#include <linux/init.h>
#include <linux/ip.h> /* for iph */
#include <linux/in.h> /* for IPPROTO_... */
-#include <linux/eeprom.h>
#include <linux/compiler.h>
#include <linux/prefetch.h>
#include <linux/ethtool.h>
#include <linux/timer.h>
#include <linux/if_vlan.h>
+#include <linux/rtnetlink.h>
+#include <linux/jiffies.h>
#include <asm/io.h>
#include <asm/uaccess.h>
u32 MEAR_cache;
u32 IMR_cache;
- struct eeprom ee;
unsigned linkstate;
static void fastcall phy_intr(struct net_device *ndev)
{
struct ns83820 *dev = PRIV(ndev);
- static char *speeds[] = { "10", "100", "1000", "1000(?)", "1000F" };
+ static const char *speeds[] = { "10", "100", "1000", "1000(?)", "1000F" };
u32 cfg, new_cfg;
u32 tbisr, tanar, tanlpar;
int speed, fullduplex, newlinkstate;
unsigned i;
for (i=0; i<3; i++) {
u32 data;
-#if 0 /* I've left this in as an example of how to use eeprom.h */
- data = eeprom_readw(&dev->ee, 0xa + 2 - i);
-#else
+
/* Read from the perfect match memory: this is loaded by
* the chip from the EEPROM via the EELOAD self test.
*/
writel(i*2, dev->base + RFCR);
data = readl(dev->base + RFDR);
-#endif
+
*mac++ = data;
*mac++ = data >> 8;
}
{
struct ns83820 *dev = PRIV(ndev);
int timed_out = 0;
- long start;
+ unsigned long start;
u32 status;
int loops = 0;
break;
if (status & fail)
break;
- if ((jiffies - start) >= HZ) {
+ if (time_after_eq(jiffies, start + HZ)) {
timed_out = 1;
break;
}
spin_lock_init(&dev->misc_lock);
dev->pci_dev = pci_dev;
- dev->ee.cache = &dev->MEAR_cache;
- dev->ee.lock = &dev->misc_lock;
SET_MODULE_OWNER(ndev);
SET_NETDEV_DEV(ndev, &pci_dev->dev);
dev->IMR_cache = 0;
- setup_ee_mem_bitbanger(&dev->ee, dev->base + MEAR, 3, 2, 1, 0,
- 0);
-
err = request_irq(pci_dev->irq, ns83820_irq, SA_SHIRQ,
DRV_NAME, ndev);
if (err) {