{
unsigned long e8390_base = dev->base_addr;
struct ei_device *ei_local = (struct ei_device *) netdev_priv(dev);
- int txsr, isr, tickssofar = jiffies - dev->trans_start;
+ int txsr, isr, tickssofar = jiffies - dev_trans_start(dev);
unsigned long flags;
dev->stats.tx_errors++;
* Sends a packet to an 8390 network device.
*/
-static int __ei_start_xmit(struct sk_buff *skb, struct net_device *dev)
+static netdev_tx_t __ei_start_xmit(struct sk_buff *skb,
+ struct net_device *dev)
{
unsigned long e8390_base = dev->base_addr;
struct ei_device *ei_local = (struct ei_device *) netdev_priv(dev);
{
ei_local->txing = 1;
NS8390_trigger_send(dev, send_length, output_page);
- dev->trans_start = jiffies;
if (output_page == ei_local->tx_start_page)
{
ei_local->tx1 = -1;
dev_kfree_skb (skb);
dev->stats.tx_bytes += send_length;
- return 0;
+ return NETDEV_TX_OK;
}
/**
if (ei_local->irqlock)
{
-#if 1 /* This might just be an interrupt for a PCI device sharing this line */
- /* The "irqlock" check is only for testing. */
- printk(ei_local->irqlock
- ? "%s: Interrupted while interrupts are masked! isr=%#2x imr=%#2x.\n"
- : "%s: Reentering the interrupt handler! isr=%#2x imr=%#2x.\n",
+ /*
+ * This might just be an interrupt for a PCI device sharing
+ * this line
+ */
+ printk("%s: Interrupted while interrupts are masked!"
+ " isr=%#2x imr=%#2x.\n",
dev->name, ei_inb_p(e8390_base + EN0_ISR),
ei_inb_p(e8390_base + EN0_IMR));
-#endif
spin_unlock(&ei_local->page_lock);
return IRQ_NONE;
}
ei_inb_p(e8390_base + EN0_ISR));
/* !!Assumption!! -- we stay in page 0. Don't break this. */
- while ((interrupts = ei_inb_p(e8390_base + EN0_ISR)) != 0
- && ++nr_serviced < MAX_SERVICE)
+ while ((interrupts = ei_inb_p(e8390_base + EN0_ISR)) != 0 &&
+ ++nr_serviced < MAX_SERVICE)
{
if (!netif_running(dev)) {
printk(KERN_WARNING "%s: interrupt from stopped card\n", dev->name);
/* Check for bogosity warned by 3c503 book: the status byte is never
written. This happened a lot during testing! This code should be
cleaned up someday. */
- if (rx_frame.next != next_frame
- && rx_frame.next != next_frame + 1
- && rx_frame.next != next_frame - num_rx_pages
- && rx_frame.next != next_frame + 1 - num_rx_pages) {
+ if (rx_frame.next != next_frame &&
+ rx_frame.next != next_frame + 1 &&
+ rx_frame.next != next_frame - num_rx_pages &&
+ rx_frame.next != next_frame + 1 - num_rx_pages) {
ei_local->current_page = rxing_page;
ei_outb(ei_local->current_page-1, e8390_base+EN0_BOUNDARY);
dev->stats.rx_errors++;
/* We used to also ack ENISR_OVER here, but that would sometimes mask
a real overrun, leaving the 8390 in a stopped state with rec'vr off. */
ei_outb_p(ENISR_RX+ENISR_RX_ERR, e8390_base+EN0_ISR);
- return;
}
/**
static inline void make_mc_bits(u8 *bits, struct net_device *dev)
{
- struct dev_mc_list *dmi;
+ struct netdev_hw_addr *ha;
- for (dmi=dev->mc_list; dmi; dmi=dmi->next)
- {
- u32 crc;
- if (dmi->dmi_addrlen != ETH_ALEN)
- {
- printk(KERN_INFO "%s: invalid multicast address length given.\n", dev->name);
- continue;
- }
- crc = ether_crc(ETH_ALEN, dmi->dmi_addr);
+ netdev_for_each_mc_addr(ha, dev) {
+ u32 crc = ether_crc(ETH_ALEN, ha->addr);
/*
* The 8390 uses the 6 most significant bits of the
* CRC to index the multicast table.
if (!(dev->flags&(IFF_PROMISC|IFF_ALLMULTI)))
{
memset(ei_local->mcfilter, 0, 8);
- if (dev->mc_list)
+ if (!netdev_mc_empty(dev))
make_mc_bits(ei_local->mcfilter, dev);
}
else
if(dev->flags&IFF_PROMISC)
ei_outb_p(E8390_RXCONFIG | 0x18, e8390_base + EN0_RXCR);
- else if(dev->flags&IFF_ALLMULTI || dev->mc_list)
+ else if (dev->flags & IFF_ALLMULTI || !netdev_mc_empty(dev))
ei_outb_p(E8390_RXCONFIG | 0x08, e8390_base + EN0_RXCR);
else
ei_outb_p(E8390_RXCONFIG, e8390_base + EN0_RXCR);