#include "8390.h"
/* These identify the driver base version and may not be removed. */
-static char version[] __devinitdata =
-KERN_INFO DRV_NAME ".c:v" DRV_VERSION " " DRV_RELDATE " D. Becker/P. Gortmaker\n"
-KERN_INFO " http://www.scyld.com/network/ne2k-pci.html\n";
+static const char version[] __devinitconst =
+ KERN_INFO DRV_NAME ".c:v" DRV_VERSION " " DRV_RELDATE
+ " D. Becker/P. Gortmaker\n";
#if defined(__powerpc__)
#define inl_le(addr) le32_to_cpu(inl(addr))
struct sk_buff *skb, int ring_offset);
static void ne2k_pci_block_output(struct net_device *dev, const int count,
const unsigned char *buf, const int start_page);
-static struct ethtool_ops ne2k_pci_ethtool_ops;
+static const struct ethtool_ops ne2k_pci_ethtool_ops;
+
-\f
/* There is no room in the standard 8390 structure for extra info we need,
so we build a meta/outer-wrapper structure.. */
in the 'dev' and 'ei_status' structures.
*/
+static const struct net_device_ops ne2k_netdev_ops = {
+ .ndo_open = ne2k_pci_open,
+ .ndo_stop = ne2k_pci_close,
+ .ndo_start_xmit = ei_start_xmit,
+ .ndo_tx_timeout = ei_tx_timeout,
+ .ndo_get_stats = ei_get_stats,
+ .ndo_set_multicast_list = ei_set_multicast_list,
+ .ndo_validate_addr = eth_validate_addr,
+ .ndo_set_mac_address = eth_mac_addr,
+ .ndo_change_mtu = eth_change_mtu,
+#ifdef CONFIG_NET_POLL_CONTROLLER
+ .ndo_poll_controller = ei_poll,
+#endif
+};
static int __devinit ne2k_pci_init_one (struct pci_dev *pdev,
const struct pci_device_id *ent)
irq = pdev->irq;
if (!ioaddr || ((pci_resource_flags (pdev, 0) & IORESOURCE_IO) == 0)) {
- printk (KERN_ERR PFX "no I/O resource at PCI BAR #0\n");
+ dev_err(&pdev->dev, "no I/O resource at PCI BAR #0\n");
return -ENODEV;
}
if (request_region (ioaddr, NE_IO_EXTENT, DRV_NAME) == NULL) {
- printk (KERN_ERR PFX "I/O resource 0x%x @ 0x%lx busy\n",
+ dev_err(&pdev->dev, "I/O resource 0x%x @ 0x%lx busy\n",
NE_IO_EXTENT, ioaddr);
return -EBUSY;
}
/* Allocate net_device, dev->priv; fill in 8390 specific dev fields. */
dev = alloc_ei_netdev();
if (!dev) {
- printk (KERN_ERR PFX "cannot allocate ethernet device\n");
+ dev_err(&pdev->dev, "cannot allocate ethernet device\n");
goto err_out_free_res;
}
- SET_MODULE_OWNER(dev);
+ dev->netdev_ops = &ne2k_netdev_ops;
+
SET_NETDEV_DEV(dev, &pdev->dev);
/* Reset card. Who knows what dain-bramaged state it was left in. */
while ((inb(ioaddr + EN0_ISR) & ENISR_RESET) == 0)
/* Limit wait: '2' avoids jiffy roll-over. */
if (jiffies - reset_start_time > 2) {
- printk(KERN_ERR PFX "Card failure (no reset ack).\n");
+ dev_err(&pdev->dev,
+ "Card failure (no reset ack).\n");
goto err_out_free_netdev;
}
{0x00, EN0_RSARHI},
{E8390_RREAD+E8390_START, E8390_CMD},
};
- for (i = 0; i < sizeof(program_seq)/sizeof(program_seq[0]); i++)
+ for (i = 0; i < ARRAY_SIZE(program_seq); i++)
outb(program_seq[i].value, ioaddr + program_seq[i].offset);
}
ei_status.block_output = &ne2k_pci_block_output;
ei_status.get_8390_hdr = &ne2k_pci_get_8390_hdr;
ei_status.priv = (unsigned long) pdev;
- dev->open = &ne2k_pci_open;
- dev->stop = &ne2k_pci_close;
+
dev->ethtool_ops = &ne2k_pci_ethtool_ops;
-#ifdef CONFIG_NET_POLL_CONTROLLER
- dev->poll_controller = ei_poll;
-#endif
NS8390_init(dev, 0);
i = register_netdev(dev);
if (i)
goto err_out_free_netdev;
- printk("%s: %s found at %#lx, IRQ %d, ",
- dev->name, pci_clone_list[chip_idx].name, ioaddr, dev->irq);
- for(i = 0; i < 6; i++) {
- printk("%2.2X%s", SA_prom[i], i == 5 ? ".\n": ":");
+ for(i = 0; i < 6; i++)
dev->dev_addr[i] = SA_prom[i];
- }
+ printk("%s: %s found at %#lx, IRQ %d, %pM.\n",
+ dev->name, pci_clone_list[chip_idx].name, ioaddr, dev->irq,
+ dev->dev_addr);
+
+ memcpy(dev->perm_addr, dev->dev_addr, dev->addr_len);
return 0;
}
-/*
+/*
* Magic incantation sequence for full duplex on the supported cards.
