net/macvtap: fix reference counting

[safe/jmp/linux-2.6] / drivers / net / hamradio / Kconfig

diff --git a/drivers/net/hamradio/Kconfig b/drivers/net/hamradio/Kconfig
index 6e90619..62d5d5c 100644 (file)
--- a/drivers/net/hamradio/Kconfig
+++ b/drivers/net/hamradio/Kconfig
@@ -64,7 +64,7 @@ config DMASCC
          dmascc. If you don't pass any parameter to the driver, all
          possible I/O addresses are probed. This could irritate other devices
          that are currently not in use. You may specify the list of addresses
-         to be probed by "dmascc=addr1,addr2,..." (when compiled into the
+         to be probed by "dmascc.io=addr1,addr2,..." (when compiled into the
          kernel image) or "io=addr1,addr2,..." (when loaded as a module). The
          network interfaces will be called dmascc0 and dmascc1 for the board
          detected first, dmascc2 and dmascc3 for the second one, and so on.
@@ -140,7 +140,7 @@ config BAYCOM_SER_HDX
          modems that connect to a serial interface. The driver supports the
          ser12 design in half-duplex mode. This is the old driver.  It is
          still provided in case your serial interface chip does not work with
-         the full-duplex driver. This driver is depreciated.  To configure
+         the full-duplex driver. This driver is deprecated.  To configure
          the driver, use the sethdlc utility available in the standard ax25
          utilities package. For information on the modems, see
          <http://www.baycom.de/> and