/* make sure EEPROM has finished loading before setting GPIO_CFG */
timeout=1000;
- while ( timeout-- && (SMC_GET_E2P_CMD(lp) & E2P_CMD_EPC_BUSY_)) {
+ while (--timeout && (SMC_GET_E2P_CMD(lp) & E2P_CMD_EPC_BUSY_))
udelay(10);
- }
+
if (timeout == 0){
PRINTK("%s: smc911x_reset timeout waiting for EEPROM busy\n", dev->name);
return;
dev->stats.tx_dropped++;
spin_unlock_irqrestore(&lp->lock, flags);
dev_kfree_skb(skb);
- return 0;
+ return NETDEV_TX_OK;
}
#ifdef SMC_USE_DMA
lp->pending_tx_skb = skb;
netif_stop_queue(dev);
spin_unlock_irqrestore(&lp->lock, flags);
- return 0;
+ return NETDEV_TX_OK;
} else {
DBG(SMC_DEBUG_TX | SMC_DEBUG_DMA, "%s: Activating Tx DMA\n", dev->name);
lp->txdma_active = 1;
smc911x_hardware_send_pkt(dev);
spin_unlock_irqrestore(&lp->lock, flags);
- return 0;
+ return NETDEV_TX_OK;
}
/*
return probe_irq_off(cookie);
}
+static const struct net_device_ops smc911x_netdev_ops = {
+ .ndo_open = smc911x_open,
+ .ndo_stop = smc911x_close,
+ .ndo_start_xmit = smc911x_hard_start_xmit,
+ .ndo_tx_timeout = smc911x_timeout,
+ .ndo_set_multicast_list = smc911x_set_multicast_list,
+ .ndo_change_mtu = eth_change_mtu,
+ .ndo_validate_addr = eth_validate_addr,
+ .ndo_set_mac_address = eth_mac_addr,
+#ifdef CONFIG_NET_POLL_CONTROLLER
+ .ndo_poll_controller = smc911x_poll_controller,
+#endif
+};
+
/*
* Function: smc911x_probe(unsigned long ioaddr)
*
/* Fill in the fields of the device structure with ethernet values. */
ether_setup(dev);
- dev->open = smc911x_open;
- dev->stop = smc911x_close;
- dev->hard_start_xmit = smc911x_hard_start_xmit;
- dev->tx_timeout = smc911x_timeout;
+ dev->netdev_ops = &smc911x_netdev_ops;
dev->watchdog_timeo = msecs_to_jiffies(watchdog);
- dev->set_multicast_list = smc911x_set_multicast_list;
dev->ethtool_ops = &smc911x_ethtool_ops;
-#ifdef CONFIG_NET_POLL_CONTROLLER
- dev->poll_controller = smc911x_poll_controller;
-#endif
INIT_WORK(&lp->phy_configure, smc911x_phy_configure);
lp->mii.phy_id_mask = 0x1f;
#endif
/* Grab the IRQ */
- retval = request_irq(dev->irq, &smc911x_interrupt,
+ retval = request_irq(dev->irq, smc911x_interrupt,
irq_flags, dev->name, dev);
if (retval)
goto err_out;