#include <linux/string.h>
#include <linux/errno.h>
#include <linux/ioport.h>
-#include <linux/slab.h>
#include <linux/interrupt.h>
#include <linux/delay.h>
#include <linux/init.h>
/* Information that needs to be kept for each board. */
struct ni5010_local {
- struct net_device_stats stats;
int o_pkt_size;
spinlock_t lock;
};
static void ni5010_rx(struct net_device *dev);
static void ni5010_timeout(struct net_device *dev);
static int ni5010_close(struct net_device *dev);
-static struct net_device_stats *ni5010_get_stats(struct net_device *dev);
static void ni5010_set_multicast_list(struct net_device *dev);
static void reset_receiver(struct net_device *dev);
PRINTK2((KERN_DEBUG "%s: Entering ni5010_probe\n", dev->name));
- SET_MODULE_OWNER(dev);
-
if (io > 0x1ff) { /* Check a single specified location. */
err = ni5010_probe1(dev, io);
} else if (io != 0) { /* Don't probe at all. */
outb(MM_EN_XMT|MM_MUX, IE_MMODE); /* Start transmission */
}
+static const struct net_device_ops ni5010_netdev_ops = {
+ .ndo_open = ni5010_open,
+ .ndo_stop = ni5010_close,
+ .ndo_start_xmit = ni5010_send_packet,
+ .ndo_set_multicast_list = ni5010_set_multicast_list,
+ .ndo_tx_timeout = ni5010_timeout,
+ .ndo_validate_addr = eth_validate_addr,
+ .ndo_set_mac_address = eth_mac_addr,
+ .ndo_change_mtu = eth_change_mtu,
+};
+
/*
* This is the real probe routine. Linux has a history of friendly device
* probes on the ISA bus. A good device probes avoids doing writes, and
for (i=0; i<6; i++) {
outw(i, IE_GP);
- printk("%2.2x ", dev->dev_addr[i] = inb(IE_SAPROM));
+ dev->dev_addr[i] = inb(IE_SAPROM);
}
+ printk("%pM ", dev->dev_addr);
PRINTK2((KERN_DEBUG "%s: I/O #4 passed!\n", dev->name));
outb(0, IE_RBUF); /* set buffer byte 0 to 0 again */
}
printk("-> bufsize rcv/xmt=%d/%d\n", bufsize_rcv, NI5010_BUFSIZE);
- memset(dev->priv, 0, sizeof(struct ni5010_local));
-
- dev->open = ni5010_open;
- dev->stop = ni5010_close;
- dev->hard_start_xmit = ni5010_send_packet;
- dev->get_stats = ni5010_get_stats;
- dev->set_multicast_list = ni5010_set_multicast_list;
- dev->tx_timeout = ni5010_timeout;
+
+ dev->netdev_ops = &ni5010_netdev_ops;
dev->watchdog_timeo = HZ/20;
dev->flags &= ~IFF_MULTICAST; /* Multicast doesn't work */
PRINTK2((KERN_DEBUG "%s: entering ni5010_open()\n", dev->name));
- if (request_irq(dev->irq, &ni5010_interrupt, 0, boardname, dev)) {
+ if (request_irq(dev->irq, ni5010_interrupt, 0, boardname, dev)) {
printk(KERN_WARNING "%s: Cannot get irq %#2x\n", dev->name, dev->irq);
return -EAGAIN;
}
hardware_send_packet(dev, (unsigned char *)skb->data, skb->len, length-skb->len);
dev->trans_start = jiffies;
dev_kfree_skb (skb);
- return 0;
+ return NETDEV_TX_OK;
}
/*
/* We have a good packet, get it out of the buffer. */
static void ni5010_rx(struct net_device *dev)
{
- struct ni5010_local *lp = netdev_priv(dev);
int ioaddr = dev->base_addr;
unsigned char rcv_stat;
struct sk_buff *skb;
if ( (rcv_stat & RS_VALID_BITS) != RS_PKT_OK) {
PRINTK((KERN_INFO "%s: receive error.\n", dev->name));
- lp->stats.rx_errors++;
- if (rcv_stat & RS_RUNT) lp->stats.rx_length_errors++;
- if (rcv_stat & RS_ALIGN) lp->stats.rx_frame_errors++;
