_BASE + ULI5281_OFFS;
break;
default:
return 0;
+err_out_probe_ent:
+ kfree(probe_ent);
err_out_regions:
pci_release_regions(pdev);
-
err_out:
if (!pci_dev_busy)
pci_disable_device(pdev);
git://ftp.safe.ca / safe / jmp / linux-2.6 / blobdiff