strcpy(info->bus_info, dev_name(&dev->dev));
}
-static struct ethtool_ops bfin_mac_ethtool_ops = {
+static const struct ethtool_ops bfin_mac_ethtool_ops = {
.get_settings = bfin_mac_ethtool_getsettings,
.set_settings = bfin_mac_ethtool_setsettings,
.get_link = ethtool_op_get_link,
{
int timeout_cnt = MAX_TIMEOUT_CNT;
- if (tx_list_head->status.status_word != 0
- && current_tx_ptr != tx_list_head) {
+ if (tx_list_head->status.status_word != 0 &&
+ current_tx_ptr != tx_list_head) {
goto adjust_head; /* released something, just return; */
}
if (current_tx_ptr->next->next == tx_list_head) {
while (tx_list_head->status.status_word == 0) {
udelay(10);
- if (tx_list_head->status.status_word != 0
- || !(bfin_read_DMA2_IRQ_STATUS() & DMA_RUN)) {
+ if (tx_list_head->status.status_word != 0 ||
+ !(bfin_read_DMA2_IRQ_STATUS() & DMA_RUN)) {
goto adjust_head;
}
if (timeout_cnt-- < 0) {
": no sk_buff in a transmitted frame!\n");
}
tx_list_head = tx_list_head->next;
- } while (tx_list_head->status.status_word != 0
- && current_tx_ptr != tx_list_head);
+ } while (tx_list_head->status.status_word != 0 &&
+ current_tx_ptr != tx_list_head);
return;
}
dev->trans_start = jiffies;
dev->stats.tx_packets++;
dev->stats.tx_bytes += (skb->len);
- return 0;
+ return NETDEV_TX_OK;
}
static void bfin_mac_rx(struct net_device *dev)
return 0;
}
-static const struct net_device_ops bfin_mac_netdev_ops = {
- .ndo_open = bfin_mac_open,
- .ndo_stop = bfin_mac_close,
- .ndo_start_xmit = bfin_mac_hard_start_xmit,
- .ndo_set_mac_address = bfin_mac_set_mac_address,
- .ndo_tx_timeout = bfin_mac_timeout,
- .ndo_set_multicast_list = bfin_mac_set_multicast_list,
- .ndo_validate_addr = eth_validate_addr,
- .ndo_change_mtu = eth_change_mtu,
-#ifdef CONFIG_NET_POLL_CONTROLLER
- .ndo_poll_controller = bfin_mac_poll,
-#endif
-};
-
/*
- *
* this makes the board clean up everything that it can
* and not talk to the outside world. Caused by
* an 'ifconfig ethX down'
return 0;
}
+static const struct net_device_ops bfin_mac_netdev_ops = {
+ .ndo_open = bfin_mac_open,
+ .ndo_stop = bfin_mac_close,
+ .ndo_start_xmit = bfin_mac_hard_start_xmit,
+ .ndo_set_mac_address = bfin_mac_set_mac_address,
+ .ndo_tx_timeout = bfin_mac_timeout,
+ .ndo_set_multicast_list = bfin_mac_set_multicast_list,
+ .ndo_validate_addr = eth_validate_addr,
+ .ndo_change_mtu = eth_change_mtu,
+#ifdef CONFIG_NET_POLL_CONTROLLER
+ .ndo_poll_controller = bfin_mac_poll,
+#endif
+};
+
static int __devinit bfin_mac_probe(struct platform_device *pdev)
{
struct net_device *ndev;
struct bfin_mac_local *lp;
- int rc, i;
+ struct platform_device *pd;
+ int rc;
ndev = alloc_etherdev(sizeof(struct bfin_mac_local));
if (!ndev) {
goto out_err_probe_mac;
}
- /* set the GPIO pins to Ethernet mode */
- rc = peripheral_request_list(pin_req, DRV_NAME);
- if (rc) {
- dev_err(&pdev->dev, "Requesting peripherals failed!\n");
- rc = -EFAULT;
- goto out_err_setup_pin_mux;
- }
/*
* Is it valid? (Did bootloader initialize it?)
