#endif /* MODULE */
+static const struct net_device_ops mac8390_netdev_ops = {
+ .ndo_open = mac8390_open,
+ .ndo_stop = mac8390_close,
+ .ndo_start_xmit = __ei_start_xmit,
+ .ndo_tx_timeout = __ei_tx_timeout,
+ .ndo_get_stats = __ei_get_stats,
+ .ndo_set_multicast_list = __ei_set_multicast_list,
+ .ndo_validate_addr = eth_validate_addr,
+ .ndo_set_mac_address = eth_mac_addr,
+ .ndo_change_mtu = eth_change_mtu,
+#ifdef CONFIG_NET_POLL_CONTROLLER
+ .ndo_poll_controller = __ei_poll,
+#endif
+};
+
static int __init mac8390_initdev(struct net_device * dev, struct nubus_dev * ndev,
enum mac8390_type type)
{
int access_bitmode = 0;
/* Now fill in our stuff */
- dev->open = &mac8390_open;
- dev->stop = &mac8390_close;
-#ifdef CONFIG_NET_POLL_CONTROLLER
- dev->poll_controller = __ei_poll;
-#endif
+ dev->netdev_ops = &mac8390_netdev_ops;
/* GAR, ei_status is actually a macro even though it looks global */
ei_status.name = cardname[type];
/* Good, done, now spit out some messages */
printk(KERN_INFO "%s: %s in slot %X (type %s)\n",
- dev->name, ndev->board->name, ndev->board->slot, cardname[type]);
- printk(KERN_INFO "MAC ");
- {
- int i;
- for (i = 0; i < 6; i++) {
- printk("%2.2x", dev->dev_addr[i]);
- if (i < 5)
- printk(":");
- }
- }
- printk(" IRQ %d, %d KB shared memory at %#lx, %d-bit access.\n",
- dev->irq, (int)((dev->mem_end - dev->mem_start)/0x1000) * 4,
- dev->mem_start, access_bitmode?32:16);
+ dev->name, ndev->board->name, ndev->board->slot, cardname[type]);
+ printk(KERN_INFO
+ "MAC %pM IRQ %d, %d KB shared memory at %#lx, %d-bit access.\n",
+ dev->dev_addr, dev->irq,
+ (unsigned int)(dev->mem_end - dev->mem_start) >> 10,
+ dev->mem_start, access_bitmode ? 32 : 16);
return 0;
}