#define DRV_NAME "tulip"
#ifdef CONFIG_TULIP_NAPI
-#define DRV_VERSION "1.1.14-NAPI" /* Keep at least for test */
+#define DRV_VERSION "1.1.15-NAPI" /* Keep at least for test */
#else
-#define DRV_VERSION "1.1.14"
+#define DRV_VERSION "1.1.15"
#endif
-#define DRV_RELDATE "May 11, 2002"
+#define DRV_RELDATE "Feb 27, 2007"
#include <linux/module.h>
#include <asm/unaligned.h>
#include <asm/uaccess.h>
-#ifdef __sparc__
-#include <asm/pbm.h>
+#ifdef CONFIG_SPARC
+#include <asm/prom.h>
#endif
static char version[] __devinitdata =
/* Set the copy breakpoint for the copy-only-tiny-buffer Rx structure. */
#if defined(__alpha__) || defined(__arm__) || defined(__hppa__) \
- || defined(__sparc__) || defined(__ia64__) \
+ || defined(CONFIG_SPARC) || defined(__ia64__) \
|| defined(__sh__) || defined(__mips__)
static int rx_copybreak = 1518;
#else
static int csr0 = 0x01A00000 | 0xE000;
#elif defined(__i386__) || defined(__powerpc__) || defined(__x86_64__)
static int csr0 = 0x01A00000 | 0x8000;
-#elif defined(__sparc__) || defined(__hppa__)
+#elif defined(CONFIG_SPARC) || defined(__hppa__)
/* The UltraSparc PCI controllers will disconnect at every 64-byte
* crossing anyways so it makes no sense to tell Tulip to burst
* any more than that.
struct tulip_private *tp = netdev_priv(dev);
void __iomem *ioaddr = tp->base_addr;
int next_tick = 3*HZ;
+ u32 reg;
int i;
+#ifdef CONFIG_TULIP_NAPI
+ napi_enable(&tp->napi);
+#endif
+
/* Wake the chip from sleep/snooze mode. */
tulip_set_power_state (tp, 0, 0);
/* Reset the chip, holding bit 0 set at least 50 PCI cycles. */
iowrite32(0x00000001, ioaddr + CSR0);
- pci_read_config_dword(tp->pdev, PCI_COMMAND, &i); /* flush write */
+ pci_read_config_dword(tp->pdev, PCI_COMMAND, ®); /* flush write */
udelay(100);
/* Deassert reset.
Wait the specified 50 PCI cycles after a reset by initializing
Tx and Rx queues and the address filter list. */
iowrite32(tp->csr0, ioaddr + CSR0);
- pci_read_config_dword(tp->pdev, PCI_COMMAND, &i); /* flush write */
+ pci_read_config_dword(tp->pdev, PCI_COMMAND, ®); /* flush write */
udelay(100);
if (tulip_debug > 1)
tp->dirty_rx = tp->dirty_tx = 0;
if (tp->flags & MC_HASH_ONLY) {
- u32 addr_low = le32_to_cpu(get_unaligned((u32 *)dev->dev_addr));
- u32 addr_high = le16_to_cpu(get_unaligned((u16 *)(dev->dev_addr+4)));
+ u32 addr_low = le32_to_cpu(get_unaligned((__le32 *)dev->dev_addr));
+ u32 addr_high = le16_to_cpu(get_unaligned((__le16 *)(dev->dev_addr+4)));
if (tp->chip_id == AX88140) {
iowrite32(0, ioaddr + CSR13);
iowrite32(addr_low, ioaddr + CSR14);
flush_scheduled_work();
+#ifdef CONFIG_TULIP_NAPI
+ napi_disable(&tp->napi);
+#endif
+
del_timer_sync (&tp->timer);
#ifdef CONFIG_TULIP_NAPI
del_timer_sync (&tp->oom_timer);
tp->rx_ring[i].status = 0; /* Not owned by Tulip chip. */
