static int hp_probe1(struct net_device *dev, int ioaddr);
-static int hp_open(struct net_device *dev);
-static int hp_close(struct net_device *dev);
static void hp_reset_8390(struct net_device *dev);
static void hp_get_8390_hdr(struct net_device *dev, struct e8390_pkt_hdr *hdr,
int ring_page);
#ifndef MODULE
struct net_device * __init hp_probe(int unit)
{
- struct net_device *dev = alloc_ei_netdev();
+ struct net_device *dev = alloc_eip_netdev();
int err;
if (!dev)
printk("%s: %s (ID %02x) at %#3x,", dev->name, name, board_id, ioaddr);
for(i = 0; i < ETHER_ADDR_LEN; i++)
- printk(" %2.2x", dev->dev_addr[i] = inb(ioaddr + i));
+ dev->dev_addr[i] = inb(ioaddr + i);
+
+ printk(" %pM", dev->dev_addr);
/* Snarf the interrupt now. Someday this could be moved to open(). */
if (dev->irq < 2) {
outb_p(irqmap[irq] | HP_RUN, ioaddr + HP_CONFIGURE);
outb_p( 0x00 | HP_RUN, ioaddr + HP_CONFIGURE);
if (irq == probe_irq_off(cookie) /* It's a good IRQ line! */
- && request_irq (irq, ei_interrupt, 0, DRV_NAME, dev) == 0) {
+ && request_irq (irq, eip_interrupt, 0, DRV_NAME, dev) == 0) {
printk(" selecting IRQ %d.\n", irq);
dev->irq = *irqp;
break;
} else {
if (dev->irq == 2)
dev->irq = 9;
- if ((retval = request_irq(dev->irq, ei_interrupt, 0, DRV_NAME, dev))) {
+ if ((retval = request_irq(dev->irq, eip_interrupt, 0, DRV_NAME, dev))) {
printk (" unable to get IRQ %d.\n", dev->irq);
goto out;
}
/* Set the base address to point to the NIC, not the "real" base! */
dev->base_addr = ioaddr + NIC_OFFSET;
- dev->open = &hp_open;
- dev->stop = &hp_close;
-#ifdef CONFIG_NET_POLL_CONTROLLER
- dev->poll_controller = ei_poll;
-#endif
+ dev->netdev_ops = &eip_netdev_ops;
ei_status.name = name;
ei_status.word16 = wordmode;
return retval;
}
-static int
-hp_open(struct net_device *dev)
-{
- ei_open(dev);
- return 0;
-}
-
-static int
-hp_close(struct net_device *dev)
-{
- ei_close(dev);
- return 0;
-}
-
static void
hp_reset_8390(struct net_device *dev)
{
printk("%s: hp_reset_8390() did not complete.\n", dev->name);
if (ei_debug > 1) printk("8390 reset done (%ld).", jiffies);
- return;
}
static void
dev->name, (start_page << 8) + count, addr);
}
outb_p(saved_config & (~HP_DATAON), nic_base - NIC_OFFSET + HP_CONFIGURE);
- return;
}
/* This function resets the ethercard if something screws up. */
hp_init_card(struct net_device *dev)
{
int irq = dev->irq;
- NS8390_init(dev, 0);
+ NS8390p_init(dev, 0);
outb_p(irqmap[irq&0x0f] | HP_RUN,
dev->base_addr - NIC_OFFSET + HP_CONFIGURE);
- return;
}
#ifdef MODULE
if (this_dev != 0) break; /* only autoprobe 1st one */
printk(KERN_NOTICE "hp.c: Presently autoprobing (not recommended) for a single card.\n");
}
- dev = alloc_ei_netdev();
+ dev = alloc_eip_netdev();
if (!dev)
break;
dev->irq = irq[this_dev];