#define DRV_MODULE_NAME "cassini"
#define PFX DRV_MODULE_NAME ": "
-#define DRV_MODULE_VERSION "1.4"
-#define DRV_MODULE_RELDATE "1 July 2004"
+#define DRV_MODULE_VERSION "1.6"
+#define DRV_MODULE_RELDATE "21 May 2008"
#define CAS_DEF_MSG_ENABLE \
(NETIF_MSG_DRV | \
/* free spare buffers */
INIT_LIST_HEAD(&list);
spin_lock(&cp->rx_spare_lock);
- list_splice(&cp->rx_spare_list, &list);
- INIT_LIST_HEAD(&cp->rx_spare_list);
+ list_splice_init(&cp->rx_spare_list, &list);
spin_unlock(&cp->rx_spare_lock);
list_for_each_safe(elem, tmp, &list) {
cas_page_free(cp, list_entry(elem, cas_page_t, list));
* lock than used everywhere else to manipulate this list.
*/
spin_lock(&cp->rx_inuse_lock);
- list_splice(&cp->rx_inuse_list, &list);
- INIT_LIST_HEAD(&cp->rx_inuse_list);
+ list_splice_init(&cp->rx_inuse_list, &list);
spin_unlock(&cp->rx_inuse_lock);
#else
spin_lock(&cp->rx_spare_lock);
- list_splice(&cp->rx_inuse_list, &list);
- INIT_LIST_HEAD(&cp->rx_inuse_list);
+ list_splice_init(&cp->rx_inuse_list, &list);
spin_unlock(&cp->rx_spare_lock);
#endif
list_for_each_safe(elem, tmp, &list) {
/* make a local copy of the list */
INIT_LIST_HEAD(&list);
spin_lock(&cp->rx_inuse_lock);
- list_splice(&cp->rx_inuse_list, &list);
- INIT_LIST_HEAD(&cp->rx_inuse_list);
+ list_splice_init(&cp->rx_inuse_list, &list);
spin_unlock(&cp->rx_inuse_lock);
list_for_each_safe(elem, tmp, &list) {
cas_page_t *page = list_entry(elem, cas_page_t, list);
+ /*
+ * With the lockless pagecache, cassini buffering scheme gets
+ * slightly less accurate: we might find that a page has an
+ * elevated reference count here, due to a speculative ref,
+ * and skip it as in-use. Ideally we would be able to reclaim
+ * it. However this would be such a rare case, it doesn't
+ * matter too much as we should pick it up the next time round.
+ *
+ * Importantly, if we find that the page has a refcount of 1
+ * here (our refcount), then we know it is definitely not inuse
+ * so we can reuse it.
+ */
if (page_count(page->buffer) > 1)
continue;
skb_shinfo(skb)->nr_frags++;
skb->data_len += hlen - swivel;
+ skb->truesize += hlen - swivel;
skb->len += hlen - swivel;
get_page(page->buffer);
if (addr)
cas_page_unmap(addr);
}
- skb->csum = csum_unfold(~csum);
- skb->ip_summed = CHECKSUM_COMPLETE;
skb->protocol = eth_type_trans(skb, cp->dev);
+ if (skb->protocol == htons(ETH_P_IP)) {
+ skb->csum = csum_unfold(~csum);
+ skb->ip_summed = CHECKSUM_COMPLETE;
+ } else
+ skb->ip_summed = CHECKSUM_NONE;
return len;
}
{
struct cas *cp = container_of(napi, struct cas, napi);
struct net_device *dev = cp->dev;
- int i, enable_intr, todo, credits;
+ int i, enable_intr, credits;
u32 status = readl(cp->regs + REG_INTR_STATUS);
unsigned long flags;
struct cas *cp = netdev_priv(dev);
#ifdef USE_NAPI
- napi_enable(&cp->napi);
+ napi_disable(&cp->napi);
#endif
/* Make sure we don't get distracted by suspend/resume */
mutex_lock(&cp->pm_mutex);
{"tx_fifo_errors"},
{"tx_packets"}
};
-#define CAS_NUM_STAT_KEYS (sizeof(ethtool_cassini_statnames)/ETH_GSTRING_LEN)
+#define CAS_NUM_STAT_KEYS ARRAY_SIZE(ethtool_cassini_statnames)
static struct {
const int offsets; /* neg. values for 2nd arg to cas_read_phy */
return rc;
}
+/* When this chip sits underneath an Intel 31154 bridge, it is the
+ * only subordinate device and we can tweak the bridge settings to
+ * reflect that fact.