- if (rcv_stat & RS_CRC_ERR) lp->stats.rx_crc_errors++;
- if (rcv_stat & RS_OFLW) lp->stats.rx_fifo_errors++;
+ dev->stats.rx_errors++;
+ if (rcv_stat & RS_RUNT) dev->stats.rx_length_errors++;
+ if (rcv_stat & RS_ALIGN) dev->stats.rx_frame_errors++;
+ if (rcv_stat & RS_CRC_ERR) dev->stats.rx_crc_errors++;
+ if (rcv_stat & RS_OFLW) dev->stats.rx_fifo_errors++;
outb(0xff, EDLC_RCLR); /* Clear the interrupt */
return;
}
if (i_pkt_size > ETH_FRAME_LEN || i_pkt_size < 10 ) {
PRINTK((KERN_DEBUG "%s: Packet size error, packet size = %#4.4x\n",
dev->name, i_pkt_size));
- lp->stats.rx_errors++;
- lp->stats.rx_length_errors++;
+ dev->stats.rx_errors++;
+ dev->stats.rx_length_errors++;
return;
}
skb = dev_alloc_skb(i_pkt_size + 3);
if (skb == NULL) {
printk(KERN_WARNING "%s: Memory squeeze, dropping packet.\n", dev->name);
- lp->stats.rx_dropped++;
+ dev->stats.rx_dropped++;
return;
}
skb->protocol = eth_type_trans(skb,dev);
netif_rx(skb);
- dev->last_rx = jiffies;
- lp->stats.rx_packets++;
- lp->stats.rx_bytes += i_pkt_size;
+ dev->stats.rx_packets++;
+ dev->stats.rx_bytes += i_pkt_size;
PRINTK2((KERN_DEBUG "%s: Received packet, size=%#4.4x\n",
dev->name, i_pkt_size));
-
}
static int process_xmt_interrupt(struct net_device *dev)
/* outb(0, IE_MMODE); */ /* xmt buf on sysbus FIXME: needed ? */
outb(MM_EN_XMT | MM_MUX, IE_MMODE);
outb(XM_ALL, EDLC_XMASK); /* Enable xmt IRQ's */
- lp->stats.collisions++;
+ dev->stats.collisions++;
return 1;
}
/* FIXME: handle other xmt error conditions */
- lp->stats.tx_packets++;
- lp->stats.tx_bytes += lp->o_pkt_size;
+ dev->stats.tx_packets++;
+ dev->stats.tx_bytes += lp->o_pkt_size;
netif_wake_queue(dev);
PRINTK2((KERN_DEBUG "%s: sent packet, size=%#4.4x\n",
}
-/* Get the current statistics. This may be called with the card open or
- closed. */
-static struct net_device_stats *ni5010_get_stats(struct net_device *dev)
-{
- struct ni5010_local *lp = netdev_priv(dev);
-
- PRINTK2((KERN_DEBUG "%s: entering ni5010_get_stats\n", dev->name));
-
- if (NI5010_DEBUG) ni5010_show_registers(dev);
-
- /* cli(); */
- /* Update the statistics from the device registers. */
- /* We do this in the interrupt handler */
- /* sti(); */
-
- return &lp->stats;
-}
-
/* Set or clear the multicast filter for this adaptor.
num_addrs == -1 Promiscuous mode, receive all packets
num_addrs == 0 Normal mode, clear multicast list
PRINTK2((KERN_DEBUG "%s: entering set_multicast_list\n", dev->name));
- if (dev->flags&IFF_PROMISC || dev->flags&IFF_ALLMULTI || dev->mc_list) {
- dev->flags |= IFF_PROMISC;
+ if (dev->flags & IFF_PROMISC || dev->flags & IFF_ALLMULTI ||
+ !netdev_mc_empty(dev)) {
outb(RMD_PROMISC, EDLC_RMODE); /* Enable promiscuous mode */
PRINTK((KERN_DEBUG "%s: Entering promiscuous mode\n", dev->name));
} else {
module_exit(ni5010_cleanup_module);
#endif /* MODULE */
MODULE_LICENSE("GPL");
-
-/*
- * Local variables:
- * compile-command: "gcc -D__KERNEL__ -I/usr/src/linux/net/inet -Wall -Wstrict-prototypes -O6 -m486 -c ni5010.c"
- * version-control: t
- * kept-new-versions: 5
- * tab-width: 4
- * End:
- */
git://ftp.safe.ca / safe / jmp / linux-2.6 / blobdiff