skb_put(skb, data->rxring[rx].len);
skb->protocol = eth_type_trans(skb, dev);
netif_receive_skb(skb);
- dev->last_rx = jiffies;
}
return done;
if (num_received < budget) {
data->rxpending = 0;
- netif_rx_complete(dev, napi);
+ napi_complete(napi);
TSI_WRITE(TSI108_EC_INTMASK,
TSI_READ(TSI108_EC_INTMASK)
*
* This can happen if this code races with tsi108_poll(), which masks
* the interrupts after tsi108_irq_one() read the mask, but before
- * netif_rx_schedule is called. It could also happen due to calls
+ * napi_schedule is called. It could also happen due to calls
* from tsi108_check_rxring().
*/
- if (netif_rx_schedule_prep(dev, &data->napi)) {
+ if (napi_schedule_prep(&data->napi)) {
/* Mask, rather than ack, the receive interrupts. The ack
* will happen in tsi108_poll().
*/
| TSI108_INT_RXTHRESH |
TSI108_INT_RXOVERRUN | TSI108_INT_RXERROR |
TSI108_INT_RXWAIT);
- __netif_rx_schedule(dev, &data->napi);
+ __napi_schedule(&data->napi);
} else {
if (!netif_running(dev)) {
/* This can happen if an interrupt occurs while the
spin_lock_irqsave(&phy_lock, flags);
tsi108_write_mii(data, MII_BMCR, BMCR_RESET);
- while (i--){
+ while (--i) {
if(!(tsi108_read_mii(data, MII_BMCR) & BMCR_RESET))
break;
udelay(10);
.set_settings = tsi108_set_settings,
};
+static const struct net_device_ops tsi108_netdev_ops = {
+ .ndo_open = tsi108_open,
+ .ndo_stop = tsi108_close,
+ .ndo_start_xmit = tsi108_send_packet,
+ .ndo_set_multicast_list = tsi108_set_rx_mode,
+ .ndo_get_stats = tsi108_get_stats,
+ .ndo_do_ioctl = tsi108_do_ioctl,
+ .ndo_set_mac_address = tsi108_set_mac,
+ .ndo_validate_addr = eth_validate_addr,
+ .ndo_change_mtu = eth_change_mtu,
+};
+
static int
tsi108_init_one(struct platform_device *pdev)
{
data->phy_type = einfo->phy_type;
data->irq_num = einfo->irq_num;
data->id = pdev->id;
- dev->open = tsi108_open;
- dev->stop = tsi108_close;
- dev->hard_start_xmit = tsi108_send_packet;
- dev->set_mac_address = tsi108_set_mac;
- dev->set_multicast_list = tsi108_set_rx_mode;
- dev->get_stats = tsi108_get_stats;
netif_napi_add(dev, &data->napi, tsi108_poll, 64);
- dev->do_ioctl = tsi108_do_ioctl;
+ dev->netdev_ops = &tsi108_netdev_ops;
dev->ethtool_ops = &tsi108_ethtool_ops;
/* Apparently, the Linux networking code won't use scatter-gather