if (!priv->vif || !priv->is_open)
return;
+ iwl_power_cancel_timeout(priv);
iwl_scan_cancel_timeout(priv, 200);
conf = ieee80211_get_hw_conf(priv->hw);
break;
}
- /* Enable Rx differential gain and sensitivity calibrations */
- iwl_chain_noise_reset(priv);
- priv->start_calib = 1;
-
if (priv->iw_mode == IEEE80211_IF_TYPE_IBSS)
priv->assoc_station_added = 1;
iwl_activate_qos(priv, 0);
spin_unlock_irqrestore(&priv->lock, flags);
- iwl_power_update_mode(priv, 0);
+ iwl_power_enable_management(priv);
+
+ /* Enable Rx differential gain and sensitivity calibrations */
+ iwl_chain_noise_reset(priv);
+ priv->start_calib = 1;
+
/* we have just associated, don't start scan too early */
priv->next_scan_jiffies = jiffies + IWL_DELAY_NEXT_SCAN;
}
/* Per mac80211.h: This is only used in IBSS mode... */
if (priv->iw_mode != IEEE80211_IF_TYPE_IBSS) {
+ /* switch to CAM during association period.
+ * the ucode will block any association/authentication
+ * frome during assiciation period if it can not hear
+ * the AP because of PM. the timer enable PM back is
+ * association do not complete
+ */
+ if (priv->hw->conf.channel->flags & (IEEE80211_CHAN_PASSIVE_SCAN |
+ IEEE80211_CHAN_RADAR))
+ iwl_power_disable_management(priv, 3000);
+
IWL_DEBUG_MAC80211("leave - not in IBSS\n");
mutex_unlock(&priv->mutex);
return;
/* FIXME : remove when resolved PENDING */
INIT_WORK(&priv->scan_completed, iwl_bg_scan_completed);
iwl_setup_scan_deferred_work(priv);
+ iwl_setup_power_deferred_work(priv);
if (priv->cfg->ops->lib->setup_deferred_work)
priv->cfg->ops->lib->setup_deferred_work(priv);
cancel_delayed_work_sync(&priv->init_alive_start);
cancel_delayed_work(&priv->scan_check);
+ cancel_delayed_work_sync(&priv->set_power_save);
cancel_delayed_work(&priv->alive_start);
cancel_work_sync(&priv->beacon_update);
del_timer_sync(&priv->statistics_periodic);