ixgbe: Power down PHY during driver resets

[safe/jmp/linux-2.6] / drivers / net / smc-mca.c

diff --git a/drivers/net/smc-mca.c b/drivers/net/smc-mca.c
index d6abb68..a93f122 100644 (file)
--- a/drivers/net/smc-mca.c
+++ b/drivers/net/smc-mca.c
@@ -182,6 +182,23 @@ static char *smc_mca_adapter_names[] __initdata = {
 
 static int ultra_found = 0;
 
+
+static const struct net_device_ops ultramca_netdev_ops = {
+       .ndo_open               = ultramca_open,
+       .ndo_stop               = ultramca_close_card,
+
+       .ndo_start_xmit         = ei_start_xmit,
+       .ndo_tx_timeout         = ei_tx_timeout,
+       .ndo_get_stats          = ei_get_stats,
+       .ndo_set_multicast_list = ei_set_multicast_list,
+       .ndo_validate_addr      = eth_validate_addr,
+       .ndo_set_mac_address    = eth_mac_addr,
+       .ndo_change_mtu         = eth_change_mtu,
+#ifdef CONFIG_NET_POLL_CONTROLLER
+       .ndo_poll_controller    = ei_poll,
+#endif
+};
+
 static int __init ultramca_probe(struct device *gen_dev)
 {
        unsigned short ioaddr;
@@ -196,7 +213,6 @@ static int __init ultramca_probe(struct device *gen_dev)
        int tirq = 0;
        int base_addr = ultra_io[ultra_found];
        int irq = ultra_irq[ultra_found];
-       DECLARE_MAC_BUF(mac);
 
        if (base_addr || irq) {
                printk(KERN_INFO "Probing for SMC MCA adapter");
@@ -252,9 +268,9 @@ static int __init ultramca_probe(struct device *gen_dev)
                }
        }
 
-       if(!tirq || !tbase
-          || (irq && irq != tirq)
-          || (base_addr && tbase != base_addr))
+       if(!tirq || !tbase ||
+          (irq && irq != tirq) ||
+          (base_addr && tbase != base_addr))
                /* FIXME: we're trying to force the ordering of the
                 * devices here, there should be a way of getting this
                 * to happen */
@@ -334,8 +350,8 @@ static int __init ultramca_probe(struct device *gen_dev)
        for (i = 0; i < 6; i++)
                dev->dev_addr[i] = inb(ioaddr + 8 + i);
 
-       printk(KERN_INFO "smc_mca[%d]: Parameters: %#3x, %s",
-              slot + 1, ioaddr, print_mac(mac, dev->dev_addr));
+       printk(KERN_INFO "smc_mca[%d]: Parameters: %#3x, %pM",
+              slot + 1, ioaddr, dev->dev_addr);
 
        /* Switch from the station address to the alternate register set
         * and read the useful registers there.
@@ -354,7 +370,7 @@ static int __init ultramca_probe(struct device *gen_dev)
 
        outb(reg4, ioaddr + 4);
 
-       gen_dev->driver_data = dev;
+       dev_set_drvdata(gen_dev, dev);
 
        /* The 8390 isn't at the base address, so fake the offset
         */
@@ -385,11 +401,7 @@ static int __init ultramca_probe(struct device *gen_dev)
 
        ei_status.priv = slot;
 
-       dev->open = &ultramca_open;
-       dev->stop = &ultramca_close_card;
-#ifdef CONFIG_NET_POLL_CONTROLLER
-       dev->poll_controller = ei_poll;
-#endif
+       dev->netdev_ops = &ultramca_netdev_ops;
 
        NS8390_init(dev, 0);
 
@@ -519,7 +531,7 @@ static int ultramca_close_card(struct net_device *dev)
 static int ultramca_remove(struct device *gen_dev)
 {
        struct mca_device *mca_dev = to_mca_device(gen_dev);
-       struct net_device *dev = (struct net_device *)gen_dev->driver_data;
+       struct net_device *dev = dev_get_drvdata(gen_dev);
 
        if (dev) {
                /* NB: ultra_close_card() does free_irq */