* Both are almost identical and seem to be based on pci-skeleton.c
*
* Rewritten for 2.6 by Cesar Eduardo Barros
+ *
+ * A datasheet for this chip can be found at
+ * http://www.silan.com.cn/english/products/pdf/SC92031AY.pdf
*/
/* Note about set_mac_address: I don't know how to change the hardware
#include <asm/irq.h>
-#define PCI_VENDOR_ID_SILAN 0x1904
-#define PCI_DEVICE_ID_SILAN_SC92031 0x2031
-#define PCI_DEVICE_ID_SILAN_8139D 0x8139
-
#define SC92031_NAME "sc92031"
-#define SC92031_DESCRIPTION "Silan SC92031 PCI Fast Ethernet Adapter driver"
-#define SC92031_VERSION "2.0c"
/* BAR 0 is MMIO, BAR 1 is PIO */
#ifndef SC92031_USE_BAR
void __iomem *port_base = priv->port_base;
u32 mar0 = 0, mar1 = 0;
- if ((dev->flags & IFF_PROMISC)
- || dev->mc_count > multicast_filter_limit
- || (dev->flags & IFF_ALLMULTI))
+ if ((dev->flags & IFF_PROMISC) ||
+ netdev_mc_count(dev) > multicast_filter_limit ||
+ (dev->flags & IFF_ALLMULTI))
mar0 = mar1 = 0xffffffff;
else if (dev->flags & IFF_MULTICAST) {
struct dev_mc_list *mc_list;
- for (mc_list = dev->mc_list; mc_list; mc_list = mc_list->next) {
+ netdev_for_each_mc_addr(mc_list, dev) {
u32 crc;
unsigned bit = 0;
rx_ring_offset = (rx_ring_offset + 4) % RX_BUF_LEN;
- if (unlikely(rx_status == 0
- || rx_size > (MAX_ETH_FRAME_SIZE + 4)
- || rx_size < 16
- || !(rx_status & RxStatesOK))) {
+ if (unlikely(rx_status == 0 ||
+ rx_size > (MAX_ETH_FRAME_SIZE + 4) ||
+ rx_size < 16 ||
+ !(rx_status & RxStatesOK))) {
_sc92031_rx_tasklet_error(dev, rx_status, rx_size);
break;
}
rx_len -= rx_size_align + 4;
- skb = netdev_alloc_skb(dev, pkt_size + NET_IP_ALIGN);
+ skb = netdev_alloc_skb_ip_align(dev, pkt_size);
if (unlikely(!skb)) {
if (printk_ratelimit())
printk(KERN_ERR "%s: Couldn't allocate a skb_buff for a packet of size %u\n",
goto next;
}
- skb_reserve(skb, NET_IP_ALIGN);
-
if ((rx_ring_offset + pkt_size) > RX_BUF_LEN) {
memcpy(skb_put(skb, RX_BUF_LEN - rx_ring_offset),
rx_ring + rx_ring_offset, RX_BUF_LEN - rx_ring_offset);
}
skb->protocol = eth_type_trans(skb, dev);
- dev->last_rx = jiffies;
netif_rx(skb);
dev->stats.rx_bytes += pkt_size;
return &dev->stats;
}
-static int sc92031_start_xmit(struct sk_buff *skb, struct net_device *dev)
+static netdev_tx_t sc92031_start_xmit(struct sk_buff *skb,
+ struct net_device *dev)
{
struct sc92031_priv *priv = netdev_priv(dev);
void __iomem *port_base = priv->port_base;
unsigned entry;
u32 tx_status;
- if (skb_padto(skb, ETH_ZLEN))
- return NETDEV_TX_OK;
-
if (unlikely(skb->len > TX_BUF_SIZE)) {
dev->stats.tx_dropped++;
goto out;
skb_copy_and_csum_dev(skb, priv->tx_bufs + entry * TX_BUF_SIZE);
len = skb->len;
+ if (len < ETH_ZLEN) {
+ memset(priv->tx_bufs + entry * TX_BUF_SIZE + len,
+ 0, ETH_ZLEN - len);
+ len = ETH_ZLEN;
+ }
wmb();
struct pci_dev *pdev = priv->pdev;
strcpy(drvinfo->driver, SC92031_NAME);
- strcpy(drvinfo->version, SC92031_VERSION);
strcpy(drvinfo->bus_info, pci_name(pdev));
}
spin_unlock_bh(&priv->lock);
}
-static struct ethtool_ops sc92031_ethtool_ops = {
+static const struct ethtool_ops sc92031_ethtool_ops = {