tp->rx_ring[i].length = 0;
- tp->rx_ring[i].buffer1 = 0xBADF00D0; /* An invalid address. */
+ /* An invalid address. */
+ tp->rx_ring[i].buffer1 = cpu_to_le32(0xBADF00D0);
if (skb) {
pci_unmap_single(tp->pdev, mapping, PKT_BUF_SZ,
PCI_DMA_FROMDEVICE);
filterbit &= 0x3f;
mc_filter[filterbit >> 5] |= 1 << (filterbit & 31);
if (tulip_debug > 2) {
- printk(KERN_INFO "%s: Added filter for %2.2x:%2.2x:%2.2x:"
- "%2.2x:%2.2x:%2.2x %8.8x bit %d.\n", dev->name,
- mclist->dmi_addr[0], mclist->dmi_addr[1],
- mclist->dmi_addr[2], mclist->dmi_addr[3],
- mclist->dmi_addr[4], mclist->dmi_addr[5],
- ether_crc(ETH_ALEN, mclist->dmi_addr), filterbit);
+ DECLARE_MAC_BUF(mac);
+ printk(KERN_INFO "%s: Added filter for %s"
+ " %8.8x bit %d.\n",
+ dev->name, print_mac(mac, mclist->dmi_addr),
+ ether_crc(ETH_ALEN, mclist->dmi_addr), filterbit);
}
}
if (mc_filter[0] == tp->mc_filter[0] &&
/* set or disable MWI in the standard PCI command bit.
* Check for the case where mwi is desired but not available
*/
- if (csr0 & MWI) pci_set_mwi(pdev);
+ if (csr0 & MWI) pci_try_set_mwi(pdev);
else pci_clear_mwi(pdev);
/* read result from hardware (in case bit refused to enable) */
};
static int last_irq;
static int multiport_cnt; /* For four-port boards w/one EEPROM */
- u8 chip_rev;
int i, irq;
unsigned short sum;
unsigned char *ee_data;
const char *chip_name = tulip_tbl[chip_idx].chip_name;
unsigned int eeprom_missing = 0;
unsigned int force_csr0 = 0;
+ DECLARE_MAC_BUF(mac);
#ifndef MODULE
static int did_version; /* Already printed version info. */
if (pdev->vendor == 0x1282 && pdev->device == 0x9100)
{
- u32 dev_rev;
/* Read Chip revision */
- pci_read_config_dword(pdev, PCI_REVISION_ID, &dev_rev);
- if(dev_rev < 0x02000030)
+ if (pdev->revision < 0x30)
{
printk(KERN_ERR PFX "skipping early DM9100 with Crc bug (use dmfe)\n");
return -ENODEV;
/* DM9102A has troubles with MRM & clear reserved bits 24:22, 20, 16, 7:1 */
if (tulip_uli_dm_quirk(pdev)) {
csr0 &= ~0x01f100ff;
-#if defined(__sparc__)
+#if defined(CONFIG_SPARC)
csr0 = (csr0 & ~0xff00) | 0xe000;
#endif
}
return -ENOMEM;
}
- SET_MODULE_OWNER(dev);
SET_NETDEV_DEV(dev, &pdev->dev);
if (pci_resource_len (pdev, 0) < tulip_tbl[chip_idx].io_size) {
printk (KERN_ERR PFX "%s: I/O region (0x%llx@0x%llx) too small, "
if (!ioaddr)
goto err_out_free_res;
- pci_read_config_byte (pdev, PCI_REVISION_ID, &chip_rev);
-
/*
* initialize private data structure 'tp'
* it is zeroed and aligned in alloc_etherdev
tp->flags = tulip_tbl[chip_idx].flags;
tp->pdev = pdev;
tp->base_addr = ioaddr;
- tp->revision = chip_rev;
+ tp->revision = pdev->revision;
tp->csr0 = csr0;
spin_lock_init(&tp->lock);
spin_lock_init(&tp->mii_lock);
tulip_mwi_config (pdev, dev);
#else
/* MWI is broken for DC21143 rev 65... */
- if (chip_idx == DC21143 && chip_rev == 65)