*/
static inline int set_realtek_fdx(struct net_device *dev)
static int ne2k_pci_set_fdx(struct net_device *dev)
{
- if (ei_status.ne2k_flags & REALTEK_FDX)
+ if (ei_status.ne2k_flags & REALTEK_FDX)
return set_realtek_fdx(dev);
else if (ei_status.ne2k_flags & HOLTEK_FDX)
return set_holtek_fdx(dev);
static int ne2k_pci_open(struct net_device *dev)
{
- int ret = request_irq(dev->irq, ei_interrupt, SA_SHIRQ, dev->name, dev);
+ int ret = request_irq(dev->irq, ei_interrupt, IRQF_SHARED, dev->name, dev);
if (ret)
return ret;
if (count & 3) {
buf += count & ~3;
if (count & 2) {
- u16 *b = (u16 *)buf;
+ __le16 *b = (__le16 *)buf;
- *b++ = le16_to_cpu(inw(NE_BASE + NE_DATAPORT));
+ *b++ = cpu_to_le16(inw(NE_BASE + NE_DATAPORT));
buf = (char *)b;
}
if (count & 1)
if (count & 3) {
buf += count & ~3;
if (count & 2) {
- u16 *b = (u16 *)buf;
+ __le16 *b = (__le16 *)buf;
- outw(cpu_to_le16(*b++), NE_BASE + NE_DATAPORT);
+ outw(le16_to_cpu(*b++), NE_BASE + NE_DATAPORT);
buf = (char *)b;
}
}
static void ne2k_pci_get_drvinfo(struct net_device *dev,
struct ethtool_drvinfo *info)
{
- struct ei_device *ei = dev->priv;
+ struct ei_device *ei = netdev_priv(dev);
struct pci_dev *pci_dev = (struct pci_dev *) ei->priv;
strcpy(info->driver, DRV_NAME);
strcpy(info->bus_info, pci_name(pci_dev));
}
-static struct ethtool_ops ne2k_pci_ethtool_ops = {
+static const struct ethtool_ops ne2k_pci_ethtool_ops = {
.get_drvinfo = ne2k_pci_get_drvinfo,
- .get_tx_csum = ethtool_op_get_tx_csum,
- .get_sg = ethtool_op_get_sg,
};
static void __devexit ne2k_pci_remove_one (struct pci_dev *pdev)
{
struct net_device *dev = pci_get_drvdata(pdev);
- if (!dev)
- BUG();
-
+ BUG_ON(!dev);
unregister_netdev(dev);
release_region(dev->base_addr, NE_IO_EXTENT);
free_netdev(dev);
netif_device_detach(dev);
pci_save_state(pdev);
+ pci_disable_device(pdev);
pci_set_power_state(pdev, pci_choose_state(pdev, state));
return 0;
static int ne2k_pci_resume (struct pci_dev *pdev)
{
struct net_device *dev = pci_get_drvdata (pdev);
+ int rc;
pci_set_power_state(pdev, 0);
pci_restore_state(pdev);
+
+ rc = pci_enable_device(pdev);
+ if (rc)
+ return rc;
+
NS8390_init(dev, 1);
netif_device_attach(dev);
#ifdef MODULE
printk(version);
#endif
- return pci_module_init (&ne2k_driver);
+ return pci_register_driver(&ne2k_driver);
}