static DEFINE_MUTEX(idecd_ref_mutex);
-static void ide_cd_release(struct kref *);
+static void ide_cd_release(struct device *);
static struct cdrom_info *ide_cd_get(struct gendisk *disk)
{
if (ide_device_get(cd->drive))
cd = NULL;
else
- kref_get(&cd->kref);
+ get_device(&cd->dev);
}
mutex_unlock(&idecd_ref_mutex);
ide_drive_t *drive = cd->drive;
mutex_lock(&idecd_ref_mutex);
- kref_put(&cd->kref, ide_cd_release);
+ put_device(&cd->dev);
ide_device_put(drive);
mutex_unlock(&idecd_ref_mutex);
}
bio_sectors = max(bio_sectors(failed_command->bio), 4U);
sector &= ~(bio_sectors - 1);
+ /*
+ * The SCSI specification allows for the value
+ * returned by READ CAPACITY to be up to 75 2K
+ * sectors past the last readable block.
+ * Therefore, if we hit a medium error within the
+ * last 75 2K sectors, we decrease the saved size
+ * value.
+ */
if (sector < get_capacity(info->disk) &&
drive->probed_capacity - sector < 4 * 75)
set_capacity(info->disk, sector);
static void cdrom_end_request(ide_drive_t *drive, int uptodate)
{
- struct request *rq = HWGROUP(drive)->rq;
+ struct request *rq = drive->hwif->rq;
int nsectors = rq->hard_cur_sectors;
ide_debug_log(IDE_DBG_FUNC, "Call %s, cmd: 0x%x, uptodate: 0x%x, "
static int cdrom_decode_status(ide_drive_t *drive, int good_stat, int *stat_ret)
{
ide_hwif_t *hwif = drive->hwif;
- ide_hwgroup_t *hwgroup = hwif->hwgroup;
- struct request *rq = hwgroup->rq;
+ struct request *rq = hwif->rq;
int stat, err, sense_key;
/* check for errors */
blkdev_dequeue_request(rq);
spin_unlock_irqrestore(q->queue_lock, flags);
- hwgroup->rq = NULL;
+ hwif->rq = NULL;
cdrom_queue_request_sense(drive, rq->sense, rq);
} else
}
/*
- * Set up the device registers for transferring a packet command on DEV,
- * expecting to later transfer XFERLEN bytes. HANDLER is the routine
- * which actually transfers the command to the drive. If this is a
- * drq_interrupt device, this routine will arrange for HANDLER to be
- * called when the interrupt from the drive arrives. Otherwise, HANDLER
- * will be called immediately after the drive is prepared for the transfer.
- */
-static ide_startstop_t cdrom_start_packet_command(ide_drive_t *drive,
- ide_handler_t *handler)
-{
- ide_hwif_t *hwif = drive->hwif;
- struct request *rq = hwif->hwgroup->rq;
- int xferlen;
-
- xferlen = ide_cd_get_xferlen(rq);
-
- ide_debug_log(IDE_DBG_PC, "Call %s, xferlen: %d\n", __func__, xferlen);
-
- /* FIXME: for Virtual DMA we must check harder */
- if (drive->dma)
- drive->dma = !hwif->dma_ops->dma_setup(drive);
-
- /* set up the controller registers */
- ide_pktcmd_tf_load(drive, IDE_TFLAG_OUT_NSECT | IDE_TFLAG_OUT_LBAL,
- xferlen, drive->dma);
-
- if (drive->atapi_flags & IDE_AFLAG_DRQ_INTERRUPT) {
- /* waiting for CDB interrupt, not DMA yet. */
- if (drive->dma)
- drive->waiting_for_dma = 0;
-
- /* packet command */
- ide_execute_command(drive, ATA_CMD_PACKET, handler,
- ATAPI_WAIT_PC, ide_cd_expiry);
- return ide_started;
- } else {
- ide_execute_pkt_cmd(drive);
-
- return (*handler) (drive);
- }
-}
-
-/*
- * Send a packet command to DRIVE described by CMD_BUF and CMD_LEN. The device
- * registers must have already been prepared by cdrom_start_packet_command.
