static int rx_copybreak = 200;
static int use_dac;
+static int ignore_parity_err;
static struct {
u32 msg_enable;
} debug = { -1 };
MODULE_PARM_DESC(use_dac, "Enable PCI DAC. Unsafe on 32 bit PCI slot.");
module_param_named(debug, debug.msg_enable, int, 0);
MODULE_PARM_DESC(debug, "Debug verbosity level (0=none, ..., 16=all)");
+module_param_named(ignore_parity_err, ignore_parity_err, bool, 0);
+MODULE_PARM_DESC(ignore_parity_err, "Ignore PCI parity error as target. Default: false");
MODULE_LICENSE("GPL");
MODULE_VERSION(RTL8169_VERSION);
{
unsigned int val;
- val = (mdio_read(ioaddr, MII_BMCR) | BMCR_RESET) & 0xffff;
- mdio_write(ioaddr, MII_BMCR, val);
+ mdio_write(ioaddr, MII_BMCR, BMCR_RESET);
+ val = mdio_read(ioaddr, MII_BMCR);
}
static void rtl8169_check_link_status(struct net_device *dev,
/* Shazam ! */
if (tp->mac_version == RTL_GIGA_MAC_VER_04) {
- mdio_write(ioaddr, 31, 0x0001);
- mdio_write(ioaddr, 9, 0x273a);
- mdio_write(ioaddr, 14, 0x7bfb);
- mdio_write(ioaddr, 27, 0x841e);
-
mdio_write(ioaddr, 31, 0x0002);
mdio_write(ioaddr, 1, 0x90d0);
mdio_write(ioaddr, 31, 0x0000);
free_netdev(dev);
}
+static void rtl8169_phy_reset(struct net_device *dev,
+ struct rtl8169_private *tp)
+{
+ void __iomem *ioaddr = tp->mmio_addr;
+ int i;
+
+ tp->phy_reset_enable(ioaddr);
+ for (i = 0; i < 100; i++) {
+ if (!tp->phy_reset_pending(ioaddr))
+ return;
+ msleep(1);
+ }
+ if (netif_msg_link(tp))
+ printk(KERN_ERR "%s: PHY reset failed.\n", dev->name);
+}
+
static void rtl8169_init_phy(struct net_device *dev, struct rtl8169_private *tp)
{
void __iomem *ioaddr = tp->mmio_addr;
rtl8169_link_option(board_idx, &autoneg, &speed, &duplex);
+ rtl8169_phy_reset(dev, tp);
+
rtl8169_set_speed(dev, autoneg, speed, duplex);
if ((RTL_R8(PHYstatus) & TBI_Enable) && netif_msg_link(tp))
struct rtl8169_private *tp;
struct net_device *dev;
void __iomem *ioaddr;
- unsigned int i, pm_cap;
- int rc;
+ unsigned int pm_cap;
+ int i, rc;
if (netif_msg_drv(&debug)) {
printk(KERN_INFO "%s Gigabit Ethernet driver %s loaded\n",
RTL_R8(ChipCmd);
}
-static void
-rtl8169_hw_start(struct net_device *dev)
+static void rtl8169_set_rx_tx_config_registers(struct rtl8169_private *tp)
+{
+ void __iomem *ioaddr = tp->mmio_addr;
+ u32 cfg = rtl8169_rx_config;
+
+ cfg |= (RTL_R32(RxConfig) & rtl_chip_info[tp->chipset].RxConfigMask);
+ RTL_W32(RxConfig, cfg);
+
+ /* Set DMA burst size and Interframe Gap Time */
+ RTL_W32(TxConfig, (TX_DMA_BURST << TxDMAShift) |
+ (InterFrameGap << TxInterFrameGapShift));
+}
+
+static void rtl8169_hw_start(struct net_device *dev)
{
struct rtl8169_private *tp = netdev_priv(dev);
void __iomem *ioaddr = tp->mmio_addr;
struct pci_dev *pdev = tp->pci_dev;
+ u16 cmd;
u32 i;
/* Soft reset the chip. */
msleep_interruptible(1);
}
+ if (tp->mac_version == RTL_GIGA_MAC_VER_05) {
+ RTL_W16(CPlusCmd, RTL_R16(CPlusCmd) | PCIMulRW);
+ pci_write_config_byte(pdev, PCI_CACHE_LINE_SIZE, 0x08);
+ }
+
if (tp->mac_version == RTL_GIGA_MAC_VER_13) {
pci_write_config_word(pdev, 0x68, 0x00);
pci_write_config_word(pdev, 0x69, 0x08);
/* Undocumented stuff. */
if (tp->mac_version == RTL_GIGA_MAC_VER_05) {
- u16 cmd;
-