setup_mac_addr(ndev->dev_addr);
- /* MDIO bus initial */
- lp->mii_bus = mdiobus_alloc();
- if (lp->mii_bus == NULL)
- goto out_err_mdiobus_alloc;
-
- lp->mii_bus->priv = ndev;
- lp->mii_bus->read = bfin_mdiobus_read;
- lp->mii_bus->write = bfin_mdiobus_write;
- lp->mii_bus->reset = bfin_mdiobus_reset;
- lp->mii_bus->name = "bfin_mac_mdio";
- snprintf(lp->mii_bus->id, MII_BUS_ID_SIZE, "0");
- lp->mii_bus->irq = kmalloc(sizeof(int)*PHY_MAX_ADDR, GFP_KERNEL);
- for (i = 0; i < PHY_MAX_ADDR; ++i)
- lp->mii_bus->irq[i] = PHY_POLL;
-
- rc = mdiobus_register(lp->mii_bus);
- if (rc) {
- dev_err(&pdev->dev, "Cannot register MDIO bus!\n");
- goto out_err_mdiobus_register;
+ if (!pdev->dev.platform_data) {
+ dev_err(&pdev->dev, "Cannot get platform device bfin_mii_bus!\n");
+ rc = -ENODEV;
+ goto out_err_probe_mac;
}
+ pd = pdev->dev.platform_data;
+ lp->mii_bus = platform_get_drvdata(pd);
+ lp->mii_bus->priv = ndev;
rc = mii_probe(ndev);
if (rc) {
out_err_request_irq:
out_err_mii_probe:
mdiobus_unregister(lp->mii_bus);
-out_err_mdiobus_register:
mdiobus_free(lp->mii_bus);
-out_err_mdiobus_alloc:
peripheral_free_list(pin_req);
-out_err_setup_pin_mux:
out_err_probe_mac:
platform_set_drvdata(pdev, NULL);
free_netdev(ndev);
platform_set_drvdata(pdev, NULL);
- mdiobus_unregister(lp->mii_bus);
- mdiobus_free(lp->mii_bus);
+ lp->mii_bus->priv = NULL;
unregister_netdev(ndev);
#define bfin_mac_resume NULL
#endif /* CONFIG_PM */
+static int __devinit bfin_mii_bus_probe(struct platform_device *pdev)
+{
+ struct mii_bus *miibus;
+ int rc, i;
+
+ /*
+ * We are setting up a network card,
+ * so set the GPIO pins to Ethernet mode
+ */
+ rc = peripheral_request_list(pin_req, DRV_NAME);
+ if (rc) {
+ dev_err(&pdev->dev, "Requesting peripherals failed!\n");
+ return rc;
+ }
+
+ rc = -ENOMEM;
+ miibus = mdiobus_alloc();
+ if (miibus == NULL)
+ goto out_err_alloc;
+ miibus->read = bfin_mdiobus_read;
+ miibus->write = bfin_mdiobus_write;
+ miibus->reset = bfin_mdiobus_reset;
+
+ miibus->parent = &pdev->dev;
+ miibus->name = "bfin_mii_bus";
+ snprintf(miibus->id, MII_BUS_ID_SIZE, "0");
+ miibus->irq = kmalloc(sizeof(int)*PHY_MAX_ADDR, GFP_KERNEL);
+ if (miibus->irq == NULL)
+ goto out_err_alloc;
+ for (i = 0; i < PHY_MAX_ADDR; ++i)
+ miibus->irq[i] = PHY_POLL;
+
+ rc = mdiobus_register(miibus);
+ if (rc) {
+ dev_err(&pdev->dev, "Cannot register MDIO bus!\n");
+ goto out_err_mdiobus_register;
+ }
+
+ platform_set_drvdata(pdev, miibus);
+ return 0;
+
+out_err_mdiobus_register:
+ mdiobus_free(miibus);
+out_err_alloc:
+ peripheral_free_list(pin_req);
+
+ return rc;
+}
+
+static int __devexit bfin_mii_bus_remove(struct platform_device *pdev)
+{
+ struct mii_bus *miibus = platform_get_drvdata(pdev);
+ platform_set_drvdata(pdev, NULL);
+ mdiobus_unregister(miibus);
+ mdiobus_free(miibus);
+ peripheral_free_list(pin_req);
+ return 0;
+}
+
+static struct platform_driver bfin_mii_bus_driver = {
+ .probe = bfin_mii_bus_probe,
+ .remove = __devexit_p(bfin_mii_bus_remove),
+ .driver = {
+ .name = "bfin_mii_bus",
+ .owner = THIS_MODULE,
+ },
+};
+
static struct platform_driver bfin_mac_driver = {
.probe = bfin_mac_probe,
.remove = __devexit_p(bfin_mac_remove),
static int __init bfin_mac_init(void)
{
- return platform_driver_register(&bfin_mac_driver);
+ int ret;
+ ret = platform_driver_register(&bfin_mii_bus_driver);
+ if (!ret)
+ return platform_driver_register(&bfin_mac_driver);
+ return -ENODEV;
}
module_init(bfin_mac_init);
static void __exit bfin_mac_cleanup(void)
{
platform_driver_unregister(&bfin_mac_driver);
+ platform_driver_unregister(&bfin_mii_bus_driver);
}
module_exit(bfin_mac_cleanup);
git://ftp.safe.ca / safe / jmp / linux-2.6 / blobdiff