- * HANDLER is the interrupt handler to call when the command completes or
- * there's data ready.
- */
-#define ATAPI_MIN_CDB_BYTES 12
-static ide_startstop_t cdrom_transfer_packet_command(ide_drive_t *drive,
- struct request *rq,
- ide_handler_t *handler)
-{
- ide_hwif_t *hwif = drive->hwif;
- int cmd_len;
- ide_startstop_t startstop;
-
- ide_debug_log(IDE_DBG_PC, "Call %s\n", __func__);
-
- if (drive->atapi_flags & IDE_AFLAG_DRQ_INTERRUPT) {
- /*
- * Here we should have been called after receiving an interrupt
- * from the device. DRQ should how be set.
- */
-
- /* check for errors */
- if (cdrom_decode_status(drive, ATA_DRQ, NULL))
- return ide_stopped;
-
- /* ok, next interrupt will be DMA interrupt */
- if (drive->dma)
- drive->waiting_for_dma = 1;
- } else {
- /* otherwise, we must wait for DRQ to get set */
- if (ide_wait_stat(&startstop, drive, ATA_DRQ,
- ATA_BUSY, WAIT_READY))
- return startstop;
- }
-
- /* arm the interrupt handler */
- ide_set_handler(drive, handler, rq->timeout, ide_cd_expiry);
-
- /* ATAPI commands get padded out to 12 bytes minimum */
- cmd_len = COMMAND_SIZE(rq->cmd[0]);
- if (cmd_len < ATAPI_MIN_CDB_BYTES)
- cmd_len = ATAPI_MIN_CDB_BYTES;
-
- /* send the command to the device */
- hwif->tp_ops->output_data(drive, NULL, rq->cmd, cmd_len);
-
- /* start the DMA if need be */
- if (drive->dma)
- hwif->dma_ops->dma_start(drive);
-
- return ide_started;
-}
-
-/*
* Check the contents of the interrupt reason register from the cdrom
* and attempt to recover if there are problems. Returns 0 if everything's
* ok; nonzero if the request has been terminated.
return 1;
}
-static ide_startstop_t cdrom_newpc_intr(ide_drive_t *);
-
static ide_startstop_t ide_cd_prepare_rw_request(ide_drive_t *drive,
struct request *rq)
{
}
/*
- * Routine to send a read/write packet command to the drive. This is usually
- * called directly from cdrom_start_{read,write}(). However, for drq_interrupt
- * devices, it is called from an interrupt when the drive is ready to accept
- * the command.
- */
-static ide_startstop_t cdrom_start_rw_cont(ide_drive_t *drive)
-{
- struct request *rq = drive->hwif->hwgroup->rq;
-
- /* send the command to the drive and return */
- return cdrom_transfer_packet_command(drive, rq, cdrom_newpc_intr);
-}
-
-/*
* Fix up a possibly partially-processed request so that we can start it over
* entirely, or even put it back on the request queue.