/* Realtek's r1000_n.c driver uses '&& 0x01' here. Well... */
if ((RTL_R8(Config2) & 0x07) & 0x01)
RTL_W32(0x7c, 0x0007ffff);
pci_write_config_word(pdev, PCI_COMMAND, cmd);
}
-
RTL_W8(Cfg9346, Cfg9346_Unlock);
+ if ((tp->mac_version == RTL_GIGA_MAC_VER_01) ||
+ (tp->mac_version == RTL_GIGA_MAC_VER_02) ||
+ (tp->mac_version == RTL_GIGA_MAC_VER_03) ||
+ (tp->mac_version == RTL_GIGA_MAC_VER_04))
+ RTL_W8(ChipCmd, CmdTxEnb | CmdRxEnb);
+
RTL_W8(EarlyTxThres, EarlyTxThld);
/* Low hurts. Let's disable the filtering. */
RTL_W16(RxMaxSize, 16383);
- /* Set Rx Config register */
- i = rtl8169_rx_config |
- (RTL_R32(RxConfig) & rtl_chip_info[tp->chipset].RxConfigMask);
- RTL_W32(RxConfig, i);
+ if ((tp->mac_version == RTL_GIGA_MAC_VER_01) ||
+ (tp->mac_version == RTL_GIGA_MAC_VER_02) ||
+ (tp->mac_version == RTL_GIGA_MAC_VER_03) ||
+ (tp->mac_version == RTL_GIGA_MAC_VER_04))
+ RTL_W8(ChipCmd, CmdTxEnb | CmdRxEnb);
+ rtl8169_set_rx_tx_config_registers(tp);
- /* Set DMA burst size and Interframe Gap Time */
- RTL_W32(TxConfig, (TX_DMA_BURST << TxDMAShift) |
- (InterFrameGap << TxInterFrameGapShift));
+ cmd = RTL_R16(CPlusCmd);
+ RTL_W16(CPlusCmd, cmd);
- tp->cp_cmd |= RTL_R16(CPlusCmd) | PCIMulRW;
+ tp->cp_cmd |= cmd | PCIMulRW;
if ((tp->mac_version == RTL_GIGA_MAC_VER_02) ||
(tp->mac_version == RTL_GIGA_MAC_VER_03)) {
RTL_W32(TxDescStartAddrLow, ((u64) tp->TxPhyAddr & DMA_32BIT_MASK));
RTL_W32(RxDescAddrHigh, ((u64) tp->RxPhyAddr >> 32));
RTL_W32(RxDescAddrLow, ((u64) tp->RxPhyAddr & DMA_32BIT_MASK));
- RTL_W8(ChipCmd, CmdTxEnb | CmdRxEnb);
+
+ if ((tp->mac_version != RTL_GIGA_MAC_VER_01) &&
+ (tp->mac_version != RTL_GIGA_MAC_VER_02) &&
+ (tp->mac_version != RTL_GIGA_MAC_VER_03) &&
+ (tp->mac_version != RTL_GIGA_MAC_VER_04)) {
+ RTL_W8(ChipCmd, CmdTxEnb | CmdRxEnb);
+ rtl8169_set_rx_tx_config_registers(tp);
+ }
+
RTL_W8(Cfg9346, Cfg9346_Lock);
/* Initially a 10 us delay. Turned it into a PCI commit. - FR */
if (!skb)
goto err_out;
- skb_reserve(skb, align);
+ skb_reserve(skb, (align - 1) & (u32)skb->data);
*sk_buff = skb;
mapping = pci_map_single(pdev, skb->data, rx_buf_sz,
/*
* The recovery sequence below admits a very elaborated explanation:
* - it seems to work;
- * - I did not see what else could be done.
+ * - I did not see what else could be done;
+ * - it makes iop3xx happy.
*
* Feel free to adjust to your needs.
*/
- pci_write_config_word(pdev, PCI_COMMAND,
- pci_cmd | PCI_COMMAND_SERR | PCI_COMMAND_PARITY);
+ if (ignore_parity_err)
+ pci_cmd &= ~PCI_COMMAND_PARITY;
+ else
+ pci_cmd |= PCI_COMMAND_SERR | PCI_COMMAND_PARITY;
+
+ pci_write_config_word(pdev, PCI_COMMAND, pci_cmd);
pci_write_config_word(pdev, PCI_STATUS,
pci_status & (PCI_STATUS_DETECTED_PARITY |
tp->cp_cmd &= ~PCIDAC;
RTL_W16(CPlusCmd, tp->cp_cmd);
dev->features &= ~NETIF_F_HIGHDMA;
- rtl8169_schedule_work(dev, rtl8169_reinit_task);
}
rtl8169_hw_reset(ioaddr);
+
+ rtl8169_schedule_work(dev, rtl8169_reinit_task);
}
static void
skb = dev_alloc_skb(pkt_size + align);
if (skb) {
- skb_reserve(skb, align);
+ skb_reserve(skb, (align - 1) & (u32)skb->data);
eth_copy_and_sum(skb, sk_buff[0]->data, pkt_size, 0);
*sk_buff = skb;
rtl8169_mark_to_asic(desc, rx_buf_sz);