+ if (chip_idx == DC21143 && pdev->revision == 65)
tp->csr0 &= ~MWI;
#endif
do
value = ioread32(ioaddr + CSR9);
while (value < 0 && --boguscnt > 0);
- put_unaligned(le16_to_cpu(value), ((u16*)dev->dev_addr) + i);
+ put_unaligned(cpu_to_le16(value), ((__le16*)dev->dev_addr) + i);
sum += value & 0xffff;
}
} else if (chip_idx == COMET) {
/* No need to read the EEPROM. */
- put_unaligned(cpu_to_le32(ioread32(ioaddr + 0xA4)), (u32 *)dev->dev_addr);
- put_unaligned(cpu_to_le16(ioread32(ioaddr + 0xA8)), (u16 *)(dev->dev_addr + 4));
+ put_unaligned(cpu_to_le32(ioread32(ioaddr + 0xA4)), (__le32 *)dev->dev_addr);
+ put_unaligned(cpu_to_le16(ioread32(ioaddr + 0xA8)), (__le16 *)(dev->dev_addr + 4));
for (i = 0; i < 6; i ++)
sum += dev->dev_addr[i];
} else {
sa_offset = 2; /* Grrr, damn Matrox boards. */
multiport_cnt = 4;
}
-#ifdef CONFIG_DDB5477
- if ((pdev->bus->number == 0) && (PCI_SLOT(pdev->devfn) == 4)) {
- /* DDB5477 MAC address in first EEPROM locations. */
- sa_offset = 0;
- /* No media table either */
- tp->flags &= ~HAS_MEDIA_TABLE;
- }
-#endif
#ifdef CONFIG_MIPS_COBALT
if ((pdev->bus->number == 0) &&
((PCI_SLOT(pdev->devfn) == 7) ||
Many PCI BIOSes also incorrectly report the IRQ line, so we correct
that here as well. */
if (sum == 0 || sum == 6*0xff) {
-#if defined(__sparc__)
- struct pcidev_cookie *pcp = pdev->sysdata;
+#if defined(CONFIG_SPARC)
+ struct device_node *dp = pci_device_to_OF_node(pdev);
+ const unsigned char *addr;
+ int len;
#endif
eeprom_missing = 1;
for (i = 0; i < 5; i++)
dev->dev_addr[i] = last_phys_addr[i];
dev->dev_addr[i] = last_phys_addr[i] + 1;
-#if defined(__sparc__)
- if (pcp) {
- const unsigned char *addr;
- int len;
-
- addr = of_get_property(pcp->prom_node,
- "local-mac-address", &len);
- if (addr && len == 6)
- memcpy(dev->dev_addr, addr, 6);
- }
+#if defined(CONFIG_SPARC)
+ addr = of_get_property(dp, "local-mac-address", &len);
+ if (addr && len == 6)
+ memcpy(dev->dev_addr, addr, 6);
#endif
#if defined(__i386__) || defined(__x86_64__) /* Patch up x86 BIOS bug. */
if (last_irq)
dev->tx_timeout = tulip_tx_timeout;
dev->watchdog_timeo = TX_TIMEOUT;
#ifdef CONFIG_TULIP_NAPI
- dev->poll = tulip_poll;
- dev->weight = 16;
+ netif_napi_add(dev, &tp->napi, tulip_poll, 16);
#endif
dev->stop = tulip_close;
dev->get_stats = tulip_get_stats;
#else
"Port"
#endif
- " %#llx,", dev->name, chip_name, chip_rev,
+ " %#llx,", dev->name, chip_name, pdev->revision,
(unsigned long long) pci_resource_start(pdev, TULIP_BAR));
pci_set_drvdata(pdev, dev);
if (eeprom_missing)
printk(" EEPROM not present,");
- for (i = 0; i < 6; i++)
- printk("%c%2.2X", i ? ':' : ' ', dev->dev_addr[i]);
+ printk(" %s", print_mac(mac, dev->dev_addr));
printk(", IRQ %d.\n", irq);
if (tp->chip_id == PNIC2)
git://ftp.safe.ca / safe / jmp / linux-2.6 / blobdiff