if (irqd)
disable_irq(hwif->irq);
- rc = ide_port_wait_ready(hwif);
- if (rc == -ENODEV) {
- printk(KERN_INFO "%s: no devices on the port\n", hwif->name);
- goto out;
- } else if (rc == -EBUSY)
- printk(KERN_ERR "%s: not ready before the probe\n", hwif->name);
- else
- rc = -ENODEV;
+ if (ide_port_wait_ready(hwif) == -EBUSY)
+ printk(KERN_DEBUG "%s: Wait for ready failed before probe !\n", hwif->name);
/*
* Second drive should only exist if first drive was found,
if (drive->dev_flags & IDE_DFLAG_PRESENT)
rc = 0;
}
-out:
+
/*
* Use cached IRQ number. It might be (and is...) changed by probe
* code above
if (hwif->rqsize < max_sectors)
max_sectors = hwif->rqsize;
- blk_queue_max_sectors(q, max_sectors);
+ blk_queue_max_hw_sectors(q, max_sectors);
#ifdef CONFIG_PCI
/* When we have an IOMMU, we may have a problem where pci_map_sg()
max_sg_entries >>= 1;
#endif /* CONFIG_PCI */
- blk_queue_max_hw_segments(q, max_sg_entries);
- blk_queue_max_phys_segments(q, max_sg_entries);
+ blk_queue_max_segments(q, max_sg_entries);
/* assign drive queue */
drive->queue = q;
if (hwif->host_flags & IDE_HFLAG_NO_UNMASK_IRQS)
drive->dev_flags |= IDE_DFLAG_NO_UNMASK;
+ drive->pio_mode = XFER_PIO_0;
+
if (port_ops && port_ops->init_dev)
port_ops->init_dev(drive);
}
-
- ide_port_for_each_dev(i, drive, hwif) {
- /*
- * default to PIO Mode 0 before we figure out
- * the most suited mode for the attached device
- */
- if (port_ops && port_ops->set_pio_mode)
- port_ops->set_pio_mode(drive, 0);
- }
}
static void ide_init_port(ide_hwif_t *hwif, unsigned int port,