#include <linux/module.h>
#include <linux/kernel.h>
#include <linux/sched.h>
-#include <linux/slab.h>
#include <linux/delay.h>
#include <linux/interrupt.h>
#include <linux/errno.h>
DBG(SMC_DEBUG_FUNC | SMC_DEBUG_RX, "%s: --> %s\n",
dev->name, __func__);
status = SMC_GET_RX_STS_FIFO(lp);
- DBG(SMC_DEBUG_RX, "%s: Rx pkt len %d status 0x%08x \n",
+ DBG(SMC_DEBUG_RX, "%s: Rx pkt len %d status 0x%08x\n",
dev->name, (status & 0x3fff0000) >> 16, status & 0xc000ffff);
pkt_len = (status & RX_STS_PKT_LEN_) >> 16;
if (status & RX_STS_ES_) {
}
#else
if (status & INT_STS_TSFL_) {
- DBG(SMC_DEBUG_TX, "%s: TX status FIFO limit (%d) irq \n", dev->name, );
+ DBG(SMC_DEBUG_TX, "%s: TX status FIFO limit (%d) irq\n", dev->name, );
smc911x_tx(dev);
SMC_ACK_INT(lp, INT_STS_TSFL_);
}
status = SMC_GET_INT(lp);
mask = SMC_GET_INT_EN(lp);
spin_unlock_irqrestore(&lp->lock, flags);
- DBG(SMC_DEBUG_MISC, "%s: INT 0x%02x MASK 0x%02x \n",
+ DBG(SMC_DEBUG_MISC, "%s: INT 0x%02x MASK 0x%02x\n",
dev->name, status, mask);
/* Dump the current TX FIFO contents and restart */
schedule_work(&lp->phy_configure);
/* We can accept TX packets again */
- dev->trans_start = jiffies;
+ dev->trans_start = jiffies; /* prevent tx timeout */
netif_wake_queue(dev);
}
* I don't need to zero the multicast table, because the flag is
* checked before the table is
*/
- else if (dev->flags & IFF_ALLMULTI || dev->mc_count > 16) {
+ else if (dev->flags & IFF_ALLMULTI || netdev_mc_count(dev) > 16) {
DBG(SMC_DEBUG_MISC, "%s: RCR_ALMUL\n", dev->name);
mcr |= MAC_CR_MCPAS_;
}
* the number of the 32 bit register, while the low 5 bits are the bit
* within that register.
*/
- else if (dev->mc_count) {
- int i;
- struct dev_mc_list *cur_addr;
+ else if (!netdev_mc_empty(dev)) {
+ struct netdev_hw_addr *ha;
/* Set the Hash perfec mode */
mcr |= MAC_CR_HPFILT_;
/* start with a table of all zeros: reject all */
memset(multicast_table, 0, sizeof(multicast_table));
- cur_addr = dev->mc_list;
- for (i = 0; i < dev->mc_count; i++, cur_addr = cur_addr->next) {
+ netdev_for_each_mc_addr(ha, dev) {
u32 position;
- /* do we have a pointer here? */
- if (!cur_addr)
- break;
/* make sure this is a multicast address -
shouldn't this be a given if we have it here ? */
- if (!(*cur_addr->dmi_addr & 1))
- continue;
+ if (!(*ha->addr & 1))
+ continue;
/* upper 6 bits are used as hash index */
- position = ether_crc(ETH_ALEN, cur_addr->dmi_addr)>>26;
+ position = ether_crc(ETH_ALEN, ha->addr)>>26;
multicast_table[position>>5] |= 1 << (position&0x1f);
}
#endif
/* Grab the IRQ */
- retval = request_irq(dev->irq, &smc911x_interrupt,
+ retval = request_irq(dev->irq, smc911x_interrupt,
irq_flags, dev->name, dev);
if (retval)
goto err_out;
"set using ifconfig\n", dev->name);
} else {
/* Print the Ethernet address */
- printk("%s: Ethernet addr: ", dev->name);
- for (i = 0; i < 5; i++)
- printk("%2.2x:", dev->dev_addr[i]);
- printk("%2.2x\n", dev->dev_addr[5]);
+ printk("%s: Ethernet addr: %pM\n",
+ dev->name, dev->dev_addr);
}
if (lp->phy_type == 0) {