static int netcard_probe1(struct net_device *dev, int ioaddr);
static int net_open(struct net_device *dev);
static int net_send_packet(struct sk_buff *skb, struct net_device *dev);
-static irqreturn_t net_interrupt(int irq, void *dev_id, struct pt_regs *regs);
+static irqreturn_t net_interrupt(int irq, void *dev_id);
static void net_rx(struct net_device *dev);
static int net_close(struct net_device *dev);
static struct net_device_stats *net_get_stats(struct net_device *dev);
int base_addr = dev->base_addr;
int irq = dev->irq;
- SET_MODULE_OWNER(dev);
-
if (base_addr > 0x1ff) /* Check a single specified location. */
return netcard_probe1(dev, base_addr);
else if (base_addr != 0) /* Don't probe at all. */
return -ENODEV;
}
-
+
static void cleanup_card(struct net_device *dev)
{
#ifdef jumpered_dma
}
#endif
+static const struct net_device_ops netcard_netdev_ops = {
+ .ndo_open = net_open,
+ .ndo_stop = net_close,
+ .ndo_start_xmit = net_send_packet,
+ .ndo_get_stats = net_get_stats,
+ .ndo_set_multicast_list = set_multicast_list,
+ .ndo_tx_timeout = net_tx_timeout,
+ .ndo_validate_addr = eth_validate_addr,
+ .ndo_set_mac_address = eth_mac_addr,
+ .ndo_change_mtu = eth_change_mtu,
+};
+
/*
* This is the real probe routine. Linux has a history of friendly device
* probes on the ISA bus. A good device probes avoids doing writes, and
return -EBUSY;
/*
- * For ethernet adaptors the first three octets of the station address
+ * For ethernet adaptors the first three octets of the station address
* contains the manufacturer's unique code. That might be a good probe
* method. Ideally you would add additional checks.
- */
- if (inb(ioaddr + 0) != SA_ADDR0
- || inb(ioaddr + 1) != SA_ADDR1
- || inb(ioaddr + 2) != SA_ADDR2)
+ */
+ if (inb(ioaddr + 0) != SA_ADDR0 ||
+ inb(ioaddr + 1) != SA_ADDR1 ||
+ inb(ioaddr + 2) != SA_ADDR2)
goto out;
if (net_debug && version_printed++ == 0)
/* Retrieve and print the ethernet address. */
for (i = 0; i < 6; i++)
- printk(" %2.2x", dev->dev_addr[i] = inb(ioaddr + i));
+ dev->dev_addr[i] = inb(ioaddr + i);
+
+ printk("%pM", dev->dev_addr);
err = -EAGAIN;
#ifdef jumpered_interrupts
dev->irq = 9;
{
- int irqval = request_irq(dev->irq, &net_interrupt, 0, cardname, dev);
+ int irqval = request_irq(dev->irq, net_interrupt, 0, cardname, dev);
if (irqval) {
printk("%s: unable to get IRQ %d (irqval=%d).\n",
dev->name, dev->irq, irqval);
if (i <= 0) {
printk("DMA probe failed.\n");
goto out1;
- }
+ }
if (request_dma(dev->dma, cardname)) {
printk("probed DMA %d allocation failed.\n", dev->dma);
goto out1;
np = netdev_priv(dev);
spin_lock_init(&np->lock);
- dev->open = net_open;
- dev->stop = net_close;
- dev->hard_start_xmit = net_send_packet;
- dev->get_stats = net_get_stats;
- dev->set_multicast_list = &set_multicast_list;
-
- dev->tx_timeout = &net_tx_timeout;
- dev->watchdog_timeo = MY_TX_TIMEOUT;
+ dev->netdev_ops = &netcard_netdev_ops;
+ dev->watchdog_timeo = MY_TX_TIMEOUT;
err = register_netdev(dev);
if (err)
* This is used if the interrupt line can turned off (shared).
* See 3c503.c for an example of selecting the IRQ at config-time.
*/
- if (request_irq(dev->irq, &net_interrupt, 0, cardname, dev)) {
+ if (request_irq(dev->irq, net_interrupt, 0, cardname, dev)) {
return -EAGAIN;
}
/*
* hardware interrupt handler. Queue flow control is
* thus managed under this lock as well.
*/
- spin_lock_irq(&np->lock);
+ unsigned long flags;
+ spin_lock_irqsave(&np->lock, flags);
add_to_tx_ring(np, skb, length);
dev->trans_start = jiffies;
* is when the transmit statistics are updated.
*/
- spin_unlock_irq(&np->lock);
+ spin_unlock_irqrestore(&np->lock, flags);
#else
/* This is the case for older hardware which takes
* a single transmit buffer at a time, and it is
dev_kfree_skb (skb);
#endif
- return 0;
+ return NETDEV_TX_OK;
}
#if TX_RING
* The typical workload of the driver:
* Handle the network interface interrupts.
*/
-static irqreturn_t net_interrupt(int irq, void *dev_id, struct pt_regs * regs)
+static irqreturn_t net_interrupt(int irq, void *dev_id)
{
struct net_device *dev = dev_id;
struct net_local *np;
do {
int status = inw(ioaddr);
int pkt_len = inw(ioaddr);
-
+
if (pkt_len == 0) /* Read all the frames? */
break; /* Done for now */
struct sk_buff *skb;
lp->stats.rx_bytes+=pkt_len;
-
+
skb = dev_alloc_skb(pkt_len);
if (skb == NULL) {
printk(KERN_NOTICE "%s: Memory squeeze, dropping packet.\n",
insw(ioaddr, skb->data, (pkt_len + 1) >> 1);
netif_rx(skb);
- dev->last_rx = jiffies;
lp->stats.rx_packets++;
lp->stats.rx_bytes += pkt_len;
}
outw(MULTICAST, ioaddr);
}
- else
+ else
outw(0, ioaddr);
}
}
#endif /* MODULE */
-
-/*
- * Local variables:
- * compile-command:
- * gcc -D__KERNEL__ -Wall -Wstrict-prototypes -Wwrite-strings
- * -Wredundant-decls -O2 -m486 -c skeleton.c
- * version-control: t
- * kept-new-versions: 5
- * tab-width: 4
- * c-indent-level: 4
- * End:
- */
git://ftp.safe.ca / safe / jmp / linux-2.6 / blobdiff