netdev_boot_setup_check(dev);
}
- SET_MODULE_OWNER(dev);
-
irq = dev->irq;
/* EISA spec allows for up to 16 slots, but 8 is typical. */
return ERR_PTR(err);
}
+
+static const struct net_device_ops ultra32_netdev_ops = {
+ .ndo_open = ultra32_open,
+ .ndo_stop = ultra32_close,
+ .ndo_start_xmit = ei_start_xmit,
+ .ndo_tx_timeout = ei_tx_timeout,
+ .ndo_get_stats = ei_get_stats,
+ .ndo_set_multicast_list = ei_set_multicast_list,
+ .ndo_validate_addr = eth_validate_addr,
+ .ndo_set_mac_address = eth_mac_addr,
+ .ndo_change_mtu = eth_change_mtu,
+#ifdef CONFIG_NET_POLL_CONTROLLER
+ .ndo_poll_controller = ei_poll,
+#endif
+};
+
static int __init ultra32_probe1(struct net_device *dev, int ioaddr)
{
int i, edge, media, retval;
model_name = "SMC Ultra32";
- printk("%s: %s at 0x%X,", dev->name, model_name, ioaddr);
-
for (i = 0; i < 6; i++)
- printk(" %2.2X", dev->dev_addr[i] = inb(ioaddr + 8 + i));
+ dev->dev_addr[i] = inb(ioaddr + 8 + i);
+
+ printk("%s: %s at 0x%X, %pM",
+ dev->name, model_name, ioaddr, dev->dev_addr);
/* Switch from the station address to the alternate register set and
read the useful registers there. */
ei_status.block_output = &ultra32_block_output;
ei_status.get_8390_hdr = &ultra32_get_8390_hdr;
ei_status.reset_8390 = &ultra32_reset_8390;
- dev->open = &ultra32_open;
- dev->stop = &ultra32_close;
-#ifdef CONFIG_NET_POLL_CONTROLLER
- dev->poll_controller = ei_poll;
-#endif
+
+ dev->netdev_ops = &ultra32_netdev_ops;
NS8390_init(dev, 0);
return 0;
outb(0x84, ioaddr + 5); /* Enable MEM16 & Disable Bus Master. */
outb(0x01, ioaddr + 6); /* Enable Interrupts. */
if (ei_debug > 1) printk("reset done\n");
- return;
}
/* Grab the 8390 specific header. Similar to the block_input routine, but