struct net_device * __init apne_probe(int unit);
static int apne_probe1(struct net_device *dev, int ioaddr);
-static int apne_open(struct net_device *dev);
-static int apne_close(struct net_device *dev);
-
static void apne_reset_8390(struct net_device *dev);
static void apne_get_8390_hdr(struct net_device *dev, struct e8390_pkt_hdr *hdr,
int ring_page);
#endif
int err;
+ if (!MACH_IS_AMIGA)
+ return ERR_PTR(-ENODEV);
+
if (apne_owned)
return ERR_PTR(-ENODEV);
sprintf(dev->name, "eth%d", unit);
netdev_boot_setup_check(dev);
}
- SET_MODULE_OWNER(dev);
/* disable pcmcia irq for readtuple */
pcmcia_disable_irq();
{0x00, NE_EN0_RSARHI},
{E8390_RREAD+E8390_START, NE_CMD},
};
- for (i = 0; i < sizeof(program_seq)/sizeof(program_seq[0]); i++) {
+ for (i = 0; i < ARRAY_SIZE(program_seq); i++) {
outb(program_seq[i].value, ioaddr + program_seq[i].offset);
}
#endif
dev->base_addr = ioaddr;
+ dev->irq = IRQ_AMIGA_PORTS;
+ dev->netdev_ops = &ei_netdev_ops;
/* Install the Interrupt handler */
- i = request_irq(IRQ_AMIGA_PORTS, apne_interrupt, IRQF_SHARED, DRV_NAME, dev);
+ i = request_irq(dev->irq, apne_interrupt, IRQF_SHARED, DRV_NAME, dev);
if (i) return i;
- for(i = 0; i < ETHER_ADDR_LEN; i++) {
- printk(" %2.2x", SA_prom[i]);
+ for(i = 0; i < ETHER_ADDR_LEN; i++)
dev->dev_addr[i] = SA_prom[i];
- }
- printk("\n%s: %s found.\n", dev->name, name);
+ printk(" %pM\n", dev->dev_addr);
+
+ printk("%s: %s found.\n", dev->name, name);
ei_status.name = name;
ei_status.tx_start_page = start_page;
ei_status.block_input = &apne_block_input;
ei_status.block_output = &apne_block_output;
ei_status.get_8390_hdr = &apne_get_8390_hdr;
- dev->open = &apne_open;
- dev->stop = &apne_close;
-#ifdef CONFIG_NET_POLL_CONTROLLER
- dev->poll_controller = ei_poll;
-#endif
+
NS8390_init(dev, 0);
pcmcia_ack_int(pcmcia_get_intreq()); /* ack PCMCIA int req */
return 0;
}
-static int
-apne_open(struct net_device *dev)
-{
- ei_open(dev);
- return 0;
-}
-
-static int
-apne_close(struct net_device *dev)
-{
- if (ei_debug > 1)
- printk("%s: Shutting down ethercard.\n", dev->name);
- ei_close(dev);
- return 0;
-}
-
/* Hard reset the card. This used to pause for the same period that a
8390 reset command required, but that shouldn't be necessary. */
static void
outb(ENISR_RDC, nic_base + NE_EN0_ISR); /* Ack intr. */
ei_status.dmaing &= ~0x01;
- return;
}
static irqreturn_t apne_interrupt(int irq, void *dev_id)
#ifdef MODULE
static struct net_device *apne_dev;
-int __init init_module(void)
+static int __init apne_module_init(void)
{
apne_dev = apne_probe(-1);
if (IS_ERR(apne_dev))
return 0;
}
-void __exit cleanup_module(void)
+static void __exit apne_module_exit(void)
{
unregister_netdev(apne_dev);
free_netdev(apne_dev);
}
-
+module_init(apne_module_init);
+module_exit(apne_module_exit);
#endif
static int init_pcmcia(void)