static int lne390_probe1(struct net_device *dev, int ioaddr);
-static int lne390_open(struct net_device *dev);
-static int lne390_close(struct net_device *dev);
-
static void lne390_reset_8390(struct net_device *dev);
static void lne390_get_8390_hdr(struct net_device *dev, struct e8390_pkt_hdr *hdr, int ring_page);
int mem_start = dev->mem_start;
int ret;
- SET_MODULE_OWNER(dev);
-
if (ioaddr > 0x1ff) { /* Check a single specified location. */
if (!request_region(ioaddr, LNE390_IO_EXTENT, DRV_NAME))
return -EBUSY;
}
revision = (eisa_id >> 24) & 0x01; /* 0 = rev A, 1 rev B */
-
+
#if 0
/* Check the Mylex vendor ID as well. Not really required. */
if (inb(ioaddr + LNE390_SA_PROM + 0) != LNE390_ADDR0
}
#endif
- printk("lne390.c: LNE390%X in EISA slot %d, address", 0xa+revision, ioaddr/0x1000);
for(i = 0; i < ETHER_ADDR_LEN; i++)
- printk(" %02x", (dev->dev_addr[i] = inb(ioaddr + LNE390_SA_PROM + i)));
- printk(".\nlne390.c: ");
+ dev->dev_addr[i] = inb(ioaddr + LNE390_SA_PROM + i);
+ printk("lne390.c: LNE390%X in EISA slot %d, address %pM.\n",
+ 0xa+revision, ioaddr/0x1000, dev->dev_addr);
+
+ printk("lne390.c: ");
/* Snarf the interrupt now. CFG file has them all listed as `edge' with share=NO */
if (dev->irq == 0) {
ei_status.block_output = &lne390_block_output;
ei_status.get_8390_hdr = &lne390_get_8390_hdr;
- dev->open = &lne390_open;
- dev->stop = &lne390_close;
-#ifdef CONFIG_NET_POLL_CONTROLLER
- dev->poll_controller = ei_poll;
-#endif
+ dev->netdev_ops = &ei_netdev_ops;
NS8390_init(dev, 0);
ret = register_netdev(dev);
hdr->count = (hdr->count + 3) & ~3; /* Round up allocation. */
}
-/*
+/*
* Block input and output are easy on shared memory ethercards, the only
* complication is when the ring buffer wraps. The count will already
* be rounded up to a doubleword value via lne390_get_8390_hdr() above.
memcpy_toio(shmem, buf, count);
}
-static int lne390_open(struct net_device *dev)
-{
- ei_open(dev);
- return 0;
-}
-
-static int lne390_close(struct net_device *dev)
-{
-
- if (ei_debug > 1)
- printk("%s: Shutting down ethercard.\n", dev->name);
-
- ei_close(dev);
- return 0;
-}
#ifdef MODULE
#define MAX_LNE_CARDS 4 /* Max number of LNE390 cards per module */
MODULE_DESCRIPTION("Mylex LNE390A/B EISA Ethernet driver");
MODULE_LICENSE("GPL");
-int init_module(void)
+int __init init_module(void)
{
struct net_device *dev;
int this_dev, found = 0;
iounmap(ei_status.mem);
}
-void cleanup_module(void)
+void __exit cleanup_module(void)
{
int this_dev;