depends on LEDS_CLASS && X86 && EXPERIMENTAL
help
This option enables support for the PCEngines ALIX.2 and ALIX.3 LEDs.
+ You have to set leds-alix2.force=1 for boards with Award BIOS.
config LEDS_H1940
tristate "LED Support for iPAQ H1940 device"
of_platform devices. For instance, LEDs which are listed in a "dts"
file.
+config LEDS_LP3944
+ tristate "LED Support for N.S. LP3944 (Fun Light) I2C chip"
+ depends on LEDS_CLASS && I2C
+ help
+ This option enables support for LEDs connected to the National
+ Semiconductor LP3944 Lighting Management Unit (LMU) also known as
+ Fun Light Chip.
+
+ To compile this driver as a module, choose M here: the
+ module will be called leds-lp3944.
+
config LEDS_CLEVO_MAIL
tristate "Mail LED on Clevo notebook"
depends on LEDS_CLASS && X86 && SERIO_I8042 && DMI
LED driver chips accessed via the I2C bus. Supported
devices include PCA9550, PCA9551, PCA9552, and PCA9553.
+config LEDS_WM831X_STATUS
+ tristate "LED support for status LEDs on WM831x PMICs"
+ depends on LEDS_CLASS && MFD_WM831X
+ help
+ This option enables support for the status LEDs of the WM831x
+ series of PMICs.
+
config LEDS_WM8350
tristate "LED Support for WM8350 AudioPlus PMIC"
depends on LEDS_CLASS && MFD_WM8350
help
This option enables support for pwm driven LEDs
+config LEDS_REGULATOR
+ tristate "REGULATOR driven LED support"
+ depends on LEDS_CLASS && REGULATOR
+ help
+ This option enables support for regulator driven LEDs.
+
+config LEDS_BD2802
+ tristate "LED driver for BD2802 RGB LED"
+ depends on LEDS_CLASS && I2C
+ help
+ This option enables support for BD2802GU RGB LED driver chips
+ accessed via the I2C bus.
+
+config LEDS_INTEL_SS4200
+ tristate "LED driver for Intel NAS SS4200 series"
+ depends on LEDS_CLASS && PCI && DMI
+ help
+ This option enables support for the Intel SS4200 series of
+ Network Attached Storage servers. You may control the hard
+ drive or power LEDs on the front panel. Using this driver
+ can stop the front LED from blinking after startup.
+
+config LEDS_LT3593
+ tristate "LED driver for LT3593 controllers"
+ depends on LEDS_CLASS && GENERIC_GPIO
+ help
+ This option enables support for LEDs driven by a Linear Technology
+ LT3593 controller. This controller uses a special one-wire pulse
+ coding protocol to set the brightness.
+
+config LEDS_ADP5520
+ tristate "LED Support for ADP5520/ADP5501 PMIC"
+ depends on LEDS_CLASS && PMIC_ADP5520
+ help
+ This option enables support for on-chip LED drivers found
+ on Analog Devices ADP5520/ADP5501 PMICs.
+
+ To compile this driver as a module, choose M here: the module will
+ be called leds-adp5520.
+
comment "LED Triggers"
config LEDS_TRIGGERS