static int hp_probe1(struct net_device *dev, int ioaddr);
-static int hp_open(struct net_device *dev);
-static int hp_close(struct net_device *dev);
static void hp_reset_8390(struct net_device *dev);
static void hp_get_8390_hdr(struct net_device *dev, struct e8390_pkt_hdr *hdr,
int ring_page);
int i, retval, board_id, wordmode;
const char *name;
static unsigned version_printed;
- DECLARE_MAC_BUF(mac);
if (!request_region(ioaddr, HP_IO_EXTENT, DRV_NAME))
return -EBUSY;
for(i = 0; i < ETHER_ADDR_LEN; i++)
dev->dev_addr[i] = inb(ioaddr + i);
- printk(" %s", print_mac(mac, dev->dev_addr));
+ printk(" %pM", dev->dev_addr);
/* Snarf the interrupt now. Someday this could be moved to open(). */
if (dev->irq < 2) {
/* Set the base address to point to the NIC, not the "real" base! */
dev->base_addr = ioaddr + NIC_OFFSET;
- dev->open = &hp_open;
- dev->stop = &hp_close;
-#ifdef CONFIG_NET_POLL_CONTROLLER
- dev->poll_controller = eip_poll;
-#endif
+ dev->netdev_ops = &eip_netdev_ops;
ei_status.name = name;
ei_status.word16 = wordmode;
return retval;
}
-static int
-hp_open(struct net_device *dev)
-{
- eip_open(dev);
- return 0;
-}
-
-static int
-hp_close(struct net_device *dev)
-{
- eip_close(dev);
- return 0;
-}
-
static void
hp_reset_8390(struct net_device *dev)
{
printk("%s: hp_reset_8390() did not complete.\n", dev->name);
if (ei_debug > 1) printk("8390 reset done (%ld).", jiffies);
- return;
}
static void
dev->name, (start_page << 8) + count, addr);
}
outb_p(saved_config & (~HP_DATAON), nic_base - NIC_OFFSET + HP_CONFIGURE);
- return;
}
/* This function resets the ethercard if something screws up. */
hp_init_card(struct net_device *dev)
{
int irq = dev->irq;
- NS8390_init(dev, 0);
+ NS8390p_init(dev, 0);
outb_p(irqmap[irq&0x0f] | HP_RUN,
dev->base_addr - NIC_OFFSET + HP_CONFIGURE);
- return;
}
#ifdef MODULE