}
/**
- * it821x_configure_drive_for_dma - set up for DMA transfers
- * @drive: drive we are going to set up
- *
- * Set up the drive for DMA, tune the controller and drive as
- * required. If the drive isn't suitable for DMA or we hit
- * other problems then we will drop down to PIO and set up
- * PIO appropriately
- */
-
-static int it821x_config_drive_for_dma (ide_drive_t *drive)
-{
- if (ide_tune_dma(drive))
- return 0;
-
- ide_set_max_pio(drive);
-
- return -1;
-}
-
-/**
* ata66_it821x - check for 80 pin cable
* @hwif: interface to check
*
hwif->ultra_mask = 0x7f;
hwif->mwdma_mask = 0x07;
- hwif->ide_dma_check = &it821x_config_drive_for_dma;
-
if (hwif->cbl != ATA_CBL_PATA40_SHORT)
hwif->cbl = ata66_it821x(hwif);