/*
* Adaptec AAC series RAID controller driver
- * (c) Copyright 2001 Red Hat Inc. <alan@redhat.com>
+ * (c) Copyright 2001 Red Hat Inc.
*
* based on the old aacraid driver that is..
* Adaptec aacraid device driver for Linux.
#include <linux/moduleparam.h>
#include <linux/pci.h>
#include <linux/slab.h>
+#include <linux/smp_lock.h>
#include <linux/spinlock.h>
#include <linux/syscalls.h>
#include <linux/delay.h>
*
* Note: The last field is used to index into aac_drivers below.
*/
-static struct pci_device_id aac_pci_tbl[] = {
+#ifdef DECLARE_PCI_DEVICE_TABLE
+static DECLARE_PCI_DEVICE_TABLE(aac_pci_tbl) = {
+#elif defined(__devinitconst)
+static const struct pci_device_id aac_pci_tbl[] __devinitconst = {
+#else
+static const struct pci_device_id aac_pci_tbl[] __devinitdata = {
+#endif
{ 0x1028, 0x0001, 0x1028, 0x0001, 0, 0, 0 }, /* PERC 2/Si (Iguana/PERC2Si) */
{ 0x1028, 0x0002, 0x1028, 0x0002, 0, 0, 1 }, /* PERC 3/Di (Opal/PERC3Di) */
{ 0x1028, 0x0003, 0x1028, 0x0003, 0, 0, 2 }, /* PERC 3/Si (SlimFast/PERC3Si */
{ aac_rx_init, "percraid", "DELL ", "PERCRAID ", 2, AAC_QUIRK_31BIT | AAC_QUIRK_34SG | AAC_QUIRK_SCSI_32 }, /* PERC 3/Di (Boxster/PERC3DiB) */
{ aac_rx_init, "aacraid", "ADAPTEC ", "catapult ", 2, AAC_QUIRK_31BIT | AAC_QUIRK_34SG | AAC_QUIRK_SCSI_32 }, /* catapult */
{ aac_rx_init, "aacraid", "ADAPTEC ", "tomcat ", 2, AAC_QUIRK_31BIT | AAC_QUIRK_34SG | AAC_QUIRK_SCSI_32 }, /* tomcat */
- { aac_rx_init, "aacraid", "ADAPTEC ", "Adaptec 2120S ", 1, AAC_QUIRK_31BIT | AAC_QUIRK_34SG | AAC_QUIRK_SCSI_32 }, /* Adaptec 2120S (Crusader) */
- { aac_rx_init, "aacraid", "ADAPTEC ", "Adaptec 2200S ", 2, AAC_QUIRK_31BIT | AAC_QUIRK_34SG | AAC_QUIRK_SCSI_32 }, /* Adaptec 2200S (Vulcan) */
+ { aac_rx_init, "aacraid", "ADAPTEC ", "Adaptec 2120S ", 1, AAC_QUIRK_31BIT | AAC_QUIRK_34SG }, /* Adaptec 2120S (Crusader) */
+ { aac_rx_init, "aacraid", "ADAPTEC ", "Adaptec 2200S ", 2, AAC_QUIRK_31BIT | AAC_QUIRK_34SG }, /* Adaptec 2200S (Vulcan) */
{ aac_rx_init, "aacraid", "ADAPTEC ", "Adaptec 2200S ", 2, AAC_QUIRK_31BIT | AAC_QUIRK_34SG | AAC_QUIRK_SCSI_32 }, /* Adaptec 2200S (Vulcan-2m) */
{ aac_rx_init, "aacraid", "Legend ", "Legend S220 ", 1, AAC_QUIRK_31BIT | AAC_QUIRK_34SG | AAC_QUIRK_SCSI_32 }, /* Legend S220 (Legend Crusader) */
{ aac_rx_init, "aacraid", "Legend ", "Legend S230 ", 2, AAC_QUIRK_31BIT | AAC_QUIRK_34SG | AAC_QUIRK_SCSI_32 }, /* Legend S230 (Legend Vulcan) */
* Firmware has an individual device recovery time typically
* of 35 seconds, give us a margin.
*/
- if (sdev->timeout < (45 * HZ))
- sdev->timeout = 45 * HZ;
+ if (sdev->request_queue->rq_timeout < (45 * HZ))
+ blk_queue_rq_timeout(sdev->request_queue, 45*HZ);
for (cid = 0; cid < aac->maximum_num_containers; ++cid)
if (aac->fsa_dev[cid].valid)
++num_lsu;
* total capacity and the queue depth supported by the target device.
*/
-static int aac_change_queue_depth(struct scsi_device *sdev, int depth)
+static int aac_change_queue_depth(struct scsi_device *sdev, int depth,
+ int reason)
{
+ if (reason != SCSI_QDEPTH_DEFAULT)
+ return -EOPNOTSUPP;
+
if (sdev->tagged_supported && (sdev->type == TYPE_DISK) &&
(sdev_channel(sdev) == CONTAINER_CHANNEL)) {
struct scsi_device * dev;
unsigned minor_number = iminor(inode);
int err = -ENODEV;
+ lock_kernel(); /* BKL pushdown: nothing else protects this list */
list_for_each_entry(aac, &aac_devices, entry) {
if (aac->id == minor_number) {
file->private_data = aac;
break;
}
}
+ unlock_kernel();
return err;
}
goto out;
error = -ENODEV;
- if (pci_set_dma_mask(pdev, DMA_32BIT_MASK) ||
- pci_set_consistent_dma_mask(pdev, DMA_32BIT_MASK))
+ if (pci_set_dma_mask(pdev, DMA_BIT_MASK(32)) ||
+ pci_set_consistent_dma_mask(pdev, DMA_BIT_MASK(32)))
goto out_disable_pdev;
/*
* If the quirk31 bit is set, the adapter needs adapter
* to driver communication memory to be allocated below 2gig
*/
if (aac_drivers[index].quirks & AAC_QUIRK_31BIT)
- if (pci_set_dma_mask(pdev, DMA_31BIT_MASK) ||
- pci_set_consistent_dma_mask(pdev, DMA_31BIT_MASK))
+ if (pci_set_dma_mask(pdev, DMA_BIT_MASK(31)) ||
+ pci_set_consistent_dma_mask(pdev, DMA_BIT_MASK(31)))
goto out_disable_pdev;
pci_set_master(pdev);
* address space.
*/
if (aac_drivers[index].quirks & AAC_QUIRK_31BIT)
- if (pci_set_dma_mask(pdev, DMA_32BIT_MASK))
+ if (pci_set_dma_mask(pdev, DMA_BIT_MASK(32)))
goto out_deinit;
aac->maximum_num_channels = aac_drivers[index].channels;