}
#endif
+static const struct net_device_ops ac_netdev_ops = {
+ .ndo_open = ac_open,
+ .ndo_stop = ac_close_card,
+
+ .ndo_start_xmit = ei_start_xmit,
+ .ndo_tx_timeout = ei_tx_timeout,
+ .ndo_get_stats = ei_get_stats,
+ .ndo_set_multicast_list = ei_set_multicast_list,
+ .ndo_validate_addr = eth_validate_addr,
+ .ndo_set_mac_address = eth_mac_addr,
+ .ndo_change_mtu = eth_change_mtu,
+#ifdef CONFIG_NET_POLL_CONTROLLER
+ .ndo_poll_controller = ei_poll,
+#endif
+};
+
static int __init ac_probe1(int ioaddr, struct net_device *dev)
{
int i, retval;
inb(ioaddr + AC_ID_PORT + 2), inb(ioaddr + AC_ID_PORT + 3));
#endif
- printk("AC3200 in EISA slot %d, node", ioaddr/0x1000);
- for(i = 0; i < 6; i++)
- printk(" %02x", dev->dev_addr[i] = inb(ioaddr + AC_SA_PROM + i));
+ for (i = 0; i < 6; i++)
+ dev->dev_addr[i] = inb(ioaddr + AC_SA_PROM + i);
+ printk(KERN_DEBUG "AC3200 in EISA slot %d, node %pM",
+ ioaddr/0x1000, dev->dev_addr);
#if 0
/* Check the vendor ID/prefix. Redundant after checking the EISA ID */
if (inb(ioaddr + AC_SA_PROM + 0) != AC_ADDR0
ei_status.block_output = &ac_block_output;
ei_status.get_8390_hdr = &ac_get_8390_hdr;
- dev->open = &ac_open;
- dev->stop = &ac_close_card;
-#ifdef CONFIG_NET_POLL_CONTROLLER
- dev->poll_controller = ei_poll;
-#endif
+ dev->netdev_ops = &ac_netdev_ops;
NS8390_init(dev, 0);
retval = register_netdev(dev);
MODULE_DESCRIPTION("Ansel AC3200 EISA ethernet driver");
MODULE_LICENSE("GPL");
-int __init init_module(void)
+static int __init ac3200_module_init(void)
{
struct net_device *dev;
int this_dev, found = 0;
iounmap(ei_status.mem);
}
-void __exit
-cleanup_module(void)
+static void __exit ac3200_module_exit(void)
{
int this_dev;
}
}
}
+module_init(ac3200_module_init);
+module_exit(ac3200_module_exit);
#endif /* MODULE */