*/
static ide_startstop_t cdrom_newpc_intr(ide_drive_t *drive)
{
ide_hwif_t *hwif = drive->hwif;
- ide_hwgroup_t *hwgroup = hwif->hwgroup;
- struct request *rq = hwgroup->rq;
+ struct request *rq = hwif->rq;
xfer_func_t *xferfunc;
ide_expiry_t *expiry = NULL;
int dma_error = 0, dma, stat, thislen, uptodate = 0;
if (blk_fs_request(rq)) {
ide_end_request(drive, 1, rq->nr_sectors);
return ide_stopped;
+ } else if (rq->cmd_type == REQ_TYPE_ATA_PC && !rq->bio) {
+ ide_end_request(drive, 1, 1);
+ return ide_stopped;
}
goto end_request;
}
if (blk_end_request(rq, 0, dlen))
BUG();
- hwgroup->rq = NULL;
+ hwif->rq = NULL;
} else {
if (!uptodate)
rq->cmd_flags |= REQ_FAILED;
return ide_started;
}
-static ide_startstop_t cdrom_do_newpc_cont(ide_drive_t *drive)
-{
- struct request *rq = HWGROUP(drive)->rq;
-
- return cdrom_transfer_packet_command(drive, rq, cdrom_newpc_intr);
-}
-
static void cdrom_do_block_pc(ide_drive_t *drive, struct request *rq)
{
static ide_startstop_t ide_cd_do_request(ide_drive_t *drive, struct request *rq,
sector_t block)
{
- ide_handler_t *fn;
-
ide_debug_log(IDE_DBG_RQ, "Call %s, rq->cmd[0]: 0x%x, "
"rq->cmd_type: 0x%x, block: %llu\n",
__func__, rq->cmd[0], rq->cmd_type,
(unsigned long long)block);
if (blk_fs_request(rq)) {
- fn = cdrom_start_rw_cont;
-
if (cdrom_start_rw(drive, rq) == ide_stopped)
return ide_stopped;
return ide_stopped;
} else if (blk_sense_request(rq) || blk_pc_request(rq) ||
rq->cmd_type == REQ_TYPE_ATA_PC) {
- fn = cdrom_do_newpc_cont;
-
if (!rq->timeout)
rq->timeout = ATAPI_WAIT_PC;
return ide_stopped;
}
- return cdrom_start_packet_command(drive, fn);
+ return ide_issue_pc(drive);
}
/*
ide_debug_log(IDE_DBG_FUNC, "Call %s\n", __func__);
ide_proc_unregister_driver(drive, info->driver);
-
+ device_del(&info->dev);
del_gendisk(info->disk);
- ide_cd_put(info);
+ mutex_lock(&idecd_ref_mutex);
+ put_device(&info->dev);
+ mutex_unlock(&idecd_ref_mutex);
}
-static void ide_cd_release(struct kref *kref)
+static void ide_cd_release(struct device *dev)
{
- struct cdrom_info *info = to_ide_drv(kref, cdrom_info);
+ struct cdrom_info *info = to_ide_drv(dev, cdrom_info);
struct cdrom_device_info *devinfo = &info->devinfo;
ide_drive_t *drive = info->drive;
struct gendisk *g = info->disk;
static int ide_cd_probe(ide_drive_t *);
-static ide_driver_t ide_cdrom_driver = {
+static struct ide_driver ide_cdrom_driver = {
.gen_driver = {
.owner = THIS_MODULE,
.name = "ide-cdrom",
.version = IDECD_VERSION,
.do_request = ide_cd_do_request,
.end_request = ide_end_request,
- .error = __ide_error,
#ifdef CONFIG_IDE_PROC_FS
.proc_entries = ide_cd_proc_entries,
.proc_devsets = ide_cd_proc_devsets,
}
drive->debug_mask = debug_mask;
+ drive->irq_handler = cdrom_newpc_intr;
info = kzalloc(sizeof(struct cdrom_info), GFP_KERNEL);
if (info == NULL) {
ide_init_disk(g, drive);
- kref_init(&info->kref);
+ info->dev.parent = &drive->gendev;
+ info->dev.release = ide_cd_release;
+ dev_set_name(&info->dev, dev_name(&drive->gendev));
+
+ if (device_register(&info->dev))
+ goto out_free_disk;
info->drive = drive;
info->driver = &ide_cdrom_driver;
g->driverfs_dev = &drive->gendev;
g->flags = GENHD_FL_CD | GENHD_FL_REMOVABLE;
if (ide_cdrom_setup(drive)) {
- ide_cd_release(&info->kref);
+ put_device(&info->dev);
goto failed;
}
add_disk(g);
return 0;
+out_free_disk:
+ put_disk(g);
out_free_cd:
kfree(info);
failed:
git://ftp.safe.ca / safe / jmp / linux-2.6 / blobdiff