#include <linux/string.h>
#include <linux/errno.h>
#include <linux/ioport.h>
-#include <linux/slab.h>
#include <linux/interrupt.h>
#include <linux/delay.h>
#include <linux/init.h>
outb(MM_EN_XMT|MM_MUX, IE_MMODE); /* Start transmission */
}
+static const struct net_device_ops ni5010_netdev_ops = {
+ .ndo_open = ni5010_open,
+ .ndo_stop = ni5010_close,
+ .ndo_start_xmit = ni5010_send_packet,
+ .ndo_set_multicast_list = ni5010_set_multicast_list,
+ .ndo_tx_timeout = ni5010_timeout,
+ .ndo_validate_addr = eth_validate_addr,
+ .ndo_set_mac_address = eth_mac_addr,
+ .ndo_change_mtu = eth_change_mtu,
+};
+
/*
* This is the real probe routine. Linux has a history of friendly device
* probes on the ISA bus. A good device probes avoids doing writes, and
unsigned int data = 0;
int boguscount = 40;
int err = -ENODEV;
- DECLARE_MAC_BUF(mac);
dev->base_addr = ioaddr;
dev->irq = irq;
outw(i, IE_GP);
dev->dev_addr[i] = inb(IE_SAPROM);
}
- printk("%s ", print_mac(mac, dev->dev_addr));
+ printk("%pM ", dev->dev_addr);
PRINTK2((KERN_DEBUG "%s: I/O #4 passed!\n", dev->name));
outb(0, IE_RBUF); /* set buffer byte 0 to 0 again */
}
printk("-> bufsize rcv/xmt=%d/%d\n", bufsize_rcv, NI5010_BUFSIZE);
- memset(dev->priv, 0, sizeof(struct ni5010_local));
- dev->open = ni5010_open;
- dev->stop = ni5010_close;
- dev->hard_start_xmit = ni5010_send_packet;
- dev->set_multicast_list = ni5010_set_multicast_list;
- dev->tx_timeout = ni5010_timeout;
+ dev->netdev_ops = &ni5010_netdev_ops;
dev->watchdog_timeo = HZ/20;
dev->flags &= ~IFF_MULTICAST; /* Multicast doesn't work */
PRINTK2((KERN_DEBUG "%s: entering ni5010_open()\n", dev->name));
- if (request_irq(dev->irq, &ni5010_interrupt, 0, boardname, dev)) {
+ if (request_irq(dev->irq, ni5010_interrupt, 0, boardname, dev)) {
printk(KERN_WARNING "%s: Cannot get irq %#2x\n", dev->name, dev->irq);
return -EAGAIN;
}
/* Try to restart the adaptor. */
/* FIXME: Give it a real kick here */
chipset_init(dev, 1);
- dev->trans_start = jiffies;
+ dev->trans_start = jiffies; /* prevent tx timeout */
netif_wake_queue(dev);
}
netif_stop_queue(dev);
hardware_send_packet(dev, (unsigned char *)skb->data, skb->len, length-skb->len);
- dev->trans_start = jiffies;
dev_kfree_skb (skb);
- return 0;
+ return NETDEV_TX_OK;
}
/*
if (i % 16 == 15) printk("\n");
}
printk("\n");
-
- return;
}
/* We have a good packet, get it out of the buffer. */
static void ni5010_rx(struct net_device *dev)
{
- struct ni5010_local *lp = netdev_priv(dev);
int ioaddr = dev->base_addr;
unsigned char rcv_stat;
struct sk_buff *skb;
skb->protocol = eth_type_trans(skb,dev);
netif_rx(skb);
- dev->last_rx = jiffies;
dev->stats.rx_packets++;
dev->stats.rx_bytes += i_pkt_size;
PRINTK2((KERN_DEBUG "%s: Received packet, size=%#4.4x\n",
dev->name, i_pkt_size));
-
}
static int process_xmt_interrupt(struct net_device *dev)
PRINTK2((KERN_DEBUG "%s: entering set_multicast_list\n", dev->name));
- if (dev->flags&IFF_PROMISC || dev->flags&IFF_ALLMULTI || dev->mc_list) {
- dev->flags |= IFF_PROMISC;
+ if (dev->flags & IFF_PROMISC || dev->flags & IFF_ALLMULTI ||
+ !netdev_mc_empty(dev)) {
outb(RMD_PROMISC, EDLC_RMODE); /* Enable promiscuous mode */
PRINTK((KERN_DEBUG "%s: Entering promiscuous mode\n", dev->name));
} else {
module_exit(ni5010_cleanup_module);
#endif /* MODULE */
MODULE_LICENSE("GPL");
-
-/*
- * Local variables:
- * compile-command: "gcc -D__KERNEL__ -I/usr/src/linux/net/inet -Wall -Wstrict-prototypes -O6 -m486 -c ni5010.c"
- * version-control: t
- * kept-new-versions: 5
- * tab-width: 4
- * End:
- */