include cleanup: Update gfp.h and slab.h includes to prepare for breaking implicit...

[safe/jmp/linux-2.6] / drivers / net / spider_net.c

diff --git a/drivers/net/spider_net.c b/drivers/net/spider_net.c
index 0288054..dd3cb0f 100644 (file)
--- a/drivers/net/spider_net.c
+++ b/drivers/net/spider_net.c
@@ -31,6 +31,7 @@
 #include <linux/if_vlan.h>
 #include <linux/in.h>
 #include <linux/init.h>
+#include <linux/gfp.h>
 #include <linux/ioport.h>
 #include <linux/ip.h>
 #include <linux/kernel.h>
@@ -40,7 +41,6 @@
 #include <linux/device.h>
 #include <linux/pci.h>
 #include <linux/skbuff.h>
-#include <linux/slab.h>
 #include <linux/tcp.h>
 #include <linux/types.h>
 #include <linux/vmalloc.h>
@@ -57,6 +57,7 @@ MODULE_AUTHOR("Utz Bacher <utz.bacher@de.ibm.com> and Jens Osterkamp " \
 MODULE_DESCRIPTION("Spider Southbridge Gigabit Ethernet driver");
 MODULE_LICENSE("GPL");
 MODULE_VERSION(VERSION);
+MODULE_FIRMWARE(SPIDER_NET_FIRMWARE_NAME);
 
 static int rx_descriptors = SPIDER_NET_RX_DESCRIPTORS_DEFAULT;
 static int tx_descriptors = SPIDER_NET_TX_DESCRIPTORS_DEFAULT;
@@ -71,7 +72,7 @@ MODULE_PARM_DESC(tx_descriptors, "number of descriptors used " \
 
 char spider_net_driver_name[] = "spidernet";
 
-static struct pci_device_id spider_net_pci_tbl[] = {
+static DEFINE_PCI_DEVICE_TABLE(spider_net_pci_tbl) = {
        { PCI_VENDOR_ID_TOSHIBA_2, PCI_DEVICE_ID_TOSHIBA_SPIDER_NET,
          PCI_ANY_ID, PCI_ANY_ID, 0, 0, 0UL },
        { 0, }
@@ -409,7 +410,7 @@ spider_net_free_rx_chain_contents(struct spider_net_card *card)
  * @card: card structure
  * @descr: descriptor to re-init
  *
- * Return 0 on succes, <0 on failure.
+ * Return 0 on success, <0 on failure.
  *
  * Allocates a new rx skb, iommu-maps it and attaches it to the
  * descriptor. Mark the descriptor as activated, ready-to-use.
@@ -473,7 +474,7 @@ spider_net_prepare_rx_descr(struct spider_net_card *card,
  * spider_net_enable_rxchtails - sets RX dmac chain tail addresses
  * @card: card structure
  *
- * spider_net_enable_rxchtails sets the RX DMAC chain tail adresses in the
+ * spider_net_enable_rxchtails sets the RX DMAC chain tail addresses in the
  * chip by writing to the appropriate register. DMA is enabled in
  * spider_net_enable_rxdmac.
  */
@@ -645,7 +646,7 @@ spider_net_set_multi(struct net_device *netdev)
        hash = spider_net_get_multicast_hash(netdev, netdev->broadcast); */
        set_bit(0xfd, bitmask);
 
-       for (mc = netdev->mc_list; mc; mc = mc->next) {
+       netdev_for_each_mc_addr(mc, netdev) {
                hash = spider_net_get_multicast_hash(netdev, mc->dmi_addr);
                set_bit(hash, bitmask);
        }
@@ -1819,7 +1820,7 @@ spider_net_enable_card(struct spider_net_card *card)
 
        spider_net_write_reg(card, SPIDER_NET_ECMODE, SPIDER_NET_ECMODE_VALUE);
 
-       /* set chain tail adress for RX chains and
+       /* set chain tail address for RX chains and
         * enable DMA */
        spider_net_enable_rxchtails(card);
        spider_net_enable_rxdmac(card);
@@ -2268,6 +2269,7 @@ static const struct net_device_ops spider_net_ops = {
        .ndo_change_mtu         = spider_net_change_mtu,
        .ndo_do_ioctl           = spider_net_do_ioctl,
        .ndo_tx_timeout         = spider_net_tx_timeout,
+       .ndo_validate_addr      = eth_validate_addr,
        /* HW VLAN */
 #ifdef CONFIG_NET_POLL_CONTROLLER
        /* poll controller */