bus_region.end = res->end;
pcibios_bus_to_resource(dev, res, &bus_region);
- pci_claim_resource(dev, nr);
- dev_info(&dev->dev, "quirk: %pR claimed by %s\n", res, name);
+ if (pci_claim_resource(dev, nr) == 0)
+ dev_info(&dev->dev, "quirk: %pR claimed by %s\n",
+ res, name);
}
}
/*
* Disable PCI Bus Parking and PCI Master read caching on CX700
* which causes unspecified timing errors with a VT6212L on the PCI
- * bus leading to USB2.0 packet loss. The defaults are that these
- * features are turned off but some BIOSes turn them on.
+ * bus leading to USB2.0 packet loss.
+ *
+ * This quirk is only enabled if a second (on the external PCI bus)
+ * VT6212L is found -- the CX700 core itself also contains a USB
+ * host controller with the same PCI ID as the VT6212L.
*/
+ /* Count VT6212L instances */
+ struct pci_dev *p = pci_get_device(PCI_VENDOR_ID_VIA,
+ PCI_DEVICE_ID_VIA_8235_USB_2, NULL);
uint8_t b;
+
+ /* p should contain the first (internal) VT6212L -- see if we have
+ an external one by searching again */
+ p = pci_get_device(PCI_VENDOR_ID_VIA, PCI_DEVICE_ID_VIA_8235_USB_2, p);
+ if (!p)
+ return;
+ pci_dev_put(p);
+
if (pci_read_config_byte(dev, 0x76, &b) == 0) {
if (b & 0x40) {
/* Turn off PCI Bus Parking */
}
}
}
-DECLARE_PCI_FIXUP_EARLY(PCI_VENDOR_ID_VIA, 0x324e, quirk_via_cx700_pci_parking_caching);
+DECLARE_PCI_FIXUP_FINAL(PCI_VENDOR_ID_VIA, 0x324e, quirk_via_cx700_pci_parking_caching);
/*
* For Broadcom 5706, 5708, 5709 rev. A nics, any read beyond the
}
}
DECLARE_PCI_FIXUP_FINAL(PCI_VENDOR_ID_AMD, PCI_DEVICE_ID_AMD_8131_BRIDGE, quirk_disable_msi);
+DECLARE_PCI_FIXUP_FINAL(PCI_VENDOR_ID_VIA, 0xa238, quirk_disable_msi);
/* Go through the list of Hypertransport capabilities and
* return 1 if a HT MSI capability is found and enabled */
DECLARE_PCI_FIXUP_FINAL(PCI_VENDOR_ID_ATI, 0x4375,
quirk_msi_intx_disable_bug);
+/*
+ * MSI does not work with the AMD RS780/RS880 internal graphics and HDMI audio
+ * devices unless the BIOS has initialized the nb_cntl.strap_msi_enable bit.
+ */
+static void __init rs780_int_gfx_disable_msi(struct pci_dev *int_gfx_bridge)
+{
+ u32 nb_cntl;
+
+ if (!int_gfx_bridge->subordinate)
+ return;
+
+ pci_bus_write_config_dword(int_gfx_bridge->bus, PCI_DEVFN(0, 0),
+ 0x60, 0);
+ pci_bus_read_config_dword(int_gfx_bridge->bus, PCI_DEVFN(0, 0),
+ 0x64, &nb_cntl);
+
+ if (!(nb_cntl & BIT(10))) {
+ dev_warn(&int_gfx_bridge->dev,
+ FW_WARN "RS780: MSI for internal graphics disabled\n");
+ int_gfx_bridge->subordinate->bus_flags |= PCI_BUS_FLAGS_NO_MSI;
+ }
+}
+
+#define PCI_DEVICE_ID_AMD_RS780_P2P_INT_GFX 0x9602
+
+DECLARE_PCI_FIXUP_FINAL(PCI_VENDOR_ID_AMD,
+ PCI_DEVICE_ID_AMD_RS780_P2P_INT_GFX,
+ rs780_int_gfx_disable_msi);
+/* wrong vendor ID on M4A785TD motherboard: */
+DECLARE_PCI_FIXUP_FINAL(PCI_VENDOR_ID_ASUSTEK,
+ PCI_DEVICE_ID_AMD_RS780_P2P_INT_GFX,
+ rs780_int_gfx_disable_msi);
+
#endif /* CONFIG_PCI_MSI */
#ifdef CONFIG_PCI_IOV
DECLARE_PCI_FIXUP_HEADER(PCI_VENDOR_ID_INTEL, 0x10e8, quirk_i82576_sriov);
DECLARE_PCI_FIXUP_HEADER(PCI_VENDOR_ID_INTEL, 0x150a, quirk_i82576_sriov);
DECLARE_PCI_FIXUP_HEADER(PCI_VENDOR_ID_INTEL, 0x150d, quirk_i82576_sriov);
+DECLARE_PCI_FIXUP_HEADER(PCI_VENDOR_ID_INTEL, 0x1518, quirk_i82576_sriov);
#endif /* CONFIG_PCI_IOV */
+/*
+ * This is a quirk for the Ricoh MMC controller found as a part of
+ * some mulifunction chips.
+
+ * This is very similiar and based on the ricoh_mmc driver written by
+ * Philip Langdale. Thank you for these magic sequences.
+ *
+ * These chips implement the four main memory card controllers (SD, MMC, MS, xD)
+ * and one or both of cardbus or firewire.
+ *
+ * It happens that they implement SD and MMC
+ * support as separate controllers (and PCI functions). The linux SDHCI
+ * driver supports MMC cards but the chip detects MMC cards in hardware
+ * and directs them to the MMC controller - so the SDHCI driver never sees
+ * them.
+ *
+ * To get around this, we must disable the useless MMC controller.
+ * At that point, the SDHCI controller will start seeing them
+ * It seems to be the case that the relevant PCI registers to deactivate the
+ * MMC controller live on PCI function 0, which might be the cardbus controller
+ * or the firewire controller, depending on the particular chip in question
+ *
+ * This has to be done early, because as soon as we disable the MMC controller
+ * other pci functions shift up one level, e.g. function #2 becomes function
+ * #1, and this will confuse the pci core.
+ */
+
+#ifdef CONFIG_MMC_RICOH_MMC
+static void ricoh_mmc_fixup_rl5c476(struct pci_dev *dev)
+{
+ /* disable via cardbus interface */
+ u8 write_enable;
+ u8 write_target;
+ u8 disable;
+
+ /* disable must be done via function #0 */
+ if (PCI_FUNC(dev->devfn))
+ return;
+
+ pci_read_config_byte(dev, 0xB7, &disable);
+ if (disable & 0x02)
+ return;
+
+ pci_read_config_byte(dev, 0x8E, &write_enable);
+ pci_write_config_byte(dev, 0x8E, 0xAA);
+ pci_read_config_byte(dev, 0x8D, &write_target);
+ pci_write_config_byte(dev, 0x8D, 0xB7);
+ pci_write_config_byte(dev, 0xB7, disable | 0x02);
+ pci_write_config_byte(dev, 0x8E, write_enable);
+ pci_write_config_byte(dev, 0x8D, write_target);
+
+ dev_notice(&dev->dev, "proprietary Ricoh MMC controller disabled (via cardbus function)\n");
+ dev_notice(&dev->dev, "MMC cards are now supported by standard SDHCI controller\n");
+}
+DECLARE_PCI_FIXUP_EARLY(PCI_VENDOR_ID_RICOH, PCI_DEVICE_ID_RICOH_RL5C476, ricoh_mmc_fixup_rl5c476);
+DECLARE_PCI_FIXUP_RESUME_EARLY(PCI_VENDOR_ID_RICOH, PCI_DEVICE_ID_RICOH_RL5C476, ricoh_mmc_fixup_rl5c476);
+
+static void ricoh_mmc_fixup_r5c832(struct pci_dev *dev)
+{
+ /* disable via firewire interface */
+ u8 write_enable;
+ u8 disable;
+
+ /* disable must be done via function #0 */
+ if (PCI_FUNC(dev->devfn))
+ return;
+
+ pci_read_config_byte(dev, 0xCB, &disable);
+
+ if (disable & 0x02)
+ return;
+
+ pci_read_config_byte(dev, 0xCA, &write_enable);
+ pci_write_config_byte(dev, 0xCA, 0x57);
+ pci_write_config_byte(dev, 0xCB, disable | 0x02);
+ pci_write_config_byte(dev, 0xCA, write_enable);
+
+ dev_notice(&dev->dev, "proprietary Ricoh MMC controller disabled (via firewire function)\n");
+ dev_notice(&dev->dev, "MMC cards are now supported by standard SDHCI controller\n");
+}
+DECLARE_PCI_FIXUP_EARLY(PCI_VENDOR_ID_RICOH, PCI_DEVICE_ID_RICOH_R5C832, ricoh_mmc_fixup_r5c832);
+DECLARE_PCI_FIXUP_RESUME_EARLY(PCI_VENDOR_ID_RICOH, PCI_DEVICE_ID_RICOH_R5C832, ricoh_mmc_fixup_r5c832);
+#endif /*CONFIG_MMC_RICOH_MMC*/
+
+
static void pci_do_fixups(struct pci_dev *dev, struct pci_fixup *f,
struct pci_fixup *end)
{
git://ftp.safe.ca / safe / jmp / linux-2.6 / blobdiff