do {
msleep(1);
e2cmd = smsc9420_reg_read(pd, E2P_CMD);
- } while ((e2cmd & E2P_CMD_EPC_BUSY_) && (timeout--));
+ } while ((e2cmd & E2P_CMD_EPC_BUSY_) && (--timeout));
if (!timeout) {
smsc_info(HW, "TIMED OUT");
}
memcpy(data, &eeprom_data[eeprom->offset], len);
+ eeprom->magic = SMSC9420_EEPROM_MAGIC;
eeprom->len = len;
return 0;
}
struct smsc9420_pdata *pd = netdev_priv(dev);
int ret;
+ if (eeprom->magic != SMSC9420_EEPROM_MAGIC)
+ return -EINVAL;
+
smsc9420_eeprom_enable_access(pd);
smsc9420_eeprom_send_cmd(pd, E2P_CMD_EPC_CMD_EWEN_);
ret = smsc9420_eeprom_write_location(pd, eeprom->offset, *data);
static void smsc9420_stop_tx(struct smsc9420_pdata *pd)
{
u32 dmac_control, mac_cr, dma_intr_ena;
- int timeOut = 1000;
+ int timeout = 1000;
/* disable TX DMAC */
dmac_control = smsc9420_reg_read(pd, DMAC_CONTROL);
smsc9420_reg_write(pd, DMAC_CONTROL, dmac_control);
/* Wait max 10ms for transmit process to stop */
- while (timeOut--) {
+ while (--timeout) {
if (smsc9420_reg_read(pd, DMAC_STATUS) & DMAC_STS_TS_)
break;
udelay(10);
}
- if (!timeOut)
+ if (!timeout)
smsc_warn(IFDOWN, "TX DMAC failed to stop");
/* ACK Tx DMAC stop bit */
static void smsc9420_stop_rx(struct smsc9420_pdata *pd)
{
- int timeOut = 1000;
+ int timeout = 1000;
u32 mac_cr, dmac_control, dma_intr_ena;
/* mask RX DMAC interrupts */
smsc9420_pci_flush_write(pd);
/* wait up to 10ms for receive to stop */
- while (timeOut--) {
+ while (--timeout) {
if (smsc9420_reg_read(pd, DMAC_STATUS) & DMAC_STS_RS_)
break;
udelay(10);
}
- if (!timeOut)
+ if (!timeout)
smsc_warn(IFDOWN, "RX DMAC did not stop! timeout.");
/* ACK the Rx DMAC stop bit */
/* test the IRQ connection to the ISR */
smsc_dbg(IFUP, "Testing ISR using IRQ %d", dev->irq);
+ pd->software_irq_signal = false;
spin_lock_irqsave(&pd->int_lock, flags);
/* configure interrupt deassertion timer and enable interrupts */
smsc9420_pci_flush_write(pd);
timeout = 1000;
- pd->software_irq_signal = false;
- smp_wmb();
while (timeout--) {
if (pd->software_irq_signal)
break;
.ndo_set_multicast_list = smsc9420_set_multicast_list,
.ndo_do_ioctl = smsc9420_do_ioctl,
.ndo_validate_addr = eth_validate_addr,
+ .ndo_set_mac_address = eth_mac_addr,
#ifdef CONFIG_NET_POLL_CONTROLLER
.ndo_poll_controller = smsc9420_poll_controller,
#endif /* CONFIG_NET_POLL_CONTROLLER */