V4L/DVB (11918): tuner-xc2028: Fix offset frequencies for DVB @ 6MHz

[safe/jmp/linux-2.6] / drivers / media / common / tuners / tuner-xc2028.c

diff --git a/drivers/media/common/tuners/tuner-xc2028.c b/drivers/media/common/tuners/tuner-xc2028.c
index 14649e4..27e7cb6 100644 (file)
--- a/drivers/media/common/tuners/tuner-xc2028.c
+++ b/drivers/media/common/tuners/tuner-xc2028.c
@@ -917,22 +917,29 @@ static int generic_set_freq(struct dvb_frontend *fe, u32 freq /* in HZ */,
         * that xc2028 will be in a safe state.
         * Maybe this might also be needed for DTV.
         */
-       if (new_mode == T_ANALOG_TV) {
+       if (new_mode == T_ANALOG_TV)
                rc = send_seq(priv, {0x00, 0x00});
-       } else if (priv->cur_fw.type & ATSC) {
-               offset = 1750000;
-       } else {
-               offset = 2750000;
+
+       /*
+        * Digital modes require an offset to adjust to the
+        * proper frequency.
+        * Analog modes require offset = 0
+        */
+       if (new_mode != T_ANALOG_TV) {
+               /* Sets the offset according with firmware */
+               if (priv->cur_fw.type & DTV6)
+                       offset = 1750000;
+               else if (priv->cur_fw.type & DTV7)
+                       offset = 2250000;
+               else    /* DTV8 or DTV78 */
+                       offset = 2750000;
+
                /*
-                * We must adjust the offset by 500kHz in two cases in order
-                * to correctly center the IF output:
-                * 1) When the ZARLINK456 or DIBCOM52 tables were explicitly
-                *    selected and a 7MHz channel is tuned;
-                * 2) When tuning a VHF channel with DTV78 firmware.
+                * We must adjust the offset by 500kHz  when
+                * tuning a 7MHz VHF channel with DTV78 firmware
+                * (used in Australia, Italy and Germany)
                 */
-               if (((priv->cur_fw.type & DTV7) &&
-                    (priv->cur_fw.scode_table & (ZARLINK456 | DIBCOM52))) ||
-                   ((priv->cur_fw.type & DTV78) && freq < 470000000))
+               if ((priv->cur_fw.type & DTV78) && freq < 470000000)
                        offset -= 500000;
        }