+ */
+static void __devinit cas_program_bridge(struct pci_dev *cas_pdev)
+{
+ struct pci_dev *pdev = cas_pdev->bus->self;
+ u32 val;
+
+ if (!pdev)
+ return;
+
+ if (pdev->vendor != 0x8086 || pdev->device != 0x537c)
+ return;
+
+ /* Clear bit 10 (Bus Parking Control) in the Secondary
+ * Arbiter Control/Status Register which lives at offset
+ * 0x41. Using a 32-bit word read/modify/write at 0x40
+ * is much simpler so that's how we do this.
+ */
+ pci_read_config_dword(pdev, 0x40, &val);
+ val &= ~0x00040000;
+ pci_write_config_dword(pdev, 0x40, val);
+
+ /* Max out the Multi-Transaction Timer settings since
+ * Cassini is the only device present.
+ *
+ * The register is 16-bit and lives at 0x50. When the
+ * settings are enabled, it extends the GRANT# signal
+ * for a requestor after a transaction is complete. This
+ * allows the next request to run without first needing
+ * to negotiate the GRANT# signal back.
+ *
+ * Bits 12:10 define the grant duration:
+ *
+ * 1 -- 16 clocks
+ * 2 -- 32 clocks
+ * 3 -- 64 clocks
+ * 4 -- 128 clocks
+ * 5 -- 256 clocks
+ *
+ * All other values are illegal.
+ *
+ * Bits 09:00 define which REQ/GNT signal pairs get the
+ * GRANT# signal treatment. We set them all.
+ */
+ pci_write_config_word(pdev, 0x50, (5 << 10) | 0x3ff);
+
+ /* The Read Prefecth Policy register is 16-bit and sits at
+ * offset 0x52. It enables a "smart" pre-fetch policy. We
+ * enable it and max out all of the settings since only one
+ * device is sitting underneath and thus bandwidth sharing is
+ * not an issue.
+ *
+ * The register has several 3 bit fields, which indicates a
+ * multiplier applied to the base amount of prefetching the
+ * chip would do. These fields are at:
+ *
+ * 15:13 --- ReRead Primary Bus
+ * 12:10 --- FirstRead Primary Bus
+ * 09:07 --- ReRead Secondary Bus
+ * 06:04 --- FirstRead Secondary Bus
+ *
+ * Bits 03:00 control which REQ/GNT pairs the prefetch settings
+ * get enabled on. Bit 3 is a grouped enabler which controls
+ * all of the REQ/GNT pairs from [8:3]. Bits 2 to 0 control
+ * the individual REQ/GNT pairs [2:0].
+ */
+ pci_write_config_word(pdev, 0x52,
+ (0x7 << 13) |
+ (0x7 << 10) |
+ (0x7 << 7) |
+ (0x7 << 4) |
+ (0xf << 0));
+
+ /* Force cacheline size to 0x8 */
+ pci_write_config_byte(pdev, PCI_CACHE_LINE_SIZE, 0x08);
+
+ /* Force latency timer to maximum setting so Cassini can
+ * sit on the bus as long as it likes.
+ */
+ pci_write_config_byte(pdev, PCI_LATENCY_TIMER, 0xff);
+}
+
static int __devinit cas_init_one(struct pci_dev *pdev,
const struct pci_device_id *ent)
{
printk(KERN_WARNING PFX "Could not enable MWI for %s\n",
pci_name(pdev));
+ cas_program_bridge(pdev);
+
/*
* On some architectures, the default cache line size set
* by pci_try_set_mwi reduces perforamnce. We have to increase
/* give us access to cassini registers */
cp->regs = pci_iomap(pdev, 0, casreg_len);
- if (cp->regs == 0UL) {
+ if (!cp->regs) {
dev_err(&pdev->dev, "Cannot map device registers, aborting.\n");
goto err_out_free_res;
}
git://ftp.safe.ca / safe / jmp / linux-2.6 / blobdiff