There are no ill effects from too-large receive rings. */
#define TX_RING_SIZE 16
#define TX_QUEUE_LEN 10 /* Limit ring entries actually used. */
-#ifdef CONFIG_VIA_RHINE_NAPI
#define RX_RING_SIZE 64
-#else
-#define RX_RING_SIZE 16
-#endif
-
/* Operational parameters that usually are not changed. */
#include <linux/dmi.h>
/* These identify the driver base version and may not be removed. */
-static char version[] __devinitdata =
-KERN_INFO DRV_NAME ".c:v1.10-LK" DRV_VERSION " " DRV_RELDATE " Written by Donald Becker\n";
+static const char version[] __devinitconst =
+ KERN_INFO DRV_NAME ".c:v1.10-LK" DRV_VERSION " " DRV_RELDATE
+ " Written by Donald Becker\n";
/* This driver was written to use PCI memory space. Some early versions
of the Rhine may only work correctly with I/O space accesses. */
The driver runs as two independent, single-threaded flows of control. One
is the send-packet routine, which enforces single-threaded use by the
-dev->priv->lock spinlock. The other thread is the interrupt handler, which
-is single threaded by the hardware and interrupt handling software.
+netdev_priv(dev)->lock spinlock. The other thread is the interrupt handler,
+which is single threaded by the hardware and interrupt handling software.
The send packet thread has partial control over the Tx ring. It locks the
-dev->priv->lock whenever it's queuing a Tx packet. If the next slot in the ring
-is not available it stops the transmit queue by calling netif_stop_queue.
+netdev_priv(dev)->lock whenever it's queuing a Tx packet. If the next slot in
+the ring is not available it stops the transmit queue by
+calling netif_stop_queue.
The interrupt handler has exclusive control over the Rx ring and records stats
from the Tx ring. After reaping the stats, it marks the Tx queue entry as
}
#endif
-#ifdef CONFIG_VIA_RHINE_NAPI
static int rhine_napipoll(struct napi_struct *napi, int budget)
{
struct rhine_private *rp = container_of(napi, struct rhine_private, napi);
work_done = rhine_rx(dev, budget);
if (work_done < budget) {
- netif_rx_complete(dev, napi);
+ napi_complete(napi);
iowrite16(IntrRxDone | IntrRxErr | IntrRxEmpty| IntrRxOverflow |
IntrRxDropped | IntrRxNoBuf | IntrTxAborted |
}
return work_done;
}
-#endif
static void __devinit rhine_hw_init(struct net_device *dev, long pioaddr)
{
rhine_reload_eeprom(pioaddr, dev);
}
+static const struct net_device_ops rhine_netdev_ops = {
+ .ndo_open = rhine_open,
+ .ndo_stop = rhine_close,
+ .ndo_start_xmit = rhine_start_tx,
+ .ndo_get_stats = rhine_get_stats,
+ .ndo_set_multicast_list = rhine_set_rx_mode,
+ .ndo_validate_addr = eth_validate_addr,
+ .ndo_set_mac_address = eth_mac_addr,
+ .ndo_do_ioctl = netdev_ioctl,
+ .ndo_tx_timeout = rhine_tx_timeout,
+#ifdef CONFIG_NET_POLL_CONTROLLER
+ .ndo_poll_controller = rhine_poll,
+#endif
+};
+
static int __devinit rhine_init_one(struct pci_dev *pdev,
const struct pci_device_id *ent)
{
#else
int bar = 0;
#endif
- DECLARE_MAC_BUF(mac);
/* when built into the kernel, we only print version if device is found */
#ifndef MODULE
goto err_out;
/* this should always be supported */
- rc = pci_set_dma_mask(pdev, DMA_32BIT_MASK);
+ rc = pci_set_dma_mask(pdev, DMA_BIT_MASK(32));
if (rc) {
printk(KERN_ERR "32-bit PCI DMA addresses not supported by "
"the card!?\n");
rp->mii_if.reg_num_mask = 0x1f;
/* The chip-specific entries in the device structure. */
- dev->open = rhine_open;
- dev->hard_start_xmit = rhine_start_tx;
- dev->stop = rhine_close;
- dev->get_stats = rhine_get_stats;
- dev->set_multicast_list = rhine_set_rx_mode;
- dev->do_ioctl = netdev_ioctl;
- dev->ethtool_ops = &netdev_ethtool_ops;
- dev->tx_timeout = rhine_tx_timeout;
+ dev->netdev_ops = &rhine_netdev_ops;
+ dev->ethtool_ops = &netdev_ethtool_ops,
dev->watchdog_timeo = TX_TIMEOUT;
-#ifdef CONFIG_NET_POLL_CONTROLLER
- dev->poll_controller = rhine_poll;
-#endif
-#ifdef CONFIG_VIA_RHINE_NAPI
+
netif_napi_add(dev, &rp->napi, rhine_napipoll, 64);
-#endif
+
if (rp->quirks & rqRhineI)
dev->features |= NETIF_F_SG|NETIF_F_HW_CSUM;
if (rc)
goto err_out_unmap;
- printk(KERN_INFO "%s: VIA %s at 0x%lx, %s, IRQ %d.\n",
+ printk(KERN_INFO "%s: VIA %s at 0x%lx, %pM, IRQ %d.\n",
dev->name, name,
#ifdef USE_MMIO
memaddr,
#else
(long)ioaddr,
#endif
- print_mac(mac, dev->dev_addr), pdev->irq);
+ dev->dev_addr, pdev->irq);
pci_set_drvdata(pdev, dev);
/* Fill in the Rx buffers. Handle allocation failure gracefully. */
for (i = 0; i < RX_RING_SIZE; i++) {
- struct sk_buff *skb = dev_alloc_skb(rp->rx_buf_sz);
+ struct sk_buff *skb = netdev_alloc_skb(dev, rp->rx_buf_sz);
rp->rx_skbuff[i] = skb;
if (skb == NULL)
break;
rhine_set_rx_mode(dev);
-#ifdef CONFIG_VIA_RHINE_NAPI
napi_enable(&rp->napi);
-#endif
/* Enable interrupts by setting the interrupt mask. */
iowrite16(IntrRxDone | IntrRxErr | IntrRxEmpty| IntrRxOverflow |
/* protect against concurrent rx interrupts */
disable_irq(rp->pdev->irq);
-#ifdef CONFIG_VIA_RHINE_NAPI
napi_disable(&rp->napi);
-#endif
spin_lock(&rp->lock);
if (intr_status & (IntrRxDone | IntrRxErr | IntrRxDropped |
IntrRxWakeUp | IntrRxEmpty | IntrRxNoBuf)) {
-#ifdef CONFIG_VIA_RHINE_NAPI
iowrite16(IntrTxAborted |
IntrTxDone | IntrTxError | IntrTxUnderrun |
IntrPCIErr | IntrStatsMax | IntrLinkChange,
ioaddr + IntrEnable);
- netif_rx_schedule(dev, &rp->napi);
-#else
- rhine_rx(dev, RX_RING_SIZE);
-#endif
+ napi_schedule(&rp->napi);
}
if (intr_status & (IntrTxErrSummary | IntrTxDone)) {
/* Check if the packet is long enough to accept without
copying to a minimally-sized skbuff. */
if (pkt_len < rx_copybreak &&
- (skb = dev_alloc_skb(pkt_len + 2)) != NULL) {
- skb_reserve(skb, 2); /* 16 byte align the IP header */
+ (skb = netdev_alloc_skb(dev, pkt_len + NET_IP_ALIGN)) != NULL) {
+ skb_reserve(skb, NET_IP_ALIGN); /* 16 byte align the IP header */
pci_dma_sync_single_for_cpu(rp->pdev,
rp->rx_skbuff_dma[entry],
rp->rx_buf_sz,
PCI_DMA_FROMDEVICE);
}
skb->protocol = eth_type_trans(skb, dev);
-#ifdef CONFIG_VIA_RHINE_NAPI
netif_receive_skb(skb);
-#else
- netif_rx(skb);
-#endif
- dev->last_rx = jiffies;
rp->stats.rx_bytes += pkt_len;
rp->stats.rx_packets++;
}
struct sk_buff *skb;
entry = rp->dirty_rx % RX_RING_SIZE;
if (rp->rx_skbuff[entry] == NULL) {
- skb = dev_alloc_skb(rp->rx_buf_sz);
+ skb = netdev_alloc_skb(dev, rp->rx_buf_sz);
rp->rx_skbuff[entry] = skb;
if (skb == NULL)
break; /* Better luck next round. */
spin_lock_irq(&rp->lock);
netif_stop_queue(dev);
-#ifdef CONFIG_VIA_RHINE_NAPI
napi_disable(&rp->napi);
-#endif
if (debug > 1)
printk(KERN_DEBUG "%s: Shutting down ethercard, "
/* Make sure we use pattern 0, 1 and not 4, 5 */
if (rp->quirks & rq6patterns)
- iowrite8(0x04, ioaddr + 0xA7);
+ iowrite8(0x04, ioaddr + WOLcgClr);
if (rp->wolopts & WAKE_MAGIC) {
iowrite8(WOLmagic, ioaddr + WOLcrSet);
if (!netif_running(dev))
return 0;
-#ifdef CONFIG_VIA_RHINE_NAPI
napi_disable(&rp->napi);
-#endif
+
netif_device_detach(dev);
pci_save_state(pdev);
git://ftp.safe.ca / safe / jmp / linux-2.6 / blobdiff