.get_settings = sc92031_ethtool_get_settings,
.set_settings = sc92031_ethtool_set_settings,
.get_drvinfo = sc92031_ethtool_get_drvinfo,
.get_ethtool_stats = sc92031_ethtool_get_ethtool_stats,
};
+
+static const struct net_device_ops sc92031_netdev_ops = {
+ .ndo_get_stats = sc92031_get_stats,
+ .ndo_start_xmit = sc92031_start_xmit,
+ .ndo_open = sc92031_open,
+ .ndo_stop = sc92031_stop,
+ .ndo_set_multicast_list = sc92031_set_multicast_list,
+ .ndo_change_mtu = eth_change_mtu,
+ .ndo_validate_addr = eth_validate_addr,
+ .ndo_set_mac_address = eth_mac_addr,
+ .ndo_tx_timeout = sc92031_tx_timeout,
+#ifdef CONFIG_NET_POLL_CONTROLLER
+ .ndo_poll_controller = sc92031_poll_controller,
+#endif
+};
+
static int __devinit sc92031_probe(struct pci_dev *pdev,
const struct pci_device_id *id)
{
struct net_device *dev;
struct sc92031_priv *priv;
u32 mac0, mac1;
+ unsigned long base_addr;
err = pci_enable_device(pdev);
if (unlikely(err < 0))
pci_set_master(pdev);
- err = pci_set_dma_mask(pdev, DMA_32BIT_MASK);
+ err = pci_set_dma_mask(pdev, DMA_BIT_MASK(32));
if (unlikely(err < 0))
goto out_set_dma_mask;
- err = pci_set_consistent_dma_mask(pdev, DMA_32BIT_MASK);
+ err = pci_set_consistent_dma_mask(pdev, DMA_BIT_MASK(32));
if (unlikely(err < 0))
goto out_set_dma_mask;
/* faked with skb_copy_and_csum_dev */
dev->features = NETIF_F_SG | NETIF_F_HW_CSUM | NETIF_F_HIGHDMA;
- dev->get_stats = sc92031_get_stats;
- dev->ethtool_ops = &sc92031_ethtool_ops;
- dev->hard_start_xmit = sc92031_start_xmit;
+ dev->netdev_ops = &sc92031_netdev_ops;
dev->watchdog_timeo = TX_TIMEOUT;
- dev->open = sc92031_open;
- dev->stop = sc92031_stop;
- dev->set_multicast_list = sc92031_set_multicast_list;
- dev->tx_timeout = sc92031_tx_timeout;
-#ifdef CONFIG_NET_POLL_CONTROLLER
- dev->poll_controller = sc92031_poll_controller;
-#endif
+ dev->ethtool_ops = &sc92031_ethtool_ops;
priv = netdev_priv(dev);
spin_lock_init(&priv->lock);
if (err < 0)
goto out_register_netdev;
+#if SC92031_USE_BAR == 0
+ base_addr = dev->mem_start;
+#elif SC92031_USE_BAR == 1
+ base_addr = dev->base_addr;
+#endif
+ printk(KERN_INFO "%s: SC92031 at 0x%lx, %pM, IRQ %d\n", dev->name,
+ base_addr, dev->dev_addr, dev->irq);
+
return 0;
out_register_netdev:
return 0;
}
-static struct pci_device_id sc92031_pci_device_id_table[] __devinitdata = {
- { PCI_DEVICE(PCI_VENDOR_ID_SILAN, PCI_DEVICE_ID_SILAN_SC92031) },
- { PCI_DEVICE(PCI_VENDOR_ID_SILAN, PCI_DEVICE_ID_SILAN_8139D) },
+static DEFINE_PCI_DEVICE_TABLE(sc92031_pci_device_id_table) = {
+ { PCI_DEVICE(PCI_VENDOR_ID_SILAN, 0x2031) },
+ { PCI_DEVICE(PCI_VENDOR_ID_SILAN, 0x8139) },
+ { PCI_DEVICE(0x1088, 0x2031) },
{ 0, }
};
MODULE_DEVICE_TABLE(pci, sc92031_pci_device_id_table);
static int __init sc92031_init(void)
{
- printk(KERN_INFO SC92031_DESCRIPTION " " SC92031_VERSION "\n");
return pci_register_driver(&sc92031_pci_driver);
}
MODULE_LICENSE("GPL");
MODULE_AUTHOR("Cesar Eduardo Barros <cesarb@cesarb.net>");
-MODULE_DESCRIPTION(SC92031_DESCRIPTION);
-MODULE_VERSION(SC92031_VERSION);
+MODULE_DESCRIPTION("Silan SC92031 PCI Fast Ethernet Adapter driver");