vsprintf: use TOLOWER whenever possible

[safe/jmp/linux-2.6] / drivers / net / cs89x0.c

diff --git a/drivers/net/cs89x0.c b/drivers/net/cs89x0.c
index ff64976..af93216 100644 (file)
--- a/drivers/net/cs89x0.c
+++ b/drivers/net/cs89x0.c
@@ -177,13 +177,10 @@ static unsigned int cs8900_irq_map[] = {1,0,0,0};
 #elif defined(CONFIG_MACH_IXDP2351)
 static unsigned int netcard_portlist[] __used __initdata = {IXDP2351_VIRT_CS8900_BASE, 0};
 static unsigned int cs8900_irq_map[] = {IRQ_IXDP2351_CS8900, 0, 0, 0};
-#include <asm/irq.h>
 #elif defined(CONFIG_ARCH_IXDP2X01)
-#include <asm/irq.h>
 static unsigned int netcard_portlist[] __used __initdata = {IXDP2X01_CS8900_VIRT_BASE, 0};
 static unsigned int cs8900_irq_map[] = {IRQ_IXDP2X01_CS8900, 0, 0, 0};
 #elif defined(CONFIG_ARCH_PNX010X)
-#include <asm/irq.h>
 #include <mach/gpio.h>
 #define CIRRUS_DEFAULT_BASE    IO_ADDRESS(EXT_STATIC2_s0_BASE + 0x200000)      /* = Physical address 0x48200000 */
 #define CIRRUS_DEFAULT_IRQ     VH_INTC_INT_NUM_CASCADED_INTERRUPT_1 /* Event inputs bank 1 - ID 35/bit 3 */
@@ -249,7 +246,7 @@ struct net_local {
 
 static int cs89x0_probe1(struct net_device *dev, int ioaddr, int modular);
 static int net_open(struct net_device *dev);
-static int net_send_packet(struct sk_buff *skb, struct net_device *dev);
+static netdev_tx_t net_send_packet(struct sk_buff *skb, struct net_device *dev);
 static irqreturn_t net_interrupt(int irq, void *dev_id);
 static void set_multicast_list(struct net_device *dev);
 static void net_timeout(struct net_device *dev);
@@ -501,6 +498,21 @@ static void net_poll_controller(struct net_device *dev)
 }
 #endif
 
+static const struct net_device_ops net_ops = {
+       .ndo_open               = net_open,
+       .ndo_stop               = net_close,
+       .ndo_tx_timeout         = net_timeout,
+       .ndo_start_xmit         = net_send_packet,
+       .ndo_get_stats          = net_get_stats,
+       .ndo_set_multicast_list = set_multicast_list,
+       .ndo_set_mac_address    = set_mac_address,
+#ifdef CONFIG_NET_POLL_CONTROLLER
+       .ndo_poll_controller    = net_poll_controller,
+#endif
+       .ndo_change_mtu         = eth_change_mtu,
+       .ndo_validate_addr      = eth_validate_addr,
+};
+
 /* This is the real probe routine.  Linux has a history of friendly device
    probes on the ISA bus.  A good device probes avoids doing writes, and
    verifies that the correct device exists and functions.
@@ -843,17 +855,8 @@ cs89x0_probe1(struct net_device *dev, int ioaddr, int modular)
        /* print the ethernet address. */
        printk(", MAC %pM", dev->dev_addr);
 
-       dev->open               = net_open;
-       dev->stop               = net_close;
-       dev->tx_timeout         = net_timeout;
-       dev->watchdog_timeo     = HZ;
-       dev->hard_start_xmit    = net_send_packet;
-       dev->get_stats          = net_get_stats;
-       dev->set_multicast_list = set_multicast_list;
-       dev->set_mac_address    = set_mac_address;
-#ifdef CONFIG_NET_POLL_CONTROLLER
-       dev->poll_controller    = net_poll_controller;
-#endif
+       dev->netdev_ops = &net_ops;
+       dev->watchdog_timeo = HZ;
 
        printk("\n");
        if (net_debug)
@@ -1320,7 +1323,7 @@ net_open(struct net_device *dev)
                writereg(dev, PP_BusCTL, ENABLE_IRQ | MEMORY_ON);
 #endif
                write_irq(dev, lp->chip_type, dev->irq);
-               ret = request_irq(dev->irq, &net_interrupt, 0, dev->name, dev);
+               ret = request_irq(dev->irq, net_interrupt, 0, dev->name, dev);
                if (ret) {
                        if (net_debug)
                                printk(KERN_DEBUG "cs89x0: request_irq(%d) failed\n", dev->irq);
@@ -1361,7 +1364,7 @@ net_open(struct net_device *dev)
                        spin_lock_irqsave(&lp->lock, flags);
                        disable_dma(dev->dma);
                        clear_dma_ff(dev->dma);
-                       set_dma_mode(dev->dma, 0x14); /* auto_init as well */
+                       set_dma_mode(dev->dma, DMA_RX_MODE); /* auto_init as well */
                        set_dma_addr(dev->dma, isa_virt_to_bus(lp->dma_buff));
                        set_dma_count(dev->dma, lp->dmasize*1024);
                        enable_dma(dev->dma);
@@ -1515,9 +1518,10 @@ static void net_timeout(struct net_device *dev)
        netif_wake_queue(dev);
 }
 
-static int net_send_packet(struct sk_buff *skb, struct net_device *dev)
+static netdev_tx_t net_send_packet(struct sk_buff *skb,struct net_device *dev)
 {
        struct net_local *lp = netdev_priv(dev);
+       unsigned long flags;
 
        if (net_debug > 3) {
                printk("%s: sent %d byte packet of type %x\n",
@@ -1529,7 +1533,7 @@ static int net_send_packet(struct sk_buff *skb, struct net_device *dev)
                   ask the chip to start transmitting before the
                   whole packet has been completely uploaded. */
 
-       spin_lock_irq(&lp->lock);
+       spin_lock_irqsave(&lp->lock, flags);
        netif_stop_queue(dev);
 
        /* initiate a transmit sequence */
@@ -1543,13 +1547,13 @@ static int net_send_packet(struct sk_buff *skb, struct net_device *dev)
                 * we're waiting for TxOk, so return 1 and requeue this packet.
                 */
 
-               spin_unlock_irq(&lp->lock);
+               spin_unlock_irqrestore(&lp->lock, flags);
                if (net_debug) printk("cs89x0: Tx buffer not free!\n");
-               return 1;
+               return NETDEV_TX_BUSY;
        }
        /* Write the contents of the packet */
        writewords(dev->base_addr, TX_FRAME_PORT,skb->data,(skb->len+1) >>1);
-       spin_unlock_irq(&lp->lock);
+       spin_unlock_irqrestore(&lp->lock, flags);
        lp->stats.tx_bytes += skb->len;
        dev->trans_start = jiffies;
        dev_kfree_skb (skb);
@@ -1565,7 +1569,7 @@ static int net_send_packet(struct sk_buff *skb, struct net_device *dev)
         * to restart the netdevice layer
         */
 
-       return 0;
+       return NETDEV_TX_OK;
 }
 
 /* The typical workload of the driver: