headers: remove sched.h from interrupt.h

[safe/jmp/linux-2.6] / drivers / message / fusion / mptscsih.h

diff --git a/drivers/message/fusion/mptscsih.h b/drivers/message/fusion/mptscsih.h
index debb8ac..e0b33e0 100644 (file)
--- a/drivers/message/fusion/mptscsih.h
+++ b/drivers/message/fusion/mptscsih.h
@@ -1,12 +1,12 @@
 /*
- *  linux/drivers/message/fusion/mptscsi.h
+ *  linux/drivers/message/fusion/mptscsih.h
  *      High performance SCSI / Fibre Channel SCSI Host device driver.
  *      For use with PCI chip/adapter(s):
  *          LSIFC9xx/LSI409xx Fibre Channel
- *      running LSI Logic Fusion MPT (Message Passing Technology) firmware.
+ *      running LSI Fusion MPT (Message Passing Technology) firmware.
  *
- *  Copyright (c) 1999-2005 LSI Logic Corporation
- *  (mailto:mpt_linux_developer@lsil.com)
+ *  Copyright (c) 1999-2008 LSI Corporation
+ *  (mailto:DL-MPTFusionLinux@lsi.com)
  *
  */
 /*=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=*/
@@ -53,22 +53,31 @@
  *     SCSI Public stuff...
  */
 
-#define MPT_SCSI_CMD_PER_DEV_HIGH      31
-#define MPT_SCSI_CMD_PER_DEV_LOW       7
+#define MPT_SCANDV_GOOD                        (0x00000000) /* must be 0 */
+#define MPT_SCANDV_DID_RESET           (0x00000001)
+#define MPT_SCANDV_SENSE               (0x00000002)
+#define MPT_SCANDV_SOME_ERROR          (0x00000004)
+#define MPT_SCANDV_SELECTION_TIMEOUT   (0x00000008)
+#define MPT_SCANDV_ISSUE_SENSE         (0x00000010)
+#define MPT_SCANDV_FALLBACK            (0x00000020)
+#define MPT_SCANDV_BUSY                        (0x00000040)
 
-#define MPT_SCSI_CMD_PER_LUN           7
+#define MPT_SCANDV_MAX_RETRIES         (10)
 
-#define MPT_SCSI_MAX_SECTORS    8192
+#define MPT_ICFLAG_BUF_CAP     0x01    /* ReadBuffer Read Capacity format */
+#define MPT_ICFLAG_ECHO                0x02    /* ReadBuffer Echo buffer format */
+#define MPT_ICFLAG_EBOS                0x04    /* ReadBuffer Echo buffer has EBOS */
+#define MPT_ICFLAG_PHYS_DISK   0x08    /* Any SCSI IO but do Phys Disk Format */
+#define MPT_ICFLAG_TAGGED_CMD  0x10    /* Do tagged IO */
+#define MPT_ICFLAG_DID_RESET   0x20    /* Bus Reset occurred with this command */
+#define MPT_ICFLAG_RESERVED    0x40    /* Reserved has been issued */
 
-/* To disable domain validation, uncomment the
- * following line. No effect for FC devices.
- * For SCSI devices, driver will negotiate to
- * NVRAM settings (if available) or to maximum adapter
- * capabilities.
- */
+#define MPT_SCSI_CMD_PER_DEV_HIGH      64
+#define MPT_SCSI_CMD_PER_DEV_LOW       32
 
-#define MPTSCSIH_ENABLE_DOMAIN_VALIDATION
+#define MPT_SCSI_CMD_PER_LUN           7
 
+#define MPT_SCSI_MAX_SECTORS    8192
 
 /* SCSI driver setup structure. Settings can be overridden
  * by command line options.
@@ -77,10 +86,25 @@
 #define MPTSCSIH_MAX_WIDTH              1
 #define MPTSCSIH_MIN_SYNC               0x08
 #define MPTSCSIH_SAF_TE                 0
-
+#define MPTSCSIH_PT_CLEAR               0
 
 #endif
 
+
+typedef struct _internal_cmd {
+       char            *data;          /* data pointer */
+       dma_addr_t      data_dma;       /* data dma address */
+       int             size;           /* transfer size */
+       u8              cmd;            /* SCSI Op Code */
+       u8              channel;        /* bus number */
+       u8              id;             /* SCSI ID (virtual) */
+       int             lun;
+       u8              flags;          /* Bit Field - See above */
+       u8              physDiskNum;    /* Phys disk number, -1 else */
+       u8              rsvd2;
+       u8              rsvd;
+} INTERNAL_CMD;
+
 extern void mptscsih_remove(struct pci_dev *);
 extern void mptscsih_shutdown(struct pci_dev *);
 #ifdef CONFIG_PM
@@ -90,7 +114,8 @@ extern int mptscsih_resume(struct pci_dev *pdev);
 extern int mptscsih_proc_info(struct Scsi_Host *host, char *buffer, char **start, off_t offset, int length, int func);
 extern const char * mptscsih_info(struct Scsi_Host *SChost);
 extern int mptscsih_qcmd(struct scsi_cmnd *SCpnt, void (*done)(struct scsi_cmnd *));
-extern int mptscsih_slave_alloc(struct scsi_device *device);
+extern int mptscsih_IssueTaskMgmt(MPT_SCSI_HOST *hd, u8 type, u8 channel,
+       u8 id, int lun, int ctx2abort, ulong timeout);
 extern void mptscsih_slave_destroy(struct scsi_device *device);
 extern int mptscsih_slave_configure(struct scsi_device *device);
 extern int mptscsih_abort(struct scsi_cmnd * SCpnt);
@@ -103,5 +128,9 @@ extern int mptscsih_taskmgmt_complete(MPT_ADAPTER *ioc, MPT_FRAME_HDR *mf, MPT_F
 extern int mptscsih_scandv_complete(MPT_ADAPTER *ioc, MPT_FRAME_HDR *mf, MPT_FRAME_HDR *r);
 extern int mptscsih_event_process(MPT_ADAPTER *ioc, EventNotificationReply_t *pEvReply);
 extern int mptscsih_ioc_reset(MPT_ADAPTER *ioc, int post_reset);
-extern ssize_t mptscsih_store_queue_depth(struct device *dev, struct device_attribute *attr, const char *buf, size_t count);
-extern void mptscsih_timer_expired(unsigned long data);
+extern int mptscsih_change_queue_depth(struct scsi_device *sdev, int qdepth);
+extern u8 mptscsih_raid_id_to_num(MPT_ADAPTER *ioc, u8 channel, u8 id);
+extern int mptscsih_is_phys_disk(MPT_ADAPTER *ioc, u8 channel, u8 id);
+extern struct device_attribute *mptscsih_host_attrs[];
+extern struct scsi_cmnd        *mptscsih_get_scsi_lookup(MPT_ADAPTER *ioc, int i);
+extern void mptscsih_taskmgmt_response_code(MPT_ADAPTER *ioc, u8 response_code);