int base_addr = dev->base_addr;
int irq = dev->irq;
-#ifdef CONFIG_NET_POLL_CONTROLLER
- dev->poll_controller = &ultra_poll;
-#endif
if (base_addr > 0x1ff) /* Check a single specified location. */
return ultra_probe1(dev, base_addr);
else if (base_addr != 0) /* Don't probe at all. */
}
#endif
+static const struct net_device_ops ultra_netdev_ops = {
+ .ndo_open = ultra_open,
+ .ndo_stop = ultra_close_card,
+
+ .ndo_start_xmit = ei_start_xmit,
+ .ndo_tx_timeout = ei_tx_timeout,
+ .ndo_get_stats = ei_get_stats,
+ .ndo_set_multicast_list = ei_set_multicast_list,
+ .ndo_validate_addr = eth_validate_addr,
+ .ndo_set_mac_address = eth_mac_addr,
+ .ndo_change_mtu = eth_change_mtu,
+#ifdef CONFIG_NET_POLL_CONTROLLER
+ .ndo_poll_controller = ultra_poll,
+#endif
+};
+
static int __init ultra_probe1(struct net_device *dev, int ioaddr)
{
int i, retval;
unsigned char num_pages, irqreg, addr, piomode;
unsigned char idreg = inb(ioaddr + 7);
unsigned char reg4 = inb(ioaddr + 4) & 0x7f;
- DECLARE_MAC_BUF(mac);
if (!request_region(ioaddr, ULTRA_IO_EXTENT, DRV_NAME))
return -EBUSY;
for (i = 0; i < 6; i++)
dev->dev_addr[i] = inb(ioaddr + 8 + i);
- printk("%s: %s at %#3x, %s", dev->name, model_name,
- ioaddr, print_mac(mac, dev->dev_addr));
+ printk("%s: %s at %#3x, %pM", dev->name, model_name,
+ ioaddr, dev->dev_addr);
/* Switch from the station address to the alternate register set and
read the useful registers there. */
ei_status.get_8390_hdr = &ultra_get_8390_hdr;
}
ei_status.reset_8390 = &ultra_reset_8390;
- dev->open = &ultra_open;
- dev->stop = &ultra_close_card;
-#ifdef CONFIG_NET_POLL_CONTROLLER
- dev->poll_controller = ei_poll;
-#endif
+
+ dev->netdev_ops = &ultra_netdev_ops;
NS8390_init(dev, 0);
retval = register_netdev(dev);
outb(0x01, cmd_port + 6); /* Enable interrupts and memory. */
if (ei_debug > 1) printk("reset done\n");
- return;
}
/* Grab the 8390 specific header. Similar to the block_input routine, but