#include <linux/sched.h>
#include <linux/slab.h>
#include <linux/timer.h>
-#include <linux/version.h>
#include <linux/bug.h>
#include <linux/bitops.h>
#include <linux/irq.h>
#include <linux/io.h>
+#include <linux/swab.h>
#include <linux/phy.h>
#include <linux/smsc911x.h>
+#include <linux/device.h>
#include "smsc911x.h"
#define SMSC_CHIPNAME "smsc911x"
smsc911x_tx_writefifo(struct smsc911x_data *pdata, unsigned int *buf,
unsigned int wordcount)
{
+ if (pdata->config.flags & SMSC911X_SWAP_FIFO) {
+ while (wordcount--)
+ smsc911x_reg_write(pdata, TX_DATA_FIFO, swab32(*buf++));
+ return;
+ }
+
if (pdata->config.flags & SMSC911X_USE_32BIT) {
writesl(pdata->ioaddr + TX_DATA_FIFO, buf, wordcount);
return;
smsc911x_rx_readfifo(struct smsc911x_data *pdata, unsigned int *buf,
unsigned int wordcount)
{
+ if (pdata->config.flags & SMSC911X_SWAP_FIFO) {
+ while (wordcount--)
+ *buf++ = swab32(smsc911x_reg_read(pdata, RX_DATA_FIFO));
+ return;
+ }
+
if (pdata->config.flags & SMSC911X_USE_32BIT) {
readsl(pdata->ioaddr + RX_DATA_FIFO, buf, wordcount);
return;
goto out;
}
- SMSC_WARNING(HW, "Timed out waiting for MII write to finish");
+ SMSC_WARNING(HW, "Timed out waiting for MII read to finish");
reg = -EIO;
out:
struct net_device *dev = pdata->dev;
int npackets = 0;
- while (likely(netif_running(dev)) && (npackets < budget)) {
+ while (npackets < budget) {
unsigned int pktlength;
unsigned int pktwords;
struct sk_buff *skb;
/* Update counters */
dev->stats.rx_packets++;
dev->stats.rx_bytes += (pktlength - 4);
- dev->last_rx = jiffies;
}
/* Return total received packets */
dev_info(&dev->dev, "SMSC911x/921x identified at %#08lx, IRQ: %d\n",
(unsigned long)pdata->ioaddr, dev->irq);
+ /* Reset the last known duplex and carrier */
+ pdata->last_duplex = -1;
+ pdata->last_carrier = -1;
+
/* Bring the PHY up */
phy_start(pdata->phy_dev);
u8 address, u8 data)
{
u32 op = E2P_CMD_EPC_CMD_ERASE_ | address;
+ u32 temp;
int ret;
SMSC_TRACE(DRV, "address 0x%x, data 0x%x", address, data);
if (!ret) {
op = E2P_CMD_EPC_CMD_WRITE_ | address;
smsc911x_reg_write(pdata, E2P_DATA, (u32)data);
+
+ /* Workaround for hardware read-after-write restriction */
+ temp = smsc911x_reg_read(pdata, BYTE_TEST);
+
ret = smsc911x_eeprom_send_cmd(pdata, op);
}
.ndo_get_stats = smsc911x_get_stats,
.ndo_set_multicast_list = smsc911x_set_multicast_list,
.ndo_do_ioctl = smsc911x_do_ioctl,
+ .ndo_change_mtu = eth_change_mtu,
.ndo_validate_addr = eth_validate_addr,
.ndo_set_mac_address = smsc911x_set_mac_address,
#ifdef CONFIG_NET_POLL_CONTROLLER
if (!res)
res = platform_get_resource(pdev, IORESOURCE_MEM, 0);
- release_mem_region(res->start, res->end - res->start);
+ release_mem_region(res->start, resource_size(res));
iounmap(pdata->ioaddr);
retval = -ENODEV;
goto out_0;
}
- res_size = res->end - res->start;
+ res_size = resource_size(res);
irq_res = platform_get_resource(pdev, IORESOURCE_IRQ, 0);
if (!irq_res) {
out_free_netdev_2:
free_netdev(dev);
out_release_io_1:
- release_mem_region(res->start, res->end - res->start);
+ release_mem_region(res->start, resource_size(res));
out_0:
return retval;
}
+#ifdef CONFIG_PM
+/* This implementation assumes the devices remains powered on its VDDVARIO
+ * pins during suspend. */
+
+/* TODO: implement freeze/thaw callbacks for hibernation.*/
+
+static int smsc911x_suspend(struct device *dev)
+{
+ struct net_device *ndev = dev_get_drvdata(dev);
+ struct smsc911x_data *pdata = netdev_priv(ndev);
+
+ /* enable wake on LAN, energy detection and the external PME
+ * signal. */
+ smsc911x_reg_write(pdata, PMT_CTRL,
+ PMT_CTRL_PM_MODE_D1_ | PMT_CTRL_WOL_EN_ |
+ PMT_CTRL_ED_EN_ | PMT_CTRL_PME_EN_);
+
+ return 0;
+}
+
+static int smsc911x_resume(struct device *dev)
+{
+ struct net_device *ndev = dev_get_drvdata(dev);
+ struct smsc911x_data *pdata = netdev_priv(ndev);
+ unsigned int to = 100;
+
+ /* Note 3.11 from the datasheet:
+ * "When the LAN9220 is in a power saving state, a write of any
+ * data to the BYTE_TEST register will wake-up the device."
+ */
+ smsc911x_reg_write(pdata, BYTE_TEST, 0);
+
+ /* poll the READY bit in PMT_CTRL. Any other access to the device is
+ * forbidden while this bit isn't set. Try for 100ms and return -EIO
+ * if it failed. */
+ while (!(smsc911x_reg_read(pdata, PMT_CTRL) & PMT_CTRL_READY_) && --to)
+ udelay(1000);
+
+ return (to == 0) ? -EIO : 0;
+}
+
+static struct dev_pm_ops smsc911x_pm_ops = {
+ .suspend = smsc911x_suspend,
+ .resume = smsc911x_resume,
+};
+
+#define SMSC911X_PM_OPS (&smsc911x_pm_ops)
+
+#else
+#define SMSC911X_PM_OPS NULL
+#endif
+
static struct platform_driver smsc911x_driver = {
.probe = smsc911x_drv_probe,
- .remove = smsc911x_drv_remove,
+ .remove = __devexit_p(smsc911x_drv_remove),
.driver = {
- .name = SMSC_CHIPNAME,
+ .name = SMSC_CHIPNAME,
+ .owner = THIS_MODULE,
+ .pm = SMSC911X_PM_OPS